ITU-T G 999 1 AMD 1-2014 Interface between the link layer and the physical layer for digital subscriber line (DSL) transceivers Amendment 1 Extension for flow control on the PHY-to(St.pdf

《ITU-T G 999 1 AMD 1-2014 Interface between the link layer and the physical layer for digital subscriber line (DSL) transceivers Amendment 1 Extension for flow control on the PHY-to(St.pdf》由会员分享，可在线阅读，更多相关《ITU-T G 999 1 AMD 1-2014 Interface between the link layer and the physical layer for digital subscriber line (DSL) transceivers Amendment 1 Extension for flow control on the PHY-to(St.pdf（10页珍藏版）》请在麦多课文档分享上搜索。

1、 I n t e r n a t i o n a l T e l e c o m m u n i c a t i o n U n i o n ITU-T G.999.1 TELECOMMUNICATION STANDARDIZATION SECTOR OF ITU Amendment 1 (04/2014) SERIES G: TRANSMISSION SYSTEMS AND MEDIA, DIGITAL SYSTEMS AND NETWORKS Digital sections and digital line system Metallic access networks Interfac

2、e between the link layer and the physical layer for digital subscriber line (DSL) transceivers Amendment 1: Extension for flow control on the PHY-to-LINK data stream over gamma reference point Recommendation ITU-T G.999.1 (2009) Amendment 1 ITU-T G-SERIES RECOMMENDATIONS TRANSMISSION SYSTEMS AND MED

3、IA, DIGITAL SYSTEMS AND NETWORKS INTERNATIONAL TELEPHONE CONNECTIONS AND CIRCUITS G.100G.199 GENERAL CHARACTERISTICS COMMON TO ALL ANALOGUE CARRIER-TRANSMISSION SYSTEMS G.200G.299 INDIVIDUAL CHARACTERISTICS OF INTERNATIONAL CARRIER TELEPHONE SYSTEMS ON METALLIC LINES G.300G.399 GENERAL CHARACTERISTI

4、CS OF INTERNATIONAL CARRIER TELEPHONE SYSTEMS ON RADIO-RELAY OR SATELLITE LINKS AND INTERCONNECTION WITH METALLIC LINES G.400G.449 COORDINATION OF RADIOTELEPHONY AND LINE TELEPHONY G.450G.499 TRANSMISSION MEDIA AND OPTICAL SYSTEMS CHARACTERISTICS G.600G.699 DIGITAL TERMINAL EQUIPMENTS G.700G.799 DIG

5、ITAL NETWORKS G.800G.899 DIGITAL SECTIONS AND DIGITAL LINE SYSTEM G.900G.999 General G.900G.909 Parameters for optical fibre cable systems G.910G.919 Digital sections at hierarchical bit rates based on a bit rate of 2048 kbit/s G.920G.929 Digital line transmission systems on cable at non-hierarchica

6、l bit rates G.930G.939 Digital line systems provided by FDM transmission bearers G.940G.949 Digital line systems G.950G.959 Digital section and digital transmission systems for customer access to ISDN G.960G.969 Optical fibre submarine cable systems G.970G.979 Optical line systems for local and acce

7、ss networks G.980G.989 Metallic access networks G.990G.999 MULTIMEDIA QUALITY OF SERVICE AND PERFORMANCE GENERIC AND USER-RELATED ASPECTS G.1000G.1999 TRANSMISSION MEDIA CHARACTERISTICS G.6000G.6999 DATA OVER TRANSPORT GENERIC ASPECTS G.7000G.7999 PACKET OVER TRANSPORT ASPECTS G.8000G.8999 ACCESS NE

8、TWORKS G.9000G.9999 For further details, please refer to the list of ITU-T Recommendations. Rec. ITU-T G.999.1 (2009)/Amd.1 (04/2014) i Recommendation ITU-T G.999.1 Interface between the link layer and the physical layer for digital subscriber line (DSL) transceivers Amendment 1 Extension for flow c

9、ontrol on the PHY-to-LINK data stream over gamma reference point Summary Amendment 1 to Recommendation ITU-T G.999.1 (2009) provides the following update: Revision to clause 6.3 with extension for flow control on the PHY-to-LINK data stream over gamma reference point. Update of clause 7, Table 7-1 C

10、onfiguration parameters for the encapsulation. History Edition Recommendation Approval Study Group Unique ID* 1.0 ITU-T G.999.1 2009-10-09 15 11.1002/1000/9677 1.1 ITU-T G.999.1 (2009) Cor. 1 2010-04-22 15 11.1002/1000/10703 1.2 ITU-T G.999.1 (2009) Amd.1 2014-04-04 15 11.1002/1000/12091 _ * To acce

