ASTM D7566-2012a red 9375 Standard Specification for Aviation Turbine Fuel Containing Synthesized Hydrocarbons《含有合成烃类的航空涡轮机燃料的标准规范》.pdf
《ASTM D7566-2012a red 9375 Standard Specification for Aviation Turbine Fuel Containing Synthesized Hydrocarbons《含有合成烃类的航空涡轮机燃料的标准规范》.pdf》由会员分享,可在线阅读,更多相关《ASTM D7566-2012a red 9375 Standard Specification for Aviation Turbine Fuel Containing Synthesized Hydrocarbons《含有合成烃类的航空涡轮机燃料的标准规范》.pdf(32页珍藏版)》请在麦多课文档分享上搜索。
1、Designation:D756612D756612a An American National Standard Standard Specication for Aviation Turbine Fuel Containing Synthesized Hydrocarbons 1 This standard is issued under the xed designation D7566; the number immediately following the designation indicates the year of original adoption or, in the
2、case of revision, the year of last revision.Anumber in parentheses indicates the year of last reapproval.A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* 1.1 This
3、specication covers the manufacture of aviation turbine fuel that consists of conventional and synthetic blending components. 1.2 This specication applies only at the point of batch origination.Aviation turbine fuel manufactured, certied and released to all the requirements of this specication, meets
4、 the requirements of Specication origination, D1655 and shall be regarded as Specication as follows:D1655 turbine fuel. Once released to this specication (D7566) the requirements of this specication are no longer applicable: any recertication shall be done to D1655. Field blending of synthesized par
5、affinic kerosine (SPK) with D1655fuel(whichmayonthewholeorinparthaveoriginatedasD7566fuel)shallbeconsideredbatchoriginationinwhichcase all of the requirements of this specication (D7566) apply, however the fuel shall be regarded as D1655 turbine fuel after certication and release. 1.2.1 Aviationturb
6、inefuelmanufactured,certied,andreleasedtoalltherequirementsofTable1ofthisspecication(D7566), meets the requirements of Specication D1655 and shall be regarded as Specication D1655 turbine fuel. Duplicate testing is not necessary; the same data may be used for both D7566 and D1655 compliance. Once th
7、e fuel is released to this specication (D7566)theuniquerequirementsofthisspecicationarenolongerapplicable:anyrecerticationshallbedoneinaccordancewith Table1 of Specication D1655. 1.2.2 Field blending of synthesized paraffinic kerosine (SPK) blendstocks, as described in Annex A1 (FT SPK) or Annex A2
8、(HEFA SPK) with D1655 fuel (which may on the whole or in part have originated as D7566 fuel) shall be considered batch origination in which case all of the requirements ofTable 1 of this specication (D7566) apply and shall be evaluated. Short form conformancetestprogramscommonlyusedtoensuretransport
9、ationqualityarenotsufficient.ThefuelshallberegardedasD1655 turbine fuel after certication and release as described in 1.2.1. 1.2.3 OnceafuelisredesignatedasD1655aviationturbinefuel,itcanbehandledinthesamefashionastheequivalentrened D1655 aviation turbine fuel. 1.3 This specication denes specic types
10、 of aviation turbine fuel that contain synthesized hydrocarbons for civil use in the operation and certication of aircraft and describes fuels found satisfactory for the operation of aircraft and engines. The specication is intended to be used as a standard in describing the quality of aviation turb
11、ine fuels and synthetic blending components at the place of manufacture but can be used to describe the quality of aviation turbine fuels for contractual transfer at all points in the distribution system. 1.4 Thisspecicationdoesnotincludeallfuelssatisfactoryforaviationturbineengines.Certainequipment
12、orconditionsofuse may permit a wider, or require a narrower, range of characteristics than is shown by this specication. 1.5 While aviation turbine fuels dened by Table 1 of this specication can be used in applications other than aviation turbine engines, requirements for such other applications hav
13、e not been considered in the development of this specication. 1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It i
14、s the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1 This specication is under the jurisdiction ofASTM Committee D02 on Petroleum Products and Lubricants and is the direct resp
15、onsibility of Subcommittee D02.J0.06 on Emerging Turbine Fuels. Current edition approved Oct. 1, 2012Nov. 1, 2012. Published December 2012February 2013. Originally approved in 2009. Last previous edition approved in 20112012 as D7566D756611a.12. DOI: 10.1520/D7566-12.10.1520/D7566-12A. This document
16、 is not anASTM standard and is intended only to provide the user of anASTM standard an indication of what changes have been made to the previous version. Because it may not be technically possible to adequately depict all changes accurately,ASTM recommends that users consult prior editions as approp
17、riate. In all cases only the current version of the standard as published by ASTM is to be considered the official document. *ASummary of Changes section appears at the end of this standard Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United Sta
18、tes 12. Referenced Documents 2.1 ASTM Standards: 2 D56Test Method for Flash Point by Tag Closed Cup Tester D86Test Method for Distillation of Petroleum Products at Atmospheric Pressure D93Test Methods for Flash Point by Pensky-Martens Closed Cup Tester D129Test Method for Sulfur in Petroleum Product
19、s (General High Pressure Decomposition Device Method) D130Test Method for Corrosiveness to Copper from Petroleum Products by Copper Strip Test D156Test Method for Saybolt Color of Petroleum Products (Saybolt Chromometer Method) D240Test Method for Heat of Combustion of Liquid Hydrocarbon Fuels by Bo
20、mb Calorimeter D323Test Method for Vapor Pressure of Petroleum Products (Reid Method) D381Test Method for Gum Content in Fuels by Jet Evaporation D445Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity) D1266Test Method for Sulfur in Petroleum
21、Products (Lamp Method) D1298Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method D1319Test Method for Hydrocarbon Types in Liquid Petroleum Products by Fluorescent Indicator Adsorption D1322Test Method for Smoke Point of Kero
22、sine and Aviation Turbine Fuel D1405Test Method for Estimation of Net Heat of Combustion of Aviation Fuels D1655Specication for Aviation Turbine Fuels D1740Test Method for Luminometer Numbers of Aviation Turbine Fuels (Withdrawn 2006) 3 D1840Test Method for Naphthalene Hydrocarbons in Aviation Turbi
23、ne Fuels by Ultraviolet Spectrophotometry D2276Test Method for Particulate Contaminant in Aviation Fuel by Line Sampling D2386Test Method for Freezing Point of Aviation Fuels D2425Test Method for Hydrocarbon Types in Middle Distillates by Mass Spectrometry D2622Test Method for Sulfur in Petroleum Pr
24、oducts by Wavelength Dispersive X-ray Fluorescence Spectrometry D2624Test Methods for Electrical Conductivity of Aviation and Distillate Fuels D2887Test Method for Boiling Range Distribution of Petroleum Fractions by Gas Chromatography D2892Test Method for Distillation of Crude Petroleum (15-Theoret
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD75662012ARED9375STANDARDSPECIFICATIONFORAVIATIONTURBINEFUELCONTAININGSYNTHESIZEDHYDROCARBONS 含有

链接地址:http://www.mydoc123.com/p-525820.html