AECMA PREN 3003-2002 Aerospace series Non-Metallic materials Structural adhesives Determination of mass per unit area of film adhesives Test method Edition P 1《航空航天系列非金属物质粘合剂每单位胶膜黏.pdf

《AECMA PREN 3003-2002 Aerospace series Non-Metallic materials Structural adhesives Determination of mass per unit area of film adhesives Test method Edition P 1《航空航天系列非金属物质粘合剂每单位胶膜黏.pdf》由会员分享，可在线阅读，更多相关《AECMA PREN 3003-2002 Aerospace series Non-Metallic materials Structural adhesives Determination of mass per unit area of film adhesives Test method Edition P 1《航空航天系列非金属物质粘合剂每单位胶膜黏.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、AECMA STANDARD prEN 3003 NORME AECMA Edition P 1 AECMA NORM December 2002 k%? Guiledeile 94 - 6-1200 Brussels - Tel. + 32 2 775 81 10 - Fax. + 32 2 775 81 11 - www.aecma-stan.org PUBLISHED BY THE EUROPEAN ASSOCIATION OF AEROSPACE INDUSTRIES - STANDARDIZATION Edition approved for publication 31 Decem

2、ber 2002 ICs: Comments should be sent within six months after the date of publication to Material Domain AECMA-STAN Descriptors: ENGLISH VERSION Aerospace series Non-metallic materials Structural adhesives Determination of mass per unit area of film adhesives Test method Srie arospatiale Luft- und R

3、aumfahrt Matriaux non-mtalliques Nichtmetallische Werkstoffe Adhsifs structuraux Strukturelle Klebstoffe de film adhsif von Klebfolie Mthode dessai Prfverfahren Dtermination de la masse par unit de surface Bestimmung der flchenbezogenen Masse This “Aerospace Series“ Prestandard ,as been drawn up und

4、er the responsibility of AECMA-STAN (The European Association of Aerospace Industries - Standardization). It is published on green paper for the needs of the European Aerospace Industry. It has been technically approved by the experts of the concerned Domain following member comments. Subsequent to

5、the publication of this Prestandard, the technical content shall not be changed to an extent that interchangeability is affected, physically or functionally, without re-identification of the standard. After examination and review by users and formal agreement of AECMA-STAN it will be submitted as a

6、draft European Standard to CEN (European Committee for Standardization) for formal vote. Standard to be used: EN 2557 Copyright Association Europeene des Constructeurs de Materiel Aerospatial Provided by IHS under license with AECMANot for ResaleNo reproduction or networking permitted without license from IHS-,-,-