11、ss the Recommendation, type the URL http:/handle.itu.int/ in the address field of your web browser, followed by the Recommendations unique ID. For example, http:/handle.itu.int/11.1002/1000/11830-en. ii Rec. ITU-T G.999.1 (2009)/Amd.1 (04/2014) FOREWORD The International Telecommunication Union (ITU

12、) is the United Nations specialized agency in the field of telecommunications, information and communication technologies (ICTs). The ITU Telecommunication Standardization Sector (ITU-T) is a permanent organ of ITU. ITU-T is responsible for studying technical, operating and tariff questions and issu

13、ing Recommendations on them with a view to standardizing telecommunications on a worldwide basis. The World Telecommunication Standardization Assembly (WTSA), which meets every four years, establishes the topics for study by the ITU-T study groups which, in turn, produce Recommendations on these top

14、ics. The approval of ITU-T Recommendations is covered by the procedure laid down in WTSA Resolution 1. In some areas of information technology which fall within ITU-Ts purview, the necessary standards are prepared on a collaborative basis with ISO and IEC. NOTE In this Recommendation, the expression

15、 “Administration“ is used for conciseness to indicate both a telecommunication administration and a recognized operating agency. Compliance with this Recommendation is voluntary. However, the Recommendation may contain certain mandatory provisions (to ensure, e.g., interoperability or applicability)

16、 and compliance with the Recommendation is achieved when all of these mandatory provisions are met. The words “shall“ or some other obligatory language such as “must“ and the negative equivalents are used to express requirements. The use of such words does not suggest that compliance with the Recomm

17、endation is required of any party. INTELLECTUAL PROPERTY RIGHTSITU draws attention to the possibility that the practice or implementation of this Recommendation may involve the use of a claimed Intellectual Property Right. ITU takes no position concerning the evidence, validity or applicability of c

18、laimed Intellectual Property Rights, whether asserted by ITU members or others outside of the Recommendation development process. As of the date of approval of this Recommendation, ITU had received notice of intellectual property, protected by patents, which may be required to implement this Recomme

19、ndation. However, implementers are cautioned that this may not represent the latest information and are therefore strongly urged to consult the TSB patent database at http:/www.itu.int/ITU-T/ipr/. ITU 2014 All rights reserved. No part of this publication may be reproduced, by any means whatsoever, w

20、ithout the prior written permission of ITU. Rec. ITU-T G.999.1 (2009)/Amd.1 (04/2014) 1 Recommendation ITU-T G.999.1 Interface between the link layer and the physical layer for digital subscriber line (DSL) transceivers Amendment 1 Extension for flow control on the PHY-to-LINK data stream over gamma

21、 reference point 1) Clause 6.3 Update clause 6.3 “Data flow control“ as follows: 6.3 Data flow control Data flow control (DFC) is a mechanism that prevents congestion by ensuring that transmitting devices do not overwhelm receiving devices with data. This is achieved by the receiving device informin

22、g in advance the transmitting device when no further data can be received (e.g., when the RX-Buffer-Filling becomes critical), after which the transmitter stops transmission (= Transmission-Off = XOFF = Active-Backpressure) until the receiver indicates in the same manner that it has regained ability

23、 to receive data (e.g., enough free RX-Buffer-Resources) and transmission may continue (= Transmission-On = XON = Inactive-Backpressure). For the LINK/PHY interface, data flow control is defined only independently for the both the transmission of data from the (transmitting) LINK device to the (rece

24、iving) PHY device and for the transmission of data from the (transmitting) PHY device to the (receiving) LINK device. Data flow control is defined per data stream to prevent loss of data units. To control the data flow from the LINKtransmitting device to the PHYreceiving device, the PHYreceiving dev

25、ice may transmit pause units to the LINKtransmitting device. The format of the pause unit is shown in Figure 6-4. L SB M SB 2 O ct et s O P C O D E f c 0 N bits , N/8 oc te ts ( N mul tiple of 8 ) DFC f c 7 f c 6 f c 5 f c 4 f c 3 f c 2 f c 1 fc N - 1 fc N - 2 fc N - 3 fc N - 4 fc N - 5 fc N - 6 fc

26、N - 7 fc N - 8 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1 T IME 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2 O ctet s Figure 6-4 Pause unit format The OPCODE field shall be set to 0x0001 (i.e., the Ethernet MAC control opcode for pause frame). The OPCODE value allows to uniquely distinguish pause units from tagged data f

27、ragments. The TIME field shall be set to 0x0000 (i.e., the Ethernet pause frame value for immediate resume of transmission). 2 Rec. ITU-T G.999.1 (2009)/Amd.1 (04/2014) The DFC field shall contain N/8 octets, where N represents the highest used SID, incremented to the next multiple of 8. The N data

