FORD SD3-7-1988 CLEAR PLASTIC COVERALL GOGGLES《透明塑料工作护目镜》.pdf

《FORD SD3-7-1988 CLEAR PLASTIC COVERALL GOGGLES《透明塑料工作护目镜》.pdf》由会员分享，可在线阅读，更多相关《FORD SD3-7-1988 CLEAR PLASTIC COVERALL GOGGLES《透明塑料工作护目镜》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 Manufacturing StandardsFord Motor Company198807 CLEAR PLASTIC COVERALL SD3-7GOGGLESEngineering Standards & Printed copies are uncontrolled.Systems Engineering (ESSE) Page 1 of 21. SCOPE: This standard describes the requirements and recommended usagefor clear flexible fitting regular ventilation cov

2、erall goggles.2. GENERAL REQUIREMENTS: Clear regular ventilation coverall goggles mustfit over either plano or prescription safety glasses as approved inManufacturing Standard SD3-1, and Industrial Relations AdministrationManual, Volume III, Section C, Topic 700, and provide protection fromimpact an

3、d dust.Design of the goggles shall permit lens replacement without the use ofspecialized tools.3. RECOMMENDED USAGE: Regular ventilation coverall goggles are intended forprotection from particles coming from any direction. Chipping and lightgrinding operations would be typical operations for which t

4、hese gogglesare intended to provide protection.Approved industrial safety glasses shall be worn in conjunction withregular ventilation coverall goggles.4. SPECIFICATIONS: Unless otherwise specified, regular ventilation coverallgoggles shall conform to the appropriate requirements of AmericanNational

5、 Standards Institute standard ANSI Z87.1-1979, Occupational andEducational Eye and Face Protection, and later revisions as they appear.The headband shall be flexible, adjustable and a minimum of 1/2 inch(12.7mm) wide.5. ORDERING INFORMATION: Each order must state the manufacturing standardsnumber an

6、d the name of the goggle.Replacement lenses must be ordered specifically for this type goggle byname.Regular ventilation coverall goggles with “antifogging“ characteristicsshould be specified where required by application.6. SUPPLIERS RESPONSIBILITY: All goggles and lens supplied to thisstandard mus

7、t be equivalent in all characteristics to the goggle andlens upon which approval was originally granted.The supplier is to certify in writing that all components supplied underthis standard conform to the current ANSI Standard for Occupational andEducational Eye and Face Protection, Z87.1-1979, or l

8、ater revisions asthey appear.Manufacturing StandardsFord Motor Company198807 CLEAR PLASTIC COVERALL SD3-7GOGGLESEngineering Standards & Printed copies are uncontrolled.Systems Engineering (ESSE) Page 2 of 27. APPROVAL OF NEW SUPPLIERS:7.1 Pricing of goggles from proposed new suppliers should be dete

9、rminedto be cost competitive by Purchasing and Supply Staff prior toobtaining laboratory and shop trial approvals. After the producthas been determined to be cost competitive, gloves submitted by newmanufacturers to this standard and concluded to be cost competitivemust have laboratory and shop tria

10、l approvals. Recommendations forthe addition of new manufacturers to the Manufacturing ApprovedSource List (ASL) must be made by the appropriate division standardsactivity in writing to the Plant Engineering Office, ManufacturingStaff. All supporting data must accompany the written request.7.2 The Plant Engineering Office, Manufacturing Staff, and theEnvironmental Health and Safety Manager, Employee Relations Staff,will review requests to determine approval.