FORD WSS-M1H943-A-2008 FABRIC MERIDIEN PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《MERIDIEN图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD WSS-M1H943-A-2008 FABRIC MERIDIEN PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《MERIDIEN图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M1H943-A-2008 FABRIC MERIDIEN PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《MERIDIEN图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 12 09 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2003 10 27 Activated N. J. Komatsu Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, Inc. Page 1 of 2 FABRIC, MERIDIEN PATTERN, WOVEN JACQUARD, WSS

2、-M1H943-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for the 2002 Model Year. 3. REQUIREMENTS In additi

3、on to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A).

4、3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 5% tolerance (ASTM D 3775) Warp 280 ends/10 cm Weft 160 picks/10 cm 3.2.2 Fabric Weight, range. (FLTM BN 106-01) 230 - 260g/m23.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 540 dtex f136 (Polyester, air text

5、urised, round, semi-dull) Weft 520 dtex f96 (Polyester, FT-stretch, bright) ENGINEERING MATERIAL SPECIFICATIONWSS-M1H943-A Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, Inc. Page 2 of 2 3.5 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.6 FINISHING O

6、PERATIONS As approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.