ASTM D2786-1991(2006) Standard Test Method for Hydrocarbon Types Analysis of Gas-Oil Saturates Fractions by High Ionizing Voltage Mass Spectrometry《高电离电压质谱法分析气体油饱和馏分中烃类的标准试验方法》.pdf
《ASTM D2786-1991(2006) Standard Test Method for Hydrocarbon Types Analysis of Gas-Oil Saturates Fractions by High Ionizing Voltage Mass Spectrometry《高电离电压质谱法分析气体油饱和馏分中烃类的标准试验方法》.pdf》由会员分享,可在线阅读,更多相关《ASTM D2786-1991(2006) Standard Test Method for Hydrocarbon Types Analysis of Gas-Oil Saturates Fractions by High Ionizing Voltage Mass Spectrometry《高电离电压质谱法分析气体油饱和馏分中烃类的标准试验方法》.pdf(8页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D 2786 91 (Reapproved 2006)An American National StandardStandard Test Method forHydrocarbon Types Analysis of Gas-Oil Saturates Fractionsby High Ionizing Voltage Mass Spectrometry1This standard is issued under the fixed designation D 2786; the number immediately following the designatio
2、n indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon (e) indicates an editorial change since the last revision or reapproval.1. Scope1.1 This test method2covers the determi
3、nation by highionizing voltage mass spectrometry of seven saturated hydro-carbon types and one aromatic type in saturate petroleumfractions having average carbon numbers 16 through 32. Thesaturate types include alkanes (0-rings), single-ring naph-thenes, and five fused naphthene types with 2, 3, 4,
4、5, and 6rings. The nonsaturate type is monoaromatic. Noncondensednaphthenes are analyzed as single rings. Samples must benonolefinic and must contain less than 5 volume % monoaro-matic. Composition data are in volume percent.1.2 The values stated in acceptable SI units are to beregarded as the stand
5、ard. The values given in parentheses areprovided for information purposes only.1.3 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and dete
6、rmine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:3D 2549 Test Method for Separation of Representative Aro-matics and Nonaromatics Fractions of High-Boiling Oilsby Elution ChromatographyD 3239 Test Method for Aromatic Types Analysis of Gas-Oil
7、Aromatic Fractions by High Ionizing Voltage MassSpectrometryE 137 Practice for Evaluation of Mass Spectrometers forQuantitative Analysis from a Batch Inlet43. Terminology3.1 Definitions of Terms Specific to This Standard:3.1.1 Characteristic Mass Groupings:3.1.1.1( 71 5 71 1 85 1 99 1 113 alkanes!.
8、(1)3.1.1.2( 69 5 69 1 83 1 97 1 111 1 125 1 139 12ring!. (2)3.1.1.3( 109 5 109 1 123 1 137 1 151 1 165 1 179 1 193 22ring!.(3)3.1.1.4( 149 5 149 1 163 1 177 1 191 1 205 1 219 1 233 1 247 32ring!.(4)3.1.1.5( 189 5 189 1 203 1 217 1 231 1 245 1 259 1 273 1 2871 301 42ring!. (5)3.1.1.6( 229 5 229 1 243
9、 1 257 1 271 1 285 1 299 1 313 1 327 1 3411 355 52ring!. (6)3.1.1.7( 269 5 269 1 283 1 297 1 311 1 325 1 339 1 353 1 367 1 3811 395 1 409 62ring!. (7)3.1.1.8( 91 5 91 1 105 1 117 1 119 1 129 1 131 1 133 1 143 1 1451 147 1 157 1 159 1 171 monoaromatic!. (8)4. Summary of Test Method4.1 The relative ab
10、undance of alkanes (0-ring), 1-ring,2-ring, 3-ring, 4-ring, 5-ring, and 6-ring naphthenes in petro-leum saturate fractions is determined by mass spectrometryusing a summation of mass fragment groups most characteris-tic of each molecular type. Calculations are carried out by the1This test method is
11、under the jurisdiction of ASTM Committee D02 onPetroleum Products and Lubricants and is the direct responsibility of SubcommitteeD02.04 on Hydrocarbon Analysis.Current edition approved May 1, 2006. Published June 2006. Originallyapproved in 1969. Last previous edition approved in 2001 as D 2786 91 (
