NAVY MIL-STD-1323-387-1992 UNIT LOAD FOR UNDERWAY REPLENISHMENT BOMB 2000 LB BLU-109-A B (THERMALLY PROTECTED) IN PALLET BOMB S S MHU-212 E (DWG《S S MHU-212 E(DWG # 3336AS100)炸弹货盘热.pdf

《NAVY MIL-STD-1323-387-1992 UNIT LOAD FOR UNDERWAY REPLENISHMENT BOMB 2000 LB BLU-109-A B (THERMALLY PROTECTED) IN PALLET BOMB S S MHU-212 E (DWG《S S MHU-212 E(DWG # 3336AS100)炸弹货盘热.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-STD-1323-387-1992 UNIT LOAD FOR UNDERWAY REPLENISHMENT BOMB 2000 LB BLU-109-A B (THERMALLY PROTECTED) IN PALLET BOMB S S MHU-212 E (DWG《S S MHU-212 E(DWG # 3336AS100)炸弹货盘热.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-STD-1323 -387 9 9999911 0435009 902 TDA SYSCOM DATE REV LTR APPROVAL REV IS ION DESCR IPTION MIL-STD-1323-387 NAWI MILITARY STANDARD 25 NOVEMBER 1992 UNIT LOAD FOR UNDERWAY REPLENISHMENT STANDARDS. REFER TO INDEX TO STANDARDS, MIL -HDBK-236 (NAVY). I FSC 814 BOMB, 2000 LB. BLU-109-A/B (THERMALLY

2、 PROTECTED) IN PALLET, BOMB, S/S, MHU-ZlZ/E / (DWG # 3336AS100) _IT LOAD DATA NUMBER OF BOMBS/UNIT LOAD -2 GROSS WEIGHT OF ONE BOMBp1,988 LBS GROSS WEIGHT OF TOP FRAME -123 LBS GROSS WEIGHT OF BOTrOM FRAME-217 LBS WEIGHT OF STEEL STRAPPING -5 LBS GROSS WEIGHT OF UNIT LOAD / 4,321 LBS A 47 63 CU FT C

3、UBE DO NOT USE FOR SHIPPING WEIGHT DO NOT STACK MORE THAN 6 UNIT LOADS HIGH IN STORAGE HEIGHT , - N/A THIS UNIT LOAD IS AUTHORIZED AND RELEASED FOR SHIPPING. HANDLING, STORAGE AND TRANSFER-AT-SEA. IT MAY ALSO BE USED FOR DOMESTIC SHIPMENT IN COMPLIANCE WITH DOT REGULATIONS. SIGNATYQ! ,/ TDA. WPNSTA

4、EARLE OATE REQUIREMENTS FOR CONSTRUCTION OF THIS UNIT LOAD SHALL CONSIST OF THIS DOCUMENT AND THE LATEST ISSUE OF MIL-STD-1323 NAWI. ; 1 ., 7. L-L c, L /th - ,- QAT I/ I ORIGINATOR WPNSTA EARLE. NEW JERSEY ln Provided by IHSNot for ResaleNo reproduction or networking permitted without license from I

5、HS-,-,-MIL-STD-1323-387 (NAVY) PALLETIZING PROCEDURE (A) (6) THREAD LONGITUDINAL STRAPPING, ITEM 3, THROUGH SLOTS IN BOTrOM FRAME, ITEM i, AS SHOWN IN VIEW A-A PRE-POSITION TWO BOMBS WITH THEIR SUSPENSION LUGS OUTBOARD IN THE FIVE OCLOCK AND SEVEN OCLOCK POSITIONS AND PLACE IN BOTOM FRAME, ITEM 1, A

6、S SHOWN IN SECTION 6-6 AND THEIR AFT ENDS SNUG AGAINST THE AFT RIM OF THE FRAME AS SHOWN IN VIEW C-C. POSITION THE TOP FRAME, ITEM 2, OVER THE BOMBS WITH THE AFT RIM SNUG AGAINST THE AFT END OF THE BOMBS AS SHOWN IN VIEW C-C. POSITION LATERAL STRAPPING, ITEM 4, UNDER THE UNIT LOAD AND OVER THE TOP F

7、RAME IN POSITIONS SHOWN. TENSION AND DOUBLE NOTCH SEALS, ITEM 5. POSITION LONGITUDINAL STRAPPING, ITEM 3, OVER THE TOP FRAME (C) (0) E) TENSION AND DOUBLE NOTCH SEAL, ITEM 5 MARKING IN ADDITION TO ANY SPECIAL MARKING REQUIRED BY CONTRACT OR ORDER, THE UNIT LOAD SHALL BE MARKED IN ACCORDANCE WITH MIL

8、-STD-129. STACKING HEIGHT UNLESS OTHERWISE SPECIFIED, ALL MATERIALS SHALL BE IN ACCORDANCE WITH MIL-STD-1323 (NAVY). DEPALLETIZING PROCEDURE 1 CUT AND REMOVE STRAPPING. 2. REMOVE TOP FRAME. 3 REMOVE BOMBS Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,

9、-,-MIL-STD-1323 -387 9999933 0435011 560 MI L-STD- 1323 -387 (NAVY 1 )y=- / 1 REF.RUN STRAPPING THROUGH SLOT (3) PL VIEW A-A / i / SECTION B-B ROTATED 30C C 0 REF VIEW C-C ROTATED 30C C PREPARING ACTIVITY NAVY-OS (PROJECT NO 8140-N1041) PAGE 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-