FORD WSE-M2C908-A-2009 OIL ENGINE API CF SAE 50 ASSEMBLY FLUID TO BE USED WITH FORD WSS-M99P1111-A 《API CF、SAE 50装配液型发动机油 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD WSE-M2C908-A-2009 OIL ENGINE API CF SAE 50 ASSEMBLY FLUID TO BE USED WITH FORD WSS-M99P1111-A 《API CF、SAE 50装配液型发动机油 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD WSE-M2C908-A-2009 OIL ENGINE API CF SAE 50 ASSEMBLY FLUID TO BE USED WITH FORD WSS-M99P1111-A 《API CF、SAE 50装配液型发动机油 与标准FORD WSS-M99P1111-A一起使用 》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2009 12 10 Revised Revised title, Para 2,3.2, 3.5; deleted Para 3.4,3.5.1-3.5.6, supplement A para 3.1, 3.6 & 4 deleted 1992 03 17 Released NEO1-E-10127076-047 Printed copies are uncontrolled Copyright 2009, Ford Global Technologies, LLC Page

2、1 of 1 OIL, ENGINE, API CF, SAE 50, ASSEMBLY FLUID WSE-M2C908-A 1. SCOPE These material specifications define the minimum acceptable performance requirements and physical/chemical properties of engine oils to be used by Ford Motor Company in its worldwide engine/vehicle manufacturing operations. 2.

3、APPLICATION This specification was released originally for an assembly fluid for pre-lubrication of components in spark ignition and compression ignition engines prior to assembly. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform t

4、o the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 PERFORMANCE Shall meet all the requirements of API CF service category. All required engine tests shall be conducted in accordance with the most recently approved procedures as described in ASTM Standards and the app

5、licable ASTM Standards Research Reports and Information Letters. All tests under surveillance by ASTM must be conducted using test equipment monitored by and calibrated to the requirements of the ASTM Test Monitoring Center. 3.3 VISCOSITY GRADE Shall meet all the requirements of the applicable SAE v

6、iscosity grade as defined in SAE Standard J300 (latest revision), “Engine Oil Viscosity Classification“. 3.5 QUALIFICATION PROCEDURE It is the suppliers responsibility to have the technical evidence and documentation certifying that a given formulation meets all requirements described in this specification.