FORD SD3-8-1988 CHEMICAL HANDLING COVERALL GOGGLES《化学品操作用全包式护目镜》.pdf

《FORD SD3-8-1988 CHEMICAL HANDLING COVERALL GOGGLES《化学品操作用全包式护目镜》.pdf》由会员分享，可在线阅读，更多相关《FORD SD3-8-1988 CHEMICAL HANDLING COVERALL GOGGLES《化学品操作用全包式护目镜》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 Manufacturing StandardsFord Motor Company198807 CHEMICAL HANDLING COVERALL SD3-8GOGGLESEngineering Standards & Printed copies are uncontrolled.Systems Engineering (ESSE) Page 1 of 21. SCOPE: This standard describes the requirements and recommended usagefor clear flexible fitting hooded ventilation

2、coverall goggles.2. GENERAL REQUIREMENTS: Clear hooded ventilation coverall goggles must fitover either plano or prescription safety glasses as approved inManufacturing Standard SD3-1, and Industrial Relations AdministrationManual, Volume III, Section C, Topic 700, and provide eye protection fromcor

3、rosive liquid splash, mists, sprays, and fogs.Design of the goggles shall permit lens replacement without the use ofspecialized tools.3. RECOMMENDED USAGE: Hooded ventilation coverall goggles are intended forprotection from corrosive liquid splash, mists, sprays, and fogs.Handling of chemicals in a

4、laboratory and transferring of corrosivechemicals in production operations would be typical operations for whichthese goggles are intended to provide protection. Jobs or locationsrequiring hooded ventilation coverall goggles shall be designated by thesafety representative.Approved industrial safety

5、glasses shall be worn in conjunction withhooded ventilation coverall goggles.4. SPECIFICATIONS: Unless otherwise specified, hooded ventilation coverallgoggles shall be of the “antifogging“ type and conform to the appropriaterequirements of American National Standards Institute standard ANSIZ87.1-197

6、9, Occupational and Educational Eye and Face Protection, andlater revisions as they appear.The headband shall be flexible, adjustable and a minimum of 1/2 inch(12.7mm) wide.5. ORDERING INFORMATION: Each order must state the manufacturing standardsnumber and the name of the goggle.Replacement lenses

7、must be ordered specifically for this type goggle byname.6. SUPPLIERS RESPONSIBILITY: All goggles and lens supplied to thisstandard must be equivalent in all characteristics to the goggle and lensupon which approval was originally granted.The supplier is to certify in writing that all components sup

8、plied underthis standard conform to ANSI standard Z87.1-1979, or later revisions asthey appear.Manufacturing StandardsFord Motor Company198807 CHEMICAL HANDLING COVERALL SD3-8GOGGLESEngineering Standards & Printed copies are uncontrolled.Systems Engineering (ESSE) Page 2 of 27. APPROVAL OF NEW SUPPL

9、IERS:7.1 Pricing of goggles from proposed new suppliers should be determinedto be cost competitive by Purchasing and Supply Staff prior toobtaining laboratory and shop trial approvals. After the producthas been determined to be cost competitive, gloves submitted by newmanufacturers to this standard

10、and concluded to be cost competitivemust have laboratory and shop trial approvals. Recommendations forthe addition of new manufacturers to the Manufacturing ApprovedSource List (ASL) must be made by the appropriate division standardsactivity in writing to the Plant Engineering Office, ManufacturingStaff. All supporting data must accompany the written request.7.2 The Plant Engineering Office, Manufacturing Staff, and theEnvironmental Health and Safety Manager, Employee Relations Staff,will review requests to determine approval.