ETSI TS 124 380-2017 LTE Mission Critical Push To Talk (MCPTT) media plane control Protocol specification (V14 4 0 3GPP TS 24 380 version 14 4 0 Release 14)《长期演进技术(LTE) 关键任务一按通(MCP.pdf
《ETSI TS 124 380-2017 LTE Mission Critical Push To Talk (MCPTT) media plane control Protocol specification (V14 4 0 3GPP TS 24 380 version 14 4 0 Release 14)《长期演进技术(LTE) 关键任务一按通(MCP.pdf》由会员分享,可在线阅读,更多相关《ETSI TS 124 380-2017 LTE Mission Critical Push To Talk (MCPTT) media plane control Protocol specification (V14 4 0 3GPP TS 24 380 version 14 4 0 Release 14)《长期演进技术(LTE) 关键任务一按通(MCP.pdf(241页珍藏版)》请在麦多课文档分享上搜索。
1、 ETSI TS 1Mission Critical Push TProt(3GPP TS 24.3TECHNICAL SPECIFICATION124 380 V13.3.0 (2017LTE; h To Talk (MCPTT) media planrotocol specification .380 version 13.3.0 Release 1317-01) ane control; 13) ETSI ETSI TS 124 380 V13.3.0 (2017-01)13GPP TS 24.380 version 13.3.0 Release 13Reference RTS/TSGC
2、-0124380vd30 Keywords LTE ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice The present document
3、can be downloaded from: http:/www.etsi.org/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of
4、 any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document m
5、ay be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at https:/portal.etsi.org/TB/ETSIDeliverableStatus.aspx If you find errors in the present document, please send your comment to one of the following services: https:/portal.
6、etsi.org/People/CommiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified
7、without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2017. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTMand the ETSI logo are Trade Marks of ETSI registered for the benefit of it
8、s Members. 3GPPTM and LTE are Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned by the GSM Association. ETSI ETSI TS 124 380 V13.3.0 (2017-01)23GPP TS 24.380 version 13.3.0 Release 13Intell
9、ectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Right
10、s (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (https:/ipr.etsi.org/). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has
11、 been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Technical Specification (TS) has been produced by ETS
12、I 3rd Generation Partnership Project (3GPP). The present document may refer to technical specifications or reports using their 3GPP identities, UMTS identities or GSM identities. These should be interpreted as being references to the corresponding ETSI deliverables. The cross reference between GSM,
13、UMTS, 3GPP and ETSI identities can be found under http:/webapp.etsi.org/key/queryform.asp. Modal verbs terminology In the present document “shall“, “shall not“, “should“, “should not“, “may“, “need not“, “will“, “will not“, “can“ and “cannot“ are to be interpreted as described in clause 3.2 of the E
14、TSI Drafting Rules (Verbal forms for the expression of provisions). “must“ and “must not“ are NOT allowed in ETSI deliverables except when used in direct citation. ETSI ETSI TS 124 380 V13.3.0 (2017-01)33GPP TS 24.380 version 13.3.0 Release 13Contents Intellectual Property Rights 2g3Foreword . 2g3Mo
15、dal verbs terminology 2g3Foreword . 14g31 Scope 15g32 References 15g33 Definitions and abbreviations . 16g33.1 Definitions 16g33.2 Abbreviations . 17g34 General . 18g34.1 Overview 18g34.1.1 Floor Control 18g34.1.1.1 General 18g34.1.1.2 On-network floor control 18g34.1.1.3 Off-network floor control 1
16、9g34.1.1.4 Determine on-network effective priority . 19g34.1.1.5 Determine off-network effective priority 20g34.1.2 Pre-established session call control. 20g34.1.2.1 General 20g34.1.2.2 Call setup over pre-established session . 20g34.1.2.3 Release of a call which uses a pre-established session 21g34
17、.1.3 MBMS subchannel control . 21g34.1.3.1 General 21g34.1.3.2 Start of a conversation . 22g34.1.3.3 During a conversation . 22g34.1.3.4 Ending the conversation 22g34.2 Internal structure of media plane control entities . 22g34.2.1 Controlling MCPTT function . 22g34.2.2 MCPTT client . 24g34.2.3 Part
18、icipating MCPTT function . 26g34.2.3.1 General 26g34.2.3.2 Internal structure of the participating MCPTT function 26g34.2.3.3 The roles of the participating MCPTT function 27g34.2.3.3.1 For the floor control procedures 27g34.2.3.3.2 For the call over pre-established session procedures . 27g34.2.3.3.
19、3 For the use of MBMS bearer procedures . 27g34.2.4 Non-controlling MCPTT function of an MCPTT group . 28g34.3 The media plane control channel 29g34.3.1 General 29g34.3.2 Control channel realization . 29g34.3.3 Establishing a media plane control channel 30g34.3.3.1 General 30g35 Entities 30g35.1 Gen
20、eral . 30g35.2 MCPTT client . 30g35.2.1 Introduction. 30g35.2.2 Floor participant in on-network mode 31g35.2.3 Floor participant in off-network mode 31g35.3 Controlling MCPTT function . 31g35.4 Participating MCPTT function . 32g35.5 Non-controlling MCPTT function 32g3ETSI ETSI TS 124 380 V13.3.0 (20
21、17-01)43GPP TS 24.380 version 13.3.0 Release 136 On-network floor control 32g36.1 General . 32g36.2 Floor participant procedures . 33g36.2.1 Floor participant procedures at MCPTT session initialization 33g36.2.2 Floor participant procedures at MCPTT call release 33g36.2.3 Floor participant procedure
22、s at MCPTT call modification . 33g36.2.4 Floor participant state transition diagram for basic operation . 33g36.2.4.1 General 33g36.2.4.2 State: Start-stop 35g36.2.4.2.1 General 35g36.2.4.2.2 MCPTT call initiated, originating MCPTT user 35g36.2.4.2.3 MCPTT call established, terminating MCPTT user 35
23、g36.2.4.3 State: U: has no permission . 35g36.2.4.3.1 General 35g36.2.4.3.2 Receive Floor Idle message (R: Floor Idle) . 35g36.2.4.3.3 Receive Floor Taken message (R: Floor Taken) . 36g36.2.4.3.4 Receive RTP media packets (R: RTP media) 36g36.2.4.3.5 Send Floor Request message (PTT button pressed) 3
24、6g36.2.4.3.6 Timer T103 (End of RTP media) expired 36g36.2.4.4 State: U: pending Request . 37g36.2.4.4.1 General 37g36.2.4.4.2 Receive Floor Granted message (R: Floor Granted) 37g36.2.4.4.3 Receive Floor Taken message (R: Floor Taken) . 37g36.2.4.4.4 Receive Floor Deny message (R: Floor Deny) 38g36.
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ETSITS1243802017LTEMISSIONCRITICALPUSHTOTALKMCPTTMEDIAPLANECONTROLPROTOCOLSPECIFICATIONV14403GPPTS24380VERSION1440RELEASE14

链接地址:http://www.mydoc123.com/p-741285.html