ASTM D2260-2003(2013) Standard Tables of Conversion Factors and Equivalent Yarn Numbers Measured in Various Numbering Systems《各种支数标定制中测得对等纱线支数表和换算系数的标准表格》.pdf
《ASTM D2260-2003(2013) Standard Tables of Conversion Factors and Equivalent Yarn Numbers Measured in Various Numbering Systems《各种支数标定制中测得对等纱线支数表和换算系数的标准表格》.pdf》由会员分享,可在线阅读,更多相关《ASTM D2260-2003(2013) Standard Tables of Conversion Factors and Equivalent Yarn Numbers Measured in Various Numbering Systems《各种支数标定制中测得对等纱线支数表和换算系数的标准表格》.pdf(12页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D2260 03 (Reapproved 2013)Standard Tables ofConversion Factors and Equivalent Yarn Numbers Measuredin Various Numbering Systems1This standard is issued under the fixed designation D2260; the number immediately following the designation indicates the year oforiginal adoption or, in the c
2、ase of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 These tables include (1) a series of conversion factorsrequired to convert the number of
3、a yarn measured in a specificsystem to the equivalent number measured in various othersystems (see Table 1), and (2) specific equivalent numbers foryarns measured in various systems (see Table 2).1.2 The content is basically consistent with recommenda-tions of the International Organization for Stan
4、dardization(ISO) Standard 2947.1.3 The values stated in inch-pound units are to be regardedas standard. The values given in parentheses are mathematicalconversions to SI units that are provided for information onlyand are not considered standard.1.4 This standard does not purport to address all of t
5、hesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating
6、to TextilesD4849 Terminology Related to Yarns and FibersSI10 Standard for Use of the International System of Units(SI): The Modern Metric System32.2 ISO Standard:Standard 2947 TextilesIntegrated Conversion Table for Re-placing Traditional Yarn Numbers by Rounded Numbersin the Tex System42.3 NIST Sta
7、ndard:NIST Circular M121, January 193653. Terminology3.1 Refer to Terminology D4849 for definition of thefollowing ters used in this standard: American graincount;cotton count; cut, in asbestos and glass yarns, cut, in woolyarns; denier; direct yarn numbering systems; grain, in yarnspinning; grain,
8、in measuring mass; indirect yarn numberingsystem; linear density; lea, in linen yarns; metric count; run, inthe american woolen system; tex; worsted count; yarn number;and yarn numbering system.3.2 Refer to Terminology D123 for definitions of otherterms used in this standard.4. Conversion Factors fo
9、r Equivalent Yarn Numbers4.1 Calculate any equivalent value using the appropriatefactor listed in Table 1.5. Use of Previously Calculated Equivalent YarnNumbers5.1 For a specific number in a stated system, read theequivalent in the various other systems from Table 2.5.2 With a few exceptions, fracti
10、onal traditional indirectcounts have been omitted from Table 2; the rounded tex systemvalues for most fractional traditional indirect counts can beobtained by interpolation.6. Implementation of the Tex Yarn Numbering System6.1 In Table 2, to encourage the implementation of the texsystem in the Unite
11、d States, rounded tex values were chosen to1These tables are under the jurisdiction of ASTM Committee D13 on Textilesand are the direct responsibility of Subcommittee D13.58 on Yarns and Fibers.Current edition approved July 1, 2013. Published September 2013. Originallyapproved in 1964. Last previous
12、 edition approved in 2009 as D2260 03(2009).DOI: 10.1520/D2260-03R13.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM
13、website.3Excerpts from SI 10, Standard for Use of the International System of Units (SI):The Modern Metric SysteSI10, can be found in the Annual Book of ASTMStandards, Vols 07.01 and 07.02. The standard is available as a separate publicationand appears in its entirety in Vol 14.02.4Available from Am
14、erican National Standards Institute (ANSI), 25 W. 43rd St.,4th Floor, New York, NY 10036, http:/www.ansi.org.5Available from National Institute of Standards and Technology (NIST), 100Bureau Dr., Stop 1070, Gaithersburg, MD 20899-1070, http:/www.nist.gov.Copyright ASTM International, 100 Barr Harbor
15、Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States1accommodate as many yarn numbers as possible for thetraditional yarn numbering systems without encroaching onestablished tolerances. In addition to the rounded tex systemvalues, the decitex (dtex) equivalents have been includedbecau
16、se they can be used throughout most of the count rangewithout employing decimal fractions. The choice of unit isentirely a matter to be determined by each sector of the trade;decitex, for example, is particularly suitable for fine yarns(whether spun or filament) and tex for medium and coarseyarns.7.