12、2001)e1.2Hood, A., and ONeal, M. J., Advances in Mass Spectrometry, AMSPA,Waldron, 1959, p. 175.3For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Docume
13、nt Summary page onthe ASTM website.4Withdrawn.1Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959, United States.use of inverted matrices (derived from ion intensity calibrationsensitivities) that are specific for any average carbon number.The saturate
14、 fraction is obtained by liquid elution chromatog-raphy, see Test Method D 2549.5. Significance and Use5.1 Aknowledge of the hydrocarbon composition of processstreams and petroleum products boiling within the range of 205to 540C (400 to 1000F) is useful in following the effect ofchanges in process v
15、ariables, diagnosing the source of plantupsets and in evaluating the effect of changes in compositionon product performance properties.5.2 This test method, when used together with Test MethodD 3239, provides a detailed analysis of the hydrocarboncomposition of such materials.6. Apparatus6.1 Mass Sp
16、ectrometerThe suitability of the mass spec-trometer to be used with this method shall be proven byperformance tests described both herein and in Practice E 137.6.2 Sample Inlet SystemAny inlet system may be usedthat permits the introduction of the sample without loss,contamination, or change in comp
17、osition. The system mustfunction in the range from 125 to 350C to provide anappropriate sampling device.6.3 Microburet or Constant-Volume Pipet.7. Reagents7.1 n-Hexadecane.(WarningCombustible. Vapor harm-ful.)8. Calibration8.1 Calibration matrix inverses are attached in Table 1which may be used dire
18、ctly provided the following proceduresare followed.TABLE 1 Calibration Matrix Inverses(71 ( 69 ( 109 ( 149 ( 189 ( 229 ( 269 (91C16Inversen-Alkanes0 Ring 0.5344 0.0292 0.0066 0.0215 0.0299 . . 0.01511 Ring 0.0610 0.3403 0.2146 0.1162 0.0362 . . 0.01122 Ring 0.0039 0.0170 0.8491 0.6968 0.3420 . . 0.0
19、0483 Ring 0.0000 0.0004 + 0.0115 1.7220 1.3545 . . 0.01524 Ring 0.0001 0.0004 0.0039 0.0138 3.2594 . . 0.0485MA 0.0007 0.0029 0.0237 0.1566 0.3494 . . 0.3521Isoalkanes0 Ring 0.6543 0.0358 0.0081 0.0264 0.0366 . . 0.01851 Ring 0.0866 0.3416 0.2143 0.1171 0.0377 . . 0.01012 Ring 0.0053 0.0172 0.8492 0
20、.6968 0.3420 . . 0.00463 Ring 0.0001 0.0004 0.0115 1.7220 1.3545 . . 0.01524 Ring 0.0000 0.0004 0.0039 0.0138 3.2594 . . 0.0485MA 0.0001 0.0029 0.0237 0.1565 0.3493 . . 0.3521C17Inversen-Alkanes0 Ring 0.5243 0.0311 0.0075 0.0227 0.0322 . . 0.01631 Ring 0.0660 0.3403 0.2130 0.1164 0.0385 . . 0.01212
21、Ring 0.0038 0.0154 0.8375 0.6826 0.3318 . . 0.00523 Ring 0.0000 0.0004 0.0095 1.6824 1.3111 . . 0.01664 Ring 0.0001 0.0004 0.0039 0.0147 3.1247 . . 0.0527MA 0.0007 0.0027 0.0220 0.1514 0.3331 . . 0.3612Isoalkanes0 Ring 0.6435 0.0382 0.0092 0.0279 0.0395 . . 0.02001 Ring 0.0942 0.3418 0.2125 0.1176 0
22、.0403 . . 0.01122 Ring 0.0054 0.0155 0.8375 0.6826 0.3319 . . 0.00523 Ring 0.0000 0.0002 0.0090 1.6825 1.3111 . . 0.01664 Ring 0.0000 0.0004 0.0040 0.0147 3.1247 . . 0.0527MA 0.0000 0.0027 0.0220 0.1514 0.3331 . . 0.3612C18Inversen-Alkanes0 Ring 0.5175 0.0338 0.0085 0.0234 0.0344 . . 0.01781 Ring 0.
23、0720 0.3404 0.2091 0.1183 0.0404 . . 0.01362 Ring 0.0039 0.0138 0.8183 0.6626 0.3213 . . 0.00573 Ring 0.0000 0.0003 0.0062 1.6426 1.2784 . . 0.01794 Ring 0.0001 0.0004 0.0040 0.0158 3.0158 . . 0.0567MA 0.0007 0.0025 0.0206 0.1445 0.3010 . . 0.3677Isoalkanes0 Ring 0.6335 0.0414 0.0103 0.0286 0.0422 .
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD278619912006STANDARDTESTMETHODFORHYDROCARBONTYPESANALYSISOFGASOILSATURATESFRACTIONSBYHIGHIONIZINGVOLTAGEMASSSPECTROMETRY

链接地址:http://www.mydoc123.com/p-513497.html