FORD FLTM EU-BO 052-01-2001 COMPRESSION LOAD DEFLECTION TEST FOR POLYURETHANE FOAM《聚氨酯泡沫的压缩载荷挠曲试验》.pdf

《FORD FLTM EU-BO 052-01-2001 COMPRESSION LOAD DEFLECTION TEST FOR POLYURETHANE FOAM《聚氨酯泡沫的压缩载荷挠曲试验》.pdf》由会员分享，可在线阅读，更多相关《FORD FLTM EU-BO 052-01-2001 COMPRESSION LOAD DEFLECTION TEST FOR POLYURETHANE FOAM《聚氨酯泡沫的压缩载荷挠曲试验》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 FORD LABORATORY TEST METHOD EU-BO 052-01 Date Action Revisions 2001 03 27 Revised Editorial no technical change A. Cockman 1994 02 28 Printed copies are uncontrolled Page 1 of 3 Copyright 2001, Ford Global Technologies, Inc. COMPRESSION LOAD DEFLECTION TEST FOR POLYURETHANE FOAM Application This pr

2、ocedure is used to determine the compression load deflection of polyurethane foam. Apparatus Required Foam indentation hardness tester with a pressure foot approximately 150 mm diameter. A suitable alternative is a tensile testing machine with a special test fixture as shown in drawing. Either piece

3、 of apparatus must be capable of compressing the material at a constant rate of 50 mm/minute and be equipped with a recording devi ce. Height Gauge Conditioning and Test Conditions All test values indicated herein are based on material conditioned in a controlled atmosphere of 23 +/- 2 C and 50 +/-

4、5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Procedure 1. Cut a specimen of 80 +/- 1 mm x 80 +/- 1 mm with a thickness of 50 +/- 1 mm from the material under test. Note: For testing thin sheets of a foam material, a pi

5、le of minimum thickness of 50 mm is used. The number of layers used to achieve this thickness and overall thickness of the pile must be recorded. 2. Measure the thickness of the specimen using the height gauge to the nearest 0.5 mm without pressure on the specimen. 3. Place the test specimen on the

6、base plate of the machine, symmetrically to the centre of the pressure foot or symmetrically to the centre of the test fixture as shown in the drawing. FORD LABORATORY TEST METHOD EU-BO 052-01 Page 2 of 3 Copyright 2001, Ford Global Technologies, Inc. 4. Compress the specimen 70 % of its original he

7、ight at a rate of 50 mm/minute. Repeat this process 4 times in succession and record the compression stress-strain curve. Evaluation Calculate the load deflection value at 40 % compression from the fourth curve obtained. Note: Other compression, e.g., 20 % or 50 %, may be used if quoted on the relev

8、ant engineering specification. Chemicals, materials, parts, and equipment referenced in this document must be used and handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD EU-BO 052-01 Page 3 of 3 Copyright 2001, Ford Global Technologies, Inc. COMPRESSION LOAD DEFLECTION TEST FOR POLYURETHANE FOAM Fixture for Compression Load Deflection