17、 Derivation of Data in Table 27.1 Tables 1 and 2 are based on the following exactequivalents:7.1.1 1 yd = 0.9144 m.7.1.2 1 lb = 453.592 37 g.7.1.3 1 lb = 7000 grains.7.2 The following conversion factors have been computedwhere y = yards per pound.7.2.1 Woolen run (wr) = y/1600.7.2.2 cotton count (cc
18、) = y/840.7.2.3 denier (den) = 4 464 492/y.7.2.4 Worsted count (wc) = y/560.7.2.5 American grain count per 120 yd (gr) = 840 000/y.7.2.6 linen lea (lea) = y/300.7.2.7 metric count (mc) = y/496.055.7.2.8 tex (tex) = 496 055/y.7.2.9 For the woolen system, use the column and rowheaded linen lea.7.3 The
19、 data in Table 2 was derived using the NationalInstitute of Standards and Technology values in the NISTCircular M121, January,NIST Circular M121, January193651936. Based on current values, when calculating yards perpound for a specified denier, the table will understate the valueby 12 yd out of 4.5
20、million yd or 11 m out of 4.1 million m.When calculating yards per pound for a specified tex value, thetable will understate the value by 5 yd out of 0.5 million yd or4.6 m out of 0.46 million m. Therefore, those who need moreprecise data for denier and tex should recalculate the dataneeded using th
21、e current values in Table 1.TABLE 1 Conversion Factors for Converting from One Yarn Numbering System to AnotherASystem for Which Yarn Number isNeededSystem for Which Yarn Number is KnownTexBDenierAmericanGrain CountCottonCountWorstedCountWoolen RunMetricCountLinen LeaWoolen CutYd/lbTexB(g/1000 m) te
22、x = .den90.590 541gr590.541cc885.812wc310.034wr1 000mc1 653.52lea496 055yDenier (g/9000 m) den = 9 tex . 5.314 87gr5 314.87cc7 972.31wc2 790.31wr9 000mc14 881.6lea4 464 492yAmerican Grain Count (grains/120 yd) gr =tex0.590 541den5.314 87.1 000cc1 500wc525wr1 693.36mc2 800lea840 000yCotton count (840
23、 yd lengths/lb) cc =590.541tex5 314.87den1 000gr.wc1.5wr0.5250.590 541mclea2.8y840Worsted count (560 yd lengths/lb) wc =885.812tex7 972.31den1 500gr1.5cc .wr0.350.885 812mclea1.866 67y560Woolen run (1600 yd lengths/lb) wr =310.034tex2 790.31den525gr0.525 cc 0.35 wc . 0.310 034mc0.187 5leay1 600Metri
24、c count (1000 m/kg) mc =1 000tex9 000den1 693.36grcc0.590 541wc0.885 812wr0.310 034.lea1.653 52y496.055Linen lea (300 yd lengths/lb) lea =1 653.52tex14 881.6den2 800gr2.8 cc 1.866 67wc0.187 5wr1.653 52mc.y300Yards per pound (yd/lb) y =496 055tex4 464 492den840 000gr840 cc 560 wc 1600 wr 496.055mc300
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD226020032013STANDARDTABLESOFCONVERSIONFACTORSANDEQUIVALENTYARNNUMBERSMEASUREDINVARIOUSNUMBERINGSYSTEMS

链接地址:http://www.mydoc123.com/p-511330.html