ASTM E1360-2005(2015) Standard Practice for Specifying Color by Using the Optical Society of America Uniform Color Scales System《采用美国光学学会的统一色标系统规定颜色的标准实践规程》.pdf
《ASTM E1360-2005(2015) Standard Practice for Specifying Color by Using the Optical Society of America Uniform Color Scales System《采用美国光学学会的统一色标系统规定颜色的标准实践规程》.pdf》由会员分享,可在线阅读,更多相关《ASTM E1360-2005(2015) Standard Practice for Specifying Color by Using the Optical Society of America Uniform Color Scales System《采用美国光学学会的统一色标系统规定颜色的标准实践规程》.pdf(15页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: E1360 05 (Reapproved 2015)Standard Practice forSpecifying Color by Using the Optical Society of AmericaUniform Color Scales System1This standard is issued under the fixed designation E1360; the number immediately following the designation indicates the year oforiginal adoption or, in th
2、e case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.INTRODUCTIONThe Optical Society ofAmerica Uniform Color Scales (OSA-UCS) were developed by a commi
3、tteeof the Optical Society ofAmerica in the years between 1947 and 1974 in an effort to provide a systemand a set of samples that represent the closest possible approximation to equal visual spacing (1).2Thesystem is defined by a set of equations derived from the results of visual scaling experiment
4、s andrelated to the 1964 CIE system. The OSA sample set consisted of 558 atlas samples that fell at thelattice points of a rhombohedral close-packed arrangement within the color space defined by theequations. The unit in this spacing is a cuboctahedron, each color being surrounded by twelveequidista
5、nt nearest neighbors. See Fig. 1 and Fig. 2. Fig. 3 shows a OSA-UCS lightness plane plottedon the CIE 1964 chromaticity diagram. The OSA-UCS system is described in Appendix X1.The system is independent of the OSA-UCS atlas samples, and other groups of samples could bechosen within the defined color
6、space; however, for the visual determination of colors described in thisstandard, the OSA set of samples is used.1. Scope1.1 This practice provides a means for specifying the colorsof objects in terms of the Optical Society of America UniformColor Scales. Both computational and visual methods areinc
7、luded. The practice is limited to opaque objects, such aspainted surfaces, viewed in daylight by an observer havingnormal color vision.1.2 This practice does not cover the preparation of speci-mens. If the preparation of specimens is required in conjunc-tion with this practice, a mutually agreed upo
8、n procedure shallbe established.2. Referenced Documents2.1 ASTM Standards:3D1535 Practice for Specifying Color by the Munsell SystemD1729 Practice for Visual Appraisal of Colors and ColorDifferences of Diffusely-Illuminated Opaque MaterialsE284 Terminology of AppearanceE308 Practice for Computing th
9、e Colors of Objects by Usingthe CIE SystemE1164 Practice for Obtaining Spectrometric Data for Object-Color Evaluation3. Terminology3.1 Definitions of Terms Specific to This Standard:3.1.1 chromaticness, nan attribute of a visual sensationcombining hue and chroma; the visual correlate of the colori-m
10、etric quantity chomaticity.3.1.2 hue, nthe attribute of color perception by means ofwhich an object is judged to be red, yellow, green, blue, orintermediate between some adjacent pair of these. In theOSA-UCS system each hue is denoted by its angle within a360 circle beginning in the yellow direction
11、 on the right handside of the hue circle and proceeding counterclockwise throughthe greens, blues, and reds to return to the yellow hue, 360, onthe + j axis.3.1.3 OSA-UCS color system, nOptical Society ofAmerica Uniform Color Scales color order system based onequality of visual spacing, which uses t
12、he lightness scale 6Land the opponent-color scales 6j(yellowness-blueness) and 6g(greenness-redness).Acolor in the OSA-UCS system may be1This practice is under the jurisdiction of ASTM Committee E12 on Color andAppearance and is the direct responsibility of Subcommittee E12.07 on Color OrderSystems.
13、Current edition approved May 1, 2015. Published May 2015. Originallyapproved in 1990. Last previous edition approved in 2010 as E1360 05 (2010).DOI: 10.1520/E1360-05R15.2The boldface numbers in parentheses refer to a list of references at the end ofthis practice.3For referenced ASTM standards, visit
14、 the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959
15、. United States1described by its L, j, g notation or by its lightness, L; hue angle,hOSA, and chroma, cOSA, designation.NOTE 1The conventional terms yellowness, greenness, blueness, andredness are used throughout this practice for convenience. However, thisdoes not imply that the j and g axes indica
16、te the locations of thecorresponding unitary hues: The + j axis closely approximates the direc-tion toward unitary yellow; but the + g axis divides the green and blueregions, the j axis divides the blue and purple regions, and the g axislocates pinks and magentas. It is probably best to think of j a
17、nd g asabstract symbols unassociated with color names (4).3.1.4 OSA-UCS samples, nthe Optical Society of Ameri-cas physical exemplification of the OSA-UCS color system,which consisted of 558 samples displayed in a face-centeredlattice in three-dimensional space such that each interiorsample has 12 n
18、earest neighbors at equal intervals from it. Thisconfiguration is sometimes referred to as a cuboctahedral orrhombohedral lattice.3.2 Definitions:3.2.1 The definitions in Practice D1535 and TerminologyE284 are applicable to this practice.4. Summary of Practice4.1 Computation MethodCIE 1964 tristimul
19、us values forstandard illuminant D65and the 1964 supplementary (10)standard observer are obtained from spectrophotometric orcolorimetric measurements. See Practice E308 and PracticeE1164. Transformation equations (5) from CIE 1964 tristimu-lus values to OSA-UCS notations are given in Section 7, andt
20、he OSA-UCS notations and CIE specifications of the OSAatlas samples are given in Table 1.4.2 Visual MethodObservers must have normal colorvision. Specimens should be viewed on an essentially nonse-lective gray background of 30 % luminous reflectance, equiva-lent to the OSA-UCS notation L=0,j=0,g=0,
21、abbreviatedas (0,0,0), and illuminated with natural or artificial daylight.OSA-UCS atlas samples are used as references in judgingtest-specimen color.5. Significance and Use5.1 Notational systems that specify and identify colors haveproved to be very useful. This practice describes how to assignan O
22、SA-UCS notation to a color specimen. This notation givesNOTE 1Cuboctahedron showing location of L, j, and g axes throughits center and the locations and L, j, g coordinates of the center point andits 12 nearest neighbors. The lattice of the OSA-UCS system is derived byextending this unit in all dire
23、ctions to the extremes of color space. In thisdrawing horizontal nearest-neighbor planes are emphasized with heavylines. From Billmeyer, F. W., Jr., “Survey of Color Order Systems,” ColorResearch and Application, Vol 12, (2). Copyright 1987, John Wiley see Practice E308 and Practice E1164 for an ind
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTME136020052015STANDARDPRACTICEFORSPECIFYINGCOLORBYUSINGTHEOPTICALSOCIETYOFAMERICAUNIFORMCOLORSCALESSYSTEM

链接地址:http://www.mydoc123.com/p-528542.html