BS 5477-1977 Method for visual assessment by grid assay of dirt in paper for character recognition《采用栅格目测法测定字符识别纸中杂质的方法》.pdf

《BS 5477-1977 Method for visual assessment by grid assay of dirt in paper for character recognition《采用栅格目测法测定字符识别纸中杂质的方法》.pdf》由会员分享，可在线阅读，更多相关《BS 5477-1977 Method for visual assessment by grid assay of dirt in paper for character recognition《采用栅格目测法测定字符识别纸中杂质的方法》.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、BRITISH STANDARD BS 5477:1977 Method for Visual assessment, by grid assay, of dirt in paper for character recognition UDC 681.327.12:003:676.019.172BS5477:1977 This British Standard, having been prepared under the directionof the Data ProcessingStandards Committee,was published underthe authority of

2、 the Executive Board on 30 June1977 BSI 12-1999 The following BSI references relate to the work on this standard: Committee reference DPS/14 Draft for comment 76/61951 DC ISBN 0 580 09783 8 Cooperating organizations The Data Processing Standards Committee, under whose direction this British Standard

3、 was prepared, consists of representatives from the following Government departments and scientific and industrial organizations: British Airways British Computer Society* British Paper and Board Industry Federation* British Printing Industries Federation* Business Equipment Trade Association* Civil

4、 Service Department Central Computer Agency* Committee of London Clearing Bankers* Department of Industry Department of Industry National Physical Laboratory* Department of the Environment Fire Research Station Electricity Supply Industry in England and Wales* Electronic Engineering Association* Eng

5、ineering Equipment Users Association* Government Communication Headquarters HM Customs and Excise Institute of Cost and Management Accountants Institute of Municipal Treasurers and Accountants (Incorporated) Institution of Electrical and Electronics Technician Engineers Institution of Electrical Eng

6、ineers Institution of Mechanical Engineers London Transport Executive Ministry of Defence National Coal Board* National Research Development Corporation Post Office* Society of British Aerospace Companies The organizations marked with an asterisk in the above list, together with the following, were

7、directly represented on the committee entrusted with the preparation of this British Standard: Her Majestys Stationery Office PIRA Research Association for the Paper and Board, Printing and Packaging Industries Production Engineering Research Association of Great Britain Amendments issued since publ

8、ication Amd. No. Date of issue CommentsBS5477:1977 BSI 12-1999 i Contents Page Cooperating organizations Inside front cover Foreword ii 1 Scope 1 2 References 1 3 Definition 1 4 Equipment 1 5 Sampling and test area 1 6 Method 1 7 Report 1 8 Calibration 1 Publications referred to Inside back coverBS5

9、477:1977 ii BSI 12-1999 Foreword The grid assay method specified in this standard meets a need that has been felt by manufacturers and users of character recognition systems in data processing. It is the simpler of two methods contained in a draft revision of ISO/R1831 and is therefore fully in acco

10、rdance with the work currently being undertaken within ISO/TC97 “Computers and information processing”. A British Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Stand

11、ard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, pages1 and 2, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorpora

12、ted. This will be indicated in the amendment table on the inside front cover.BS5477:1977 BSI 12-1999 1 1 Scope This British Standard specifies a visual method of assessing dirt in paper used in character recognition systems. The method measures the proportion of the surface area containing particles

13、 that are immediately obvious to the eye. 2 References The titles of the publications referred to in this standard are listed on the inside back cover. 3 Definition For the purposes of this British Standard the following definition applies. dirt non-reflecting foreign particles embedded in a sheet o

14、f paper 4 Equipment The following equipment is required. a) Grid: a frame 1 m 1 m divided into100squares by fine wire. b) Working surface: to take paper and frame for viewing at a distance of about0.5m. c) Lighting: the lighting should be a close approximation to C.I.E. 1)recommended illuminant D65

15、as specified in BS950-1. The recommended level of illumination for this work is between750lx and 1500lx. BS 950-1 recommends750lx to3200lx, which could be excessively bright for viewing white papers. Care should be taken to minimize specular reflection in the direction of the observer. d) Cleaner: s

16、oft brush or vacuum cleaner to remove loose dirt or dust from the sample surface. e) Timer: to indicate 0.5 min or 1 min intervals. f) Counter: to tally the number of squares containing dirt. 5 Sampling and test area A total of6m 2of test samples shall be taken from a reel or stack of sheets in acco

17、rdance with BS3430. 6 Method Lay out sufficient test pieces, same side up, to form a square of area1m 2 . Remove loose dirt and dust from the surface. Place a grid over the test pieces. Start the timer and scan all the squares in turn in1min, recording once only with the counter the number of square

18、s seen to contain a dirt particle or particles. Repeat the test on the remaining5m 2 . 7 Report Report the number of squares per6m 2containing dirt. 8 Calibration Since observer-to-observer differences may exceed the variation due to change, observers should be selected by comparing assays and exclu

19、ding observers giving significantly high or low variation. Observer comparisons should be made periodically. For comparing results from different sources, assessed test pieces should be exchanged for calibration between groups of observers. 1) C.I.E. International Commission on Illumination.2 blankB

20、S5477:1977 BSI 12-1999 Publications referred to BS 950, Artificial daylight for the assessment of colour. BS 950-1, Illuminant for colour matching and colour appraisal. BS 3430, Sampling of paper and board for testing. ISO/R 1831, Printing specifications for optical character recognition. BS 5477:19

21、77 BSI 389 Chiswick High Road London W4 4AL BSIBritishStandardsInstitution BSI is the independent national body responsible for preparing BritishStandards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions BritishStandards a

22、re updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this B

23、ritishStandard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel:02089969000. Fax:02089967400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the lat

24、est editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel:02089969001. Fax:02089967001. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those t

25、hat have been published as BritishStandards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services ar

26、e also available which give details on all its products and services. Contact the Information Centre. Tel:02089967111. Fax:02089967048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of thes

27、e and other benefits contact Membership Administration. Tel:02089967002. Fax:02089967001. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs a

28、nd Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of ne

29、cessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel:02089967070.