ASTM D2260-2003 Standard Tables of Conversion Factors and Equivalent Yarn Numbers Measured in Various Numbering Systems《在各种编号系统中测得的换算系数和相等的纱线支数的标准表》.pdf
《ASTM D2260-2003 Standard Tables of Conversion Factors and Equivalent Yarn Numbers Measured in Various Numbering Systems《在各种编号系统中测得的换算系数和相等的纱线支数的标准表》.pdf》由会员分享,可在线阅读,更多相关《ASTM D2260-2003 Standard Tables of Conversion Factors and Equivalent Yarn Numbers Measured in Various Numbering Systems《在各种编号系统中测得的换算系数和相等的纱线支数的标准表》.pdf(13页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D 2260 03Standard Tables ofConversion Factors and Equivalent Yarn Numbers Measuredin Various Numbering Systems1This standard is issued under the fixed designation D 2260; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision,
2、 the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon (e) indicates an editorial change since the last revision or reapproval.1. Scope1.1 These tables include (1) a series of conversion factorsrequired to convert the number of a yarn measured
3、 in a specificsystem to the equivalent number measured in various othersystems (see Table 1), and (2) specific equivalent numbers foryarns measured in various systems (see Table 2).1.2 The content is basically consistent with recommenda-tions of the International Organization for Standardization(ISO
4、) Standard 2947.2. Referenced Documents2.1 ASTM Standards:D 123 Terminology Relating to Textiles2D 861 Practice for Use of the Tex System to DesignateLinear Density of Fibers, Yarn Intermediates, and Yarns2D 3888 Terminology Related to Open-End Spinning3D 3990 Terminology Relating to Fabric Defects3
5、D 4849 Terminology Relating to Fibers and Yarns3SI 10 Standard for Use of the International System of Units(SI): The Modern Metric System32.2 ISO Standard:ISO 2947, TextilesIntegrated Conversion Table for Replac-ing Traditional Yarn Numbers by Rounded Numbers in theTex System42.3 NIST Standard:NBSM1
6、21January, 193653. Terminology3.1 Refer to Terminology D 4849 for definition of thefollowing ters used in this standard: American graincount;cotton count; cut, in asbestos and glass yarns, cut, in woolyarns; denier; direct yarn numbering systems; grain, in yarnspinning; grain, in measuring mass; ind
7、irect yarn numberingsystem; linear density; lea, in linen yarns; metric count; run, inthe american woolen system; tex; worsted count; yarn number;and yarn numbering system.3.2 Refer to Terminology D 123 for definitions of otherterms used in this standard.4. Conversion Factors for Equivalent Yarn Num
8、bers4.1 Calculate any equivalent value using the appropriatefactor listed in Table 1.5. Use of Previously Calculated Equivalent YarnNumbers5.1 For a specific number in a stated system, read theequivalent in the various other systems from Table 2.5.2 With a few exceptions, fractional traditional indi
9、rectcounts have been omitted from Table 2; the rounded tex systemvalues for most fractional traditional indirect counts can beobtained by interpolation.6. Implementation of the Tex Yarn Numbering System6.1 In Table 2, to encourage the implementation of the texsystem in the United States, rounded tex
10、 values were chosen toaccommodate as many yarn numbers as possible for thetraditional yarn numbering systems without encroaching onestablished tolerances. In addition to the rounded tex systemvalues, the decitex (dtex) equivalents have been includedbecause they can be used throughout most of the cou
11、nt rangewithout employing decimal fractions. The choice of unit isentirely a matter to be determined by each sector of the trade;decitex, for example, is particularly suitable for fine yarns(whether spun or filament) and tex for medium and coarseyarns.1These tables are under the jurisdiction of ASTM
12、 Committee D13 on Textilesand are the direct responsibility of Subcommittee D13.58 on Yarn and Fiber TestMethods.Current edition approved Feb. 10, 2003. Published April 2003. Originallyapproved in 1964. Last previous edition approved in 2002 as D2260 02.2Annual Book of ASTM Standards, Vol 07.01.3Exc