28、flow control bits fc0fcN1 represent the data flow control states for the stream with SID = 0 up to the stream with SID = N1. A data flow control bit shall be set to 0 to indicate the XON-State and shall be set to 1 to indicate XOFF-State for the respective data stream. A data flow control bit corres

29、ponding to an unused SID shall be set to 0. Upon reception of a pause unit from a PHYreceiving device-side, the LINKtransmitting device shall stop transmission within the XOFF-latency of 10 microseconds for the data streams with their flow control bit set to XOFF in this PAUSE unit. Upon reception o

30、f a pause unit from a PHY receiving device, the LINKtransmitting device shall resume transmission within the XON-latency of 240 microseconds for all the data streams with their flow control bit set to XON in this PAUSE unit and was set to XOFF in the last transmitted PAUSE unit and for which the las

31、t transmitted fragment was not the last fragment of a data unit. The XOFF-latency and XON-latency are referred to the LINK/PHY-reference point (see Figure 5-1). The XOFF-latency shall be measured from the last FCS bit of the PAUSE unit transmitted by the PHY device to the last FCS bit of the last fr

32、agment transmitted by the LINK-side for the concerned data stream. The XON-latency shall be measured from the last FCS bit of the PAUSE unit transmitted by the PHY device to the last FCS bit of the first fragment transmitted by the LINK-side for the concerned data stream. If a data stream is in the

33、XON-state, then the transmitter shall manage the time in-between the transmission of consecutive data fragments belonging to the same data unit, so as to avoid data underflow in the reassembly of the data units at the receiving side. Operation with flow control on the PHY-to-LINK data stream (i.e.,

34、where the LINK device is the receiving device) is enabled only if the corresponding capability is indicated by both the LINK and PHY devices per the configuration parameter FCTL-us (see Table 7-1). 2) Clause 7 Update clause 7 “Configuration parameters“ as follows: 7 Configuration parameters Table 7-

35、1 summarizes the encapsulation configuration parameters defined in clause 6 and defines a detailed format. Table 7-1 Configuration parameters for the encapsulation NAME SIZE LINK PHY Definition FRAGMENTATION (clause 6.1) TXC_MFS 10:0 R R Maximum fragment data size supported by near-end transmitter.

36、RXC_MFS 10:0 R R Maximum fragment data size supported by near-end receiver. TX_MFS 10:0 R/W R/W Maximum fragment data size to be used by near-end transmitter. LENGTH MODE 0 R/W R/W 0: LENGTH field shall not be appended. 1: LENGTH field shall be appended. Rec. ITU-T G.999.1 (2009)/Amd.1 (04/2014) 3 T

37、able 7-1 Configuration parameters for the encapsulation NAME SIZE LINK PHY Definition FLOW CONTROL on the PHY-to-LINK data stream (clause 6.3) FCTL-us 0 R/W R/W 0: Flow Control on the PHY-to-LINK data stream Not Supported. 1: Flow Control on the PHY-to-LINK data stream Supported. ETHERNET ADAPTATION

38、 (clause 6.4) ETH 0 R/W R/W 0: Ethernet Adaptation shall not be used. 1: Ethernet Adaptation shall be used. NE_MAC_ADDRESS 47:0 R/W R/W Near-end MAC Address FE_MAC_ADDRESS 47:0 R/W R/W Far-end MAC Address PAUSE_MULTICAST 0 R/W R/W 0: Pause frame shall have far-end MAC address as destination MAC addr

39、ess. 1: Pause frame shall have multicast MAC address as destination MAC address. If the ETH bit is set to ONE, then the LENGTH MODE bit shall also be set to ONE. Printed in Switzerland Geneva, 2014 SERIES OF ITU-T RECOMMENDATIONS Series A Organization of the work of ITU-T Series D General tariff pri

40、nciples Series E Overall network operation, telephone service, service operation and human factors Series F Non-telephone telecommunication services Series G Transmission systems and media, digital systems and networks Series H Audiovisual and multimedia systems Series I Integrated services digital

41、network Series J Cable networks and transmission of television, sound programme and other multimedia signals Series K Protection against interference Series L Construction, installation and protection of cables and other elements of outside plant Series M Telecommunication management, including TMN

42、and network maintenance Series N Maintenance: international sound programme and television transmission circuits Series O Specifications of measuring equipment Series P Terminals and subjective and objective assessment methods Series Q Switching and signalling Series R Telegraph transmission Series

43、S Telegraph services terminal equipment Series T Terminals for telematic services Series U Telegraph switching Series V Data communication over the telephone network Series X Data networks, open system communications and security Series Y Global information infrastructure, Internet protocol aspects and next-generation networks Series Z Languages and general software aspects for telecommunication systems