ASTM D2281-2010(2016) Standard Test Method for Evaluation of Wetting Agents by the Skein Test《采用绞纱试验法评估湿润剂的标准试验方法》.pdf

《ASTM D2281-2010(2016) Standard Test Method for Evaluation of Wetting Agents by the Skein Test《采用绞纱试验法评估湿润剂的标准试验方法》.pdf》由会员分享，可在线阅读，更多相关《ASTM D2281-2010(2016) Standard Test Method for Evaluation of Wetting Agents by the Skein Test《采用绞纱试验法评估湿润剂的标准试验方法》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、Designation: D2281 10 (Reapproved 2016)Standard Test Method forEvaluation of Wetting Agents by the Skein Test1This standard is issued under the fixed designation D2281; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of la

2、st revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This test method2,3covers the determination of theefficiency of ordinary commercial wetting agents as defined inTerminol

3、ogy D459. This test method is applicable underlimited and controlled conditions, but does not necessarilyyield information correlating with specific end uses.1.2 The values stated in inch-pound units are to be regardedas standard. The values given in parentheses are mathematicalconversions to SI uni

4、ts that are provided for information onlyand are not considered standard.1.3 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine

5、the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:4D459 Terminology Relating to Soaps and Other Detergents3. Summary of Test Method3.1 A weighted cotton test skein is dropped into a tallcylinder containing a wetting agent of known concentrationdissol

6、ved in water. The time required for the cotton skein towet through and sink, relaxing the string stirrup to which it isattached will be recorded as the sinking time. This time relatesto the speed at which the wetting agent works and can be usedto compare agents.4. Apparatus4.1 Hook and Anchor:4.1.1

7、The hook of a standard weight and the attached anchorshall be prepared as follows: Bend a piece of No. 10 B or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the Copyright Clearance Center, 222Rosewood Drive, Danvers, MA 01923, Tel: (978) 646-2600; http:/ 10 (2016)3