13、erpts from SI 10, Standard for Use of the International System of Units (SI):The Modern Metric Syste, can be found in the Annual Book of ASTM Standards,Vols 07.01 and 07.02. The standard is available as a separate publication and appearsin its entirety in Vol 14.02.4American National Standards Insti
14、tute, 11 West 42nd Street, 13th Floor, NewYork, NY 10036.5Available from National Institute of Standards and Technology, Gaithersburg,MD 20899.1Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959, United States.7. Derivation of Data in Table 27.1 Tables
15、 1 and 2 are based on the following exactequivalents:7.1.1 1 yd = 0.9144 m.7.1.2 1 lb = 453.592 37 g.7.1.3 1 lb = 7000 grains.7.2 The following conversion factors have been computedwhere y = yards per pound.7.2.1 Woolen run (wr) = y/1600.7.2.2 cotton count (cc) = y/840.7.2.3 denier (den) = 4 464 492
16、/y.7.2.4 Worsted count (wc) = y/560.7.2.5 American grain count per 120 yd (gr) = 840 000/y.7.2.6 linen lea (lea) = y/300.7.2.7 metric count (mc) = y/496.055.7.2.8 tex (tex) = 496 055/y.7.2.9 For the woolen system, use the column and rowheaded linen lea.7.3 The data in Table 2 was derived using the N
17、ationalInstitute of Standards and Technology values in the NISTCircular M121, January, 1936. Based on current values, whencalculating yards per pound for a specified denier, the table willunderstate the value by 12 yd out of 4.5 million yd or 11 m outof 4.1 million m. When calculating yards per poun
18、d for aspecified tex value, the table will understate the value by 5 ydout of 0.5 million yd or 4.6 m out of 0.46 million m. Therefore,those who need more precise data for denier and tex shouldrecalculate the data needed using the current values in Table 1.8. Keywords8.1 yarn number; yarns per pound
19、TABLE 2 Equivalent Yarn Number Conversion TableNOTE 1In any row with a boldface type number, the other equivalents are computed from the boldface value to the nearest four significant figures.ExactEquivalentyd/lb forRounded Tex-ValueACottonCountIndirect Systems Direct SystemsDeviationBWorstedCountWo
20、olenRunLinenWoolenCutMetricCountAmericanGrain CountDenierRoundedValueRoundedValuedtex yd/lb cc wc wr lea mc gr den tex dtex %1.111 4 465 000CC C C C0.188 1.00 0.11 1.1 1.01.333 1.2 0.13 1.3 2.51.444CC C C C1.3 0.14 1.4 3.11.667 1.5 0.17 1.7 +2.01.889CC C C C1.7 0.19 1.9 +0.62.000 2 232 000CC C C C1.
21、8 0.20 2.0 0.02.222 0.376 2.00 0.22 2.2 1.02.444CC C C C2.2 0.24 2.4 1.82.556 2.3 0.26 2.6 +1.7TABLE 1 Conversion Factors for Converting from One Yarn Numbering System to AnotherASystem for Which Yarn Number isNeededSystem for Which Yarn Number is KnownTexBDenierAmericanGrain CountCottonCountWorsted
22、CountWoolen RunMetricCountLinen LeaWoolen CutYd/lbTexB(g/1000 m) tex = . den90.590 5413 gr590.541cc885.812wc310.034wr1 000mc1 653.52lea496 055yDenier (g/9000 m) den = 9 3 tex . 5.314 873 gr5 314.87cc7 972.31wc2 790.31wr9 000mc14 881.6lea4 464 492yAmerican Grain Count (grains/120 yd) gr = tex0.590 54
23、1den5.314 87. 1 000cc1 500wc525wr1 693.36mc2 800lea840 000yCotton count (840 yd lengths/lb) cc = 590.541tex5 314.87den1 000gr. wc1.5wr0.5250.590 5413 mclea2.8y840Worsted count (560 yd lengths/lb) wc = 885.812tex7 972.31den1 500gr1.5 3 cc . wr0.350.885 8123mclea1.866 67y560Woolen run (1600 yd lengths
24、/lb) wr = 310.034tex2 790.31den525gr0.525 3 cc 0.35 3 wc . 0.310 0343 mc0.187 53leay1 600Metric count (1000 m/kg) mc = 1 000tex9 000den1 693.36grcc0.590 541wc0.885 812wr0.310 034. lea1.653 52y496.055Linen lea (300 yd lengths/lb) lea = 1 653.52tex14 881.6den2 800gr2.8 3 cc 1.866 673 wc0.187 53 wr1.65
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD22602003STANDARDTABLESOFCONVERSIONFACTORSANDEQUIVALENTYARNNUMBERSMEASUREDINVARIOUSNUMBERINGSYSTEMS

链接地址:http://www.mydoc123.com/p-511328.html