DLA MS25098 REV K-2004 SWITCH TOGGLE ONE POLE SEALED TOGGLE《密封一刀触发器开关》.pdf

《DLA MS25098 REV K-2004 SWITCH TOGGLE ONE POLE SEALED TOGGLE《密封一刀触发器开关》.pdf》由会员分享，可在线阅读，更多相关《DLA MS25098 REV K-2004 SWITCH TOGGLE ONE POLE SEALED TOGGLE《密封一刀触发器开关》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A FSC 5930 MS25098K 17 March 2004 SUPERSEDING MS25098J 26 June 1995 MILITARY SPECIFICATION SHEET SWITCH, TOGGLE, ONE POLE, SEALED TOGGLE This specification is approved for use by all Depart- ments and Agencies of the Department of Defense. The requirements for acquiring the switch described h

2、erein shall consist of this specification sheet and MIL-DTL-83731. Inches mm Inches mm Inches mm Inches mm Inches mm .004 0.10 .012 0.30 .020 0.51 .03 0.8 .072 1.83 .094 2.39 .240 6.10 .432 10.97 .468 11.89 .47 11.9 .69 17.5 .719 18.26 .969 24.61 1.281 32.54 NOTES: 1. Dimensions are in inches. 2. Me

3、tric equivalents are given for information only. 3. Unless otherwise specified, tolerances are .020 (0.51 mm) on two place decimals and .005 (0.13 mm) on three place decimals. 4. For hardware detail specifications, see appendix of MIL-DTL-83731. 5. Dome on top of the mounting bushing is permissible,

4、 not to exceed .09 (2.3 mm). FIGURE 1. Dimensions and configuration. INCH-POUND MS25098K, dated 17 March 2004, is hereby reactivated and may be used for either new or existing design acquisition. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS2509

5、8K 2 Design and construction: See figure 1. Switching characteristics: See table I. Direction of the movement of the switch mechanism is the same as that of the toggle lever. Weight: .8 ounce maximum. Dielectric withstanding voltage: Sea level only. Toggle seal test: Applicable. Electrical endurance

6、: Maintained circuits: 20,000 cycles Momentary circuits: 10,000 cycles. Resistive loads: 125 V dc; 3 amperes. 115 V ac, 60 Hz: 3 amperes. Inductive loads: 125 V dc: 1.5 amperes. 115 V ac, 60 Hz: 1.5 amperes. Group B inspection: Not applicable. Part or Identifying Number (PIN): Example: MS25098-22 Da

7、sh number (see table I) PIN MS25098-22 identifies a switch with a circuit configuration of OFF in the down position (keying side), NONE in center position, and ON in the up position. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25098K 3 TABLE I.

8、 Switching characteristics. Circuit with toggle lever in MS part number MS25098- Down position keying side Center position Up position Former MS part number Former JAN type designation 22 Off None On MS25098-1 ST12A 23 On None On MS25098-4 ST12D 26 Mom On None On None ST12F 29 Mom Off None On MS2509

9、8-2 ST12B 30 Mom On None Off MS25098-3 ST12C Referenced Documents: MIL-DTL-83731 Custodians: Preparing activity: Air Force - 11 DLA - CC Navy - AS Army - CR (Project 5930-1797) DLA CC Review activities: Navy - EC Air Force - 99 Army - AV NOTE: The activities listed above were interested in this docu

10、ment as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at www.dodssp.daps.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-