ARMY MIL-STD-814 D-1997 REQUIREMENTS FOR TIEDOWN SUSPENSION AND EXTRACTION PROVISIONS ON MILITARY MATERIAL FOR AIRDROP《拴紧 检测和提取条款空降军用材料的要求》.pdf
《ARMY MIL-STD-814 D-1997 REQUIREMENTS FOR TIEDOWN SUSPENSION AND EXTRACTION PROVISIONS ON MILITARY MATERIAL FOR AIRDROP《拴紧 检测和提取条款空降军用材料的要求》.pdf》由会员分享,可在线阅读,更多相关《ARMY MIL-STD-814 D-1997 REQUIREMENTS FOR TIEDOWN SUSPENSION AND EXTRACTION PROVISIONS ON MILITARY MATERIAL FOR AIRDROP《拴紧 检测和提取条款空降军用材料的要求》.pdf(24页珍藏版)》请在麦多课文档分享上搜索。
1、“o“A.MSCN/AMIL-STD-814D?Fbmw 997S;ER:EDINGMIL-STD-814C23 February 1993DEPARTMENT OF DEFENSEINTERFACE STANDARDREQUIREMENTS FORTIEDOWN, SUSPENSION AND EXTRACTION PROVISIONSON MILITARY MATERIEL FOR AIRDROP“of-,_#r177 the parachute must not weigh more than2200 pounds,3.4 Desien limit load. The applied f
2、orce, or maximum probable force, times a safety factorthat a suspensio extraction, or tie-down provision, including its connecting strocturaJ members,can withstand when subjected to its most severe airdrop environment. This load must be less thanthe yield load.3.5 Extraction movision. An integral fi
3、tting on the item for attaching the extraction system.3.6 Errtraction svstem. A system used to withdraw airdrop items from aircraft in flight1Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MfL-STD-814D3.7 Gross rimed weidt. The airdrop weight plus t
4、he weight of all airdrop rigging. ForLVAD the gross weight= approximately 1600 pounds+ 1.18X airdrop weight.3.8 Item extraction. The extraction system is attached to the airdrop item. The item must beequipped with extraction provisions.3.9 Low velocitv airdrou d.-The dsi hit load shall not be less t
5、h 1.35 times theworking load.APPROXIMATEAIRDROPWEIGHT (LBS) G “G X TOTAL SUSPENDED WEIGHT= WORKING LOADup to 5000 3.505001-21,200 3.0021,201 and above 2.505.2.3 Ultimate strermth. The ultimate strength of each suspension provision shall be a minimumof 1.5 times the working load.5.2.4 Number and loca
6、tion. Four suspension provisions shall be provided for each airdrop item.Suspension twovisions shall be attached in r.rairsso that each Dair shall be suaced at WUSIdktarrcee the horizontalpkme passing through the CG of the airdrop item at a height such that the interference betweensuspension slings
7、and the item is minimized. Each suspension provision of a forward or an aft pairshall be located on the same horizontal plane, at equal distance from the longitudinal axis and on thesame lateral axis (see Figure 5).5Provided by IHSNot for ResaleNo reproduction or networking permitted without license
8、 from IHS-,-,-MI.L-STD-814DThe spacing of the suspension provisions shall be within the foUowing limits:(a) lateral spacing of at least one pair minimum four feet.(b) longitudinal: minimum !4 the length of the airdrop item;maximum 3 X (lateral spacing) or 20 feet, whichever is shorter.Airdrop items
9、smaUerthan the minimum spacing shsUhave the suspension provisions located atthe outer edge of the item. It is desired that the provisions be located as far apart as possible withinthe above limits.The plane of the suspension eye shaUbe in the Iongitudmrd vertical plane of the load or itsaPPro*ate al
10、ignment with the anticipated angle of the sling leg.The use of a spreader bar is not authorized. Parts of the airdrop item in contact with thesuspension slings shaUbe strong enough to withstand the resulting forces and shaUnot have anysharp edges.NOTE: Some special iterns maybe airdropped without su
11、spension provisions by usirrgplatform suspension. For information contact U.S. Army Natick RescarcDevelopment and Engineering Center, Kansas Street, Natic MA 01760-5017.5.3 Extraction provisions. These provisions are applicable if platforms are not available forextraction.5.3.1 Use of existinsrcompo
12、nents. Standard vehicle pintles, suspension provisions, tow barattachments, etc., may be used as extraction provisions if they meet the detailed requirements. Non-welded attachment of the extraction provision to the item is preferred.5.3.2 Low velocitv airdrorI (LVAD). A single airdrop extraction pr
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ARMYMILSTD814D1997REQUIREMENTSFORTIEDOWNSUSPENSIONANDEXTRACTIONPROVISIONSONMILITARYMATERIALFORAIRDROP

链接地址:http://www.mydoc123.com/p-448421.html