DOD A-A-51022-1985 TRAY MEDICINE《药盘》.pdf

《DOD A-A-51022-1985 TRAY MEDICINE《药盘》.pdf》由会员分享，可在线阅读，更多相关《DOD A-A-51022-1985 TRAY MEDICINE《药盘》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 . COMMERCIAL ITEM DESCRIPTION TRAY, EDICiNE The General Services Administration has authorized the use of this commercial item description in preference to Interim Federal Specification RR-T-00640. This specification covers a stainless steel , rectangular medicine tray suitable for use in military

2、medical treatment facilities. Sal lent characteristics: Shall be a rectangular tray, without a cover, and suitable for carrying catheter trays, thermometer technique equipment and medicines to a patients bedside. The tray shall be formed seamlessly from one piece of .O31 inch thick corrosion-resisti

3、ng steel, American Iron and Steel Institute (AISI) 300 series, which shall not be reduced below 0.25 inch thick at any point. The tray shall have approximate dimensions of 13-1/2 inches long, 9-518 inches wide, and 518 inch deep. Upper lip shall be approximately 118 inch. Corner radius (at top of tr

4、ay) shall be approximately 1-114 inches maximum. The tray shall rest on all four bottom corners on a level surface without rocking or wobbling. The bottom may concave inward so that the highest point shall be approximately more than 1/16 inch above the surface upon which it rests. Tray surface shall

5、 have a unifrom 84 commercial finish or better and be readily cleanable. The tray shall be free of sharp edges, burrs, pits, dents, cracks, ripples, and deformi ties Workmanship. The medicine tray shall be free from defects which detract from its appearance or impair its serviceabi 1 i ty - Unit. Ea

6、ch (EA). Each tray, as specified, constitutes one unit. Contractor certification. The contractor shall certify that the product offered meets the sa I ient characteristics of this description and conforms to the producers om drawings, specifications, standards, and quality assurance practices. The G

7、overnment reserves the right to require proof of such conformance prior to first delivery and thereafter as may be otherwise provided for under the provisions of the contract. FSC 6530 DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited, Provided by IHSNot for ResaleNo r

8、eproduction or networking permitted without license from IHS-,-,-A -A- 5 1 02 2 Regulatory requirements. Federal Food, Drug and Cosmetic Act. If the product covered by this document has been determined by the U. s. hood and Drug Administration to be under its jurisdiction, the offeror/contractor sha

9、ll comply, and be responsible for compliance by its subcontractors/suppliers, with the requirements of the Federal Food, Drug and Cosmetic Act, as amended, and regulations promulgated thereunder. offeror/contractor shall comply, and be responsible for compliance by its subcontractors/suppl iers, wit

10、h the requirements of al 1 other applicable Federal , State, and local statutes, ordinances, and regulations. In addition, the Recovered materials, The offeror/contractor is encouraged to use recovered material in accordance with Public Law 94-580 to th.e maximum extent practical. Preservation, pack

11、aging, packing, labeling, and marking. Unless otherwise specified , preservation, packaging, and packing shall be to a degree of protection to preclude damage to containers and/or contents thereof under normal shipping conditions, handling, etc, involving shipment fran the supply source to the recei

12、ving activity, Plus reshipment from receiving activity, and shall conform to applicable carriers rules and regulations. marking shall be as specified in the contract and/or order. The following National Stock Number is covered by this document: Intermediate and exterior package quantities and labeli

13、ng ana 6530-00-794-0600 Ordering data (Intemediate/exterior package quantities and labeling and marking must be speclfied in the contract and/or order). MILITARY INTERESTS: PREPARING ACTIVITY: Custodians: DoD-MB Army -MD Navy-MS Air Force-O3 CIVIL AGENCY COORDINATING ACTIVITY: VA-OSS Agent: DU-DM PGC 50441 Project No. 6530-1782 Location H1-11-5 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-