FORD WSS-M1H931-A-2004 FABRIC SPAN PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《Span图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD WSS-M1H931-A-2004 FABRIC SPAN PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《Span图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M1H931-A-2004 FABRIC SPAN PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《Span图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2004 05 26 Activated N. J. Komatsu Printed copies are uncontrolled Copyright 2004, Ford Global Technologies, LLC Page 1 of 2 FABRIC, SPAN PATTERN, WOVEN JACQUARD, WSS-M1H931-A UNLAMINATED 1. SCOPE The material defined by this specification is

2、a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for use in the 2003 model year. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A

3、4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 250 ends/10 cm Weft

4、 170 picks/10 cm 3.2.2 Fabric Weight, +/- 15% tolerance (FLTM BN 106-01) 300 g/m23.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 620 dtex f144 (air Texturized, dull, round) Weft 600 dtex f144 (air texturized, semi-dull round) Weft 680 dtex f1 (monofil, 0.2

5、5mm, bright, round) ENGINEERING MATERIAL SPECIFICATIONWSS-M1H931-A Printed copies are uncontrolled Copyright 2004, Ford Global Technologies, LLC Page 2 of 2 3.5 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.6 FINISHED OPERATIONS As approved by Materials Engineering 4. GENERAL

6、INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.