IEEE 1900 6A-2014 en Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and Other Advanced Radio Communication Systems Amendment 1 Proc.pdf

《IEEE 1900 6A-2014 en Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and Other Advanced Radio Communication Systems Amendment 1 Proc.pdf》由会员分享，可在线阅读，更多相关《IEEE 1900 6A-2014 en Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and Other Advanced Radio Communication Systems Amendment 1 Proc.pdf（52页珍藏版）》请在麦多课文档分享上搜索。

1、 IEEE Standard for Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and Other Advanced Radio Communication Systems Amendment 1: Procedures, Protocols, and Data Archive Enhanced Interfaces Sponsored by the IEEE Communications Society and IEEE Standards Coordinating Committe

2、e 41 on Dynamic Spectrum Access Networks IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Std 1900.6a-2014(Amendment toIEEE Std 1900.6-2011) IEEE Std 1900.6a-2014 (Amendment to IEEE Std 1900.6-2011) IEEE Standard for Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and

3、Other Advanced Radio Communication Systems Amendment 1: Procedures, Protocols, and Data Archive Enhanced Interfaces Sponsor IEEE Standards Coordinating Committee 41 on Dynamic Spectrum Access Networks of the IEEE Communications Society Approved 27 March 2014 IEEE-SA Standards Board Abstract: Include

4、d in this amendment to IEEE Std 1900.6 are procedures, protocols, and message format specifications for the exchange of sensing related data, control data, and configuration data between spectrum sensors and their clients. In addition, specifications for the exchange of sensing related and other rel

5、evant data and related interfaces between the data archive and other data sources have been added. Keywords: cognitive radio, data archive enhanced interface, data structure, distributed spectrum sensing, dynamic spectrum access, IEEE 1900.6, logical interface, procedures, protocols, sensing informa

6、tion, spectrum sensor The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2014 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 6 June 2014. Printed in the United States of America. IEEE is a r

7、egistered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are suppli

8、ed “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the vi

9、ewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or othe

10、r services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circ

11、umstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SU

12、BSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVE

13、N IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE sho

14、uld be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be con

15、sidered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal

16、position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for cha

17、nges in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests.

18、 For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation reques

19、ts. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users o

20、f IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable

21、regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international c

22、opyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making the

23、se documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual sta

24、ndard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individu

25、al standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time

26、 to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years.

27、When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IE

28、EE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For

29、 more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are

30、 encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or va

31、lidity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may

32、 indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent

33、Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or

34、conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights,

35、is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2014 IEEE. All rights reserved. vi Participants At the time this IEEE standard was completed, the Spectrum Sensing in Advanced Radio Systems Working Group had the following member

36、ship: Michael Gundlach, Chair Ha-Nguyen Tran, Secretary and Technical Editor Oliver Holland, Co-editor Yohannes Alemseged Stefan Aust Bernd Bochow Klaus Moessner Dominique Noguet Venkatesha Prasad Chen Sun Hongjian Sun Dimitri Tassetto Gabriel Villardi Jiantao Xue The following members of the indivi

37、dual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Harry Bims Bernd Bochow Nancy Bravin C. Caicedo Bastidas Timothy David Farnham Randall Groves Michael Gundlach Oliver Holland Tetsuya Ito Stuart Kerry Adrian Kliks Thomas Kurihara Nils

38、 Langhammer Edward McCall Neal Mellen Michael Newman Dominique Noguet Venkatesha Prasad Maximilian Riegel Benjamin Rolfe M. K. Sajeev Shigenobu Sasaki Naotaka Sato Bartien Sayogo Thomas Starai Walter Struppler Ha-Nguyen Tran Hung-Yu Wei Daidi Zhong When the IEEE-SA Standards Board approved this stan

39、dard on 27 March 2014, it had the following membership: John Kulick, Chair Jon Walter Rosdahl, Vice Chair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Peter Balma Farooq Bari Ted Burse Clint Chaplin Stephen Dukes Jean-Philippe Faure Gary Hoffman Michael Janezic Jeffrey Katz Jose

40、ph L. Koepfinger* David J. Law Hung Ling Oleg Logvinov Ted Olsen Glenn Parsons Ron Petersen Adrian Stephens Peter Sutherland Yatin Trivedi Phil Winston Don Wright Yu Yuan *Member Emeritus Copyright 2014 IEEE. All rights reserved. vii Also included are the following nonvoting IEEE-SA Standards Board

41、liaisons: Richard DeBlasio, DOE Representative Michael Janezic, NIST Representative Julie Alessi IEEE-SA Content Publishing Lisa Perry IEEE-SA Technical Community Programs Copyright 2014 IEEE. All rights reserved. viii Introduction This introduction is not part of IEEE Std 1900.6a-2014, IEEE Standar

42、d for Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and Other Advanced Radio Communication Systems Amendment 1: Procedures, Protocols, and Data Archive Enhanced Interfaces. This amendment to IEEE Std 1900.6-2011 adds procedures, protocols, and message format specificati

43、ons for the exchange of sensing related data, control data, and configuration data between spectrum sensors and their clients. In addition, it adds specifications for the exchange of sensing related and other relevant data and specifies related interfaces between the data archive and other data sour

44、ces. Copyright 2014 IEEE. All rights reserved. ix Contents 3. Definitions, acronyms, and abbreviations 2 3.1 Definitions . 2 4. System model . 2 4.4 Scenario 4: Single CE/DA, multiple sensors that may act as a gateway to non-compliant subsystems . 2 5. The IEEE 1900.6 reference model 3 5.1 General d

45、escription 3 6. Information description 16 6.3 Description of sensing-related parameters . 16 6.4 Data representation 23 Annex A (informative) Use cases . 27 Annex B (informative) Use case classification . 33 Annex C (informative) Implementation of distributed sensing 37 Annex F (informative) Biblio

46、graphy 40 Copyright 2014 IEEE. All rights reserved. 1 IEEE Standard for Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and Other Advanced Radio Communication Systems Amendment 1: Procedures, Protocols, and Data Archive Enhanced Interfaces IMPORTANT NOTICE: IEEE Standards

47、 documents are not intended to ensure safety, security, health, or environmental protection, or ensure against interference with or from other devices or networks. Implementers of IEEE Standards documents are responsible for determining and complying with all appropriate safety, security, environmen

48、tal, health, and interference protection practices and all applicable laws and regulations. This IEEE document is made available for use subject to important notices and legal disclaimers. These notices and disclaimers appear in all publications containing this document and may be found under the he

49、ading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Documents.” They can also be obtained on request from IEEE or viewed at http:/standards.ieee.org/IPR/disclaimers.html. NOTEThe editing instructions contained in this amendment define how to merge the material contained therein into the existing base standard and its amendments to form the comprehensive standard. The editing instructions are shown in bold italic. Four editing instructions are used: change, delete, insert, and replace. Change is used to make corrections in existing text or