DLA MIL-PRF-15160 1 G-2008 FUSES INSTRUMENT POWER AND TELEPHONE (NONINDICATING) STYLE F01.pdf

《DLA MIL-PRF-15160 1 G-2008 FUSES INSTRUMENT POWER AND TELEPHONE (NONINDICATING) STYLE F01.pdf》由会员分享，可在线阅读，更多相关《DLA MIL-PRF-15160 1 G-2008 FUSES INSTRUMENT POWER AND TELEPHONE (NONINDICATING) STYLE F01.pdf（6页珍藏版）》请在麦多课文档分享上搜索。

1、 INCH-POUND AMSC N/A FSC 5920 MIL-PRF-15160/1G 15 October 2008 SUPERSEDING MIL-PRF-15160/1F 31 March 2004 PERFORMANCE SPECIFICATION SHEET FUSES, INSTRUMENT, POWER, AND TELEPHONE (NONINDICATING), STYLE F01 This specification is approved for use by all Departments and Agencies of the Department of Def

2、ense. The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-PRF-15160. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. FIGURE 1. Style F01, fuse. Inches mm 0.004 0.10 0.010 0.25 0.031 0.79 0.230

3、 5.84 0.250 6.35 1.000 25.40 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-15160/1G 2 REQUIREMENTS: Interface and physical dimensions: See figure 1. Terminals: Ferrule type. Material: Brass, copper, phosphor bronze, or copper alloy. Finish:

4、 Nickel, or silver plated when specified. Strength: Method 211 of MIL-STD-202, test condition E, 10 inch-ounce torque between ferrules and fuse body. Body: Glass tube. Electrical: Current rating: See table I. Voltage rating: See table I. Characteristic: See table I. Resistance: See table I. Overload

5、 interrupt: Maximum 1 hour at 135 percent of rated current and a maximum of 5 seconds at 200 percent of rated current. Short circuit interrupt: See table I. Shock: 1/100 ampere through 5 ampere; Method 213 of MIL-STD-202, test condition I. Vibration: 1/100 ampere through 5 amperes; Method 204 of MIL

6、-STD-202, test condition A (except 5g peak). Type designation: Type designation shall be as specified in table I. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-15160/1G 3 TABLE I. Type designation. 1/ 1/ Inactive for new design after 30 Jan

7、uary 1970. 2/ Cold resistance at not greater than 10 percent load. 3/ For silver plated terminals, the designator “S“ is added after the current rating. Type designation AC short circuit interrupt. Style Characteristic Maximum voltage Current rating 3/ (amperes) Maximum resistance ohms 2/ 32 volts 1

8、25 volts 250 volts F01 A 250V 1/500A 6,500 10,000A 100A 35A F01 A 250V 1/200A 1,000 10,000A 100A 35A F01 A 250V 1/100A 600 10,000A 100A 35A F01 A 250V 1/32A 70 10,000A 100A 35A F01 A 250V 1/16A 40 10,000A 100A 35A F01 1/ A 250V 1/10A 9.8 10,000A 100A 35A F01 A 250V 1/8A 9.5 10,000A 100A 35A F01 1/ A

9、 250V 3/16A 8.7 10,000A 100A 35A F01 1/ A 250V 2/10A 8.5 10,000A 100A 35A F01 A 250V 1/4A 8.2 10,000A 100A 35A F01 A 250V 3/8A 6.2 10,000A 100A 35A F01 1/ A 250V 4/10A 4.5 10,000A 100A 35A F01 A 250V 1/2A 3.7 10,000A 100A 35A F01 1/ A 125V 6/10A 2.5 10,000A 100A Not rated F01 A 125V 3/4A 1.7 10,000A

10、 100A Not rated F01 1/ A 125V 8/10A 1.4 10,000A 100A Not rated F01 A 125V 1A 1.3 10,000A 100A Not rated F01 1/ A 125V 1 1/4A 1.00 10,000A 100A Not rated F01 A 125V 1 1/2A 0.21 10,000A 100A Not rated F01 1/ A 125V 1 6/10A 0.16 10,000A 100A Not rated F01 A 125V 2A 0.12 10,000A 100A Not rated F01 1/ A

11、125V 2 1/2A N/A 10,000A 10,000A Not rated F01 1/ A 125V 3A N/A 10,000A 10,000A Not rated F01 1/ A 125V 3 2/10A N/A 10,000A 10,000A Not rated F01 1/ A 125V 4A N/A 10,000A 10,000A Not rated F01 1/ A 125V 5A N/A 10,000A 10,000A Not rated Provided by IHSNot for ResaleNo reproduction or networking permit

