DIN EN ISO 16663-2 Berichtigung 1-2006 Fishing nets - Method of test for the determination of mesh size - Part 2 Length of mesh (ISO 16663-2 2003) German version EN ISO 16663-2 200.pdf

《DIN EN ISO 16663-2 Berichtigung 1-2006 Fishing nets - Method of test for the determination of mesh size - Part 2 Length of mesh (ISO 16663-2 2003) German version EN ISO 16663-2 200.pdf》由会员分享，可在线阅读，更多相关《DIN EN ISO 16663-2 Berichtigung 1-2006 Fishing nets - Method of test for the determination of mesh size - Part 2 Length of mesh (ISO 16663-2 2003) German version EN ISO 16663-2 200.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 September 2006DIN EN ISO 16663-2 Corrigendum 1 ICS 65.150 Fishing nets Method of test for the determination of mesh size Part 2: Length of mesh (ISO 16663-2:2003) Corrigendum 1 to English version of DIN EN ISO 16663-2:2003-09 Fischnetze Prfverfahren zur Bestimmung der Maschenweite Teil 2: Maschenln

2、ge (ISO 16663-2:2003) Berichtigung 1 zur englischen Fassung DIN EN ISO 16663-2:2003-09 Document comprises 2 pages No part of this standard may be reproduced without prior permission of DIN Deutsches Institut fr Normung e. V., Berlin. Beuth Verlag GmbH, 10772 Berlin, Germany, has the exclusive right

3、of sale for German Standards (DIN-Normen). English price group 99 www.din.de www.beuth.de !,p6“03.07 9779919This corrigendum should be filed together with the translation of the standard to which it refers and a corresponding note made on the translation. DIN EN ISO 16663-2 Corr. 1:2006-09 2 This Co

4、rrigendum is based on EN ISO 16663-2:2003/AC:2006. Endorsement Notice The text of ISO 16663-2:2003/Cor. 1:2005 has been approved by CEN as EN ISO 14419:1998/AC:2006 without any modifications. In DIN EN ISO 16663-2:2003-09 the following corrections are to be made: Re Subclause 6.1 Replace the existin

5、g text by the following: “Straighten the netting manually in the N-direction. Using a ruler, measure the distance from the first knot or joint exclusive to the eleventh sequential knot or joint inclusive with an accuracy of 1 mm (as shown in Figure 1). The mesh length is obtained by dividing the measured length by 5.” Re Subclause 7.1 Replace the existing text by the following: “Record the mesh length, in millimetres, for each measurement.”