12、ted without license from IHS-,-,-MIL-PRF-15160/1G 4 VERIFICATION: Qualification inspection is not applicable for the 1/500A thru 4/10A fuses of this specification sheet (see table I) and shall be replaced by acceptance testing consisting of Group A and Group B inspections per MIL-PRF-15160, prior to

13、 delivery. INSPECTION ROUTINE: Overload tests (group II): Fuses for the overload interrupt test shall be selected and tested as specified in table II for qualification test. TABLE II. Overload tests. Overload 1/ (percent) Number of samples 1/2A 2A 5A 135 4 4 4 200 4 4 - 1/ Room ambient. Short circui

14、t interrupt (group III): Four sample fuses of each rating shown in table III shall be tested at the values specified, followed by the insulation resistance test in accordance with MIL-PRF-15160 for qualification, and qualification retention. The ac voltage used shall be not less than the circuit vol

15、tage indicated and the fuses shall withstand the short circuits specified. Insulation resistance tests shall be conducted within 1 minute following the short circuit test. TABLE III. Short circuit tests. Current rating Short circuit current AC test voltage 1/2A 35A 250 2A 100A 125 5A 10,000A 125 Cro

16、ss-reference: For applicable cross-reference see table IV. The existing stocks of superseded items may be used. When exhausted, the superseding parts shall be used. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-TABLE IV. Cross reference. 1/ A lette

17、r “S” following the part number signifies silver plating. 2/ A second dash number (-1) signifies silver plating. 5 MIL-PRF-15160/1G Superseding number Superseded numbers 81349 96906 71400 71400 75915 75915 75915 98997 F01A250V1/500A 1/ F01GR002A 1/ MS90077-1 2/ AGX1/500 8AG1/500 361.005 364.002 F01A

18、250V1/200A F01GR005A MS90077-2 AGX1/200 8AG1/200 361.002 364.005 F01A250V1/100A F01GR010A MS90077-3 AGX1/100 8AG1/100 361.010 364.010 F01A250V1/32A F01GR031A MS90077-4 AGX1/32 8AG1/32 361.031 364.031 F01A250V1/16A F01GR062A MS90077-5 AGX1/16 8AG1/16 361.062 364.062 8AG1/16 F01A250V1/10A F01GR100A AG

19、X1/10 8AG1/10 361.100 364.100 8AG1/10 F01A250V1/8A F01GR125A MS90077-6 AGX1/8 8AG1/8 361.125 362.125 364.125 8AG1/8 F01A250V3/16A AGX3/16 8AG3/16 361.187 364.187 8AG3/16 F01A250V2/10A AGX2/10 8AG2/10 361.200 364.200 8AG2/10 F01A250V1/4A F01GR250A MS90077-7 AGX1/4 8AG1/4 361.250 362.250 364.250 8AG1/

20、4 F01A250V3/8A F01GR375A MS90077-8 AGX3/8 8AG3/8 361.375 362.375 364.375 8AG3/8 F01A250V4/10A AGX4/10 8AG4/10 361.400 364.400 8AG4/0 F01A250V1/2A F01GR500A MS90077-9 AGX1/2 8AG1/2 361.500 362.500 364.500 8AG1/2 F01A125V6/10A AGX6/10 8AG6/10 8AG6/10 F01A125V3/4A F01GR750A MS90077-10 AGX3/4 8AG3/4 361

21、.750 362.750 364.750 8AG3/4 F01A125V8/10A AGX8/10 8AG8/10 8AG8/10 F01A125V1A F01G1R00A MS90077-11 AGX1 8AG1 361001 362001 364001 8AG1 F01A125V1 1/4A 8AG1 1/4 8AG1 1/4 F01A125V1 1/2A F01G1R50A MS90077-12 AGX1 1/2 8AG1 1/2 36101.5 36201.5 36401.5 8AG1 1/2 F01A125V1 6/10A 8AG1 6/10 8AG1 6/10 F01A125V2A

22、 F01G2R00A MS90077-13 AGX2 8AG2 361002 362002 364002 8AG2 F01A125V2 1/2A AGX2 1/2 F01A125V3A AGX3 361003 362003 F01A125V3 1/2A AGX3 1/2 F01A125V4A AGX4 361004 F01A125V5A AGX5 361005 362005 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-15160

23、/1G 6 Reference documents. In addition to MIL-PRF-15160, this document references the following: MIL-STD-202 The margins of this specification sheet are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assu

24、mes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodians: Preparing activity: Arm

25、y - CR DLA - CC Navy - SH Air Force - 85 (Project 5920-2008-036) DLA - CC Review activities: Army - AT, CR4, MI Navy - AS, CG, MC, OS Air Force - 19, 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-