NAVY MIL-C-6781 B (2)-1999 CONTROL PANEL AIRCRAFT EQUIPMENT RACK OR CONSOLE MOUNTED《机架或控制台架设飞机设备控制面板》.pdf

《NAVY MIL-C-6781 B (2)-1999 CONTROL PANEL AIRCRAFT EQUIPMENT RACK OR CONSOLE MOUNTED《机架或控制台架设飞机设备控制面板》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-C-6781 B (2)-1999 CONTROL PANEL AIRCRAFT EQUIPMENT RACK OR CONSOLE MOUNTED《机架或控制台架设飞机设备控制面板》.pdf（4页珍藏版）》请在麦多课文档分享上搜索。

1、MILITARY SPECIFICATIONCONTROL PANEL: AIRCRAFT EQUIPMENT, RACK OR CONSOLE MOUNTEDThis amendment forms a part of MIL-C-6781B, dated 13 September 1960, and is approvedfor use by all Departments and Agencies of the Department of Defense.PAGE 1Delete “(ASG)” on this page and on every page where it appear

2、s.2.1: Under SPECIFICATIONS MILITARY, delete the followingMIL-E-5272 Environmental Testi ng, Aeronautical and Associated Equipment,General Specification forMIL-E-5556 Enamel, Camouflage, Quick DryingMIL-E-5557 Enamel, Heat-Resisting, Glyceryl-Phthalate, BlackMIL-P-8585 Primer Coating, Zinc Chromate,

3、 Low-Moisture-SensitivityUnd er SPECIFICATIONS MILITARY, change the following specification titles to:MIL-E-5400 Electronic Equipment, Airborne, General Specification forMIL-P-7788 Panel, Information, Integrally IlluminatedMIL-E-17555 Electronic and Electrical Equipment Accessories, and Repair Parts

4、,Packaging and Packing of* Add to bottom of page 1:AMSC N/A 1 of 4 FSC 1680DISTRIBUTION STATEMENT A . Approved for public release; distribution is unlimited.INCH-POUNDMIL-C-6781BAMENDMENT 215 December 1999SUPERSEDINGAMENDMENT 124 May 1979Beneficial comments (recommendations, additions, deletions) an

5、d any pertinent data whichmay be of use in improving this document should be addressed to : Commander, Naval AirWarfare Center Aircraft Division, Code 414100B120-3, Highway 547, Lakehurst, NJ 08733-5100, by using the Standardization Document Improvement Proposal (DD Form 1426)appearing at the end of

6、 this document or by letter.Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-6781BAMENDMENT 22PAGE 22.1: SPECIFICATIONS MILITARY, add the following:MIL-C-81774 Control Panel, Aircraft, General Requirements forUnder SPECIFICATIONS MILITARY, chang

7、e the following specification titles to:MIL-M-18012 Markings for Aircrew Station Displays, Design and ConfigurationofMIL-C-26482 Connector, Electric, (Circular, Miniature, Quick Disconnect,Environment Resisting) Receptacles and Plugs, GeneralSpecifications forUnder SPECIFICATIONS FEDERAL, add the fo

8、llowing:TT-E-489 Enamel, Alkyd, Gloss (for Exterior and Interior Surfaces)TT-E-527 Enamel, Alkyd, Lusterless* Under SPECIFICATIONS FEDERAL, add the following:TT-P-1757 Primer Coating, Alkyd Base, One ComponentUnder STANDARDS MILITARY, add the following:MIL-STD-810 Environmental Test MethodsMIL-STD-1

9、472 Human Engineering Design Criteria for Military SystemsEquipment and FacilitiesMS 25453 Lights, Panel Information P late, Plate Supporting TypeMS 33742 Shaft, Control KnobUnder STANDARDS MILITARY, delete the following:MS 25010 Light, Panel, Plastic Plate LightingMS 25176 Shaft, Control KnobUnder

10、Standards Air Force-Navy Aeronautical, delete the fo llowing:AN3502 Light Assembly-Control Panel, Plastic Lighting Panel3.2.1: Line 4, delete “built-in-lighting,” and substitute “integrally illuminated.”Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,

11、-MIL-C-6781BAMENDMENT 23PAGE 33.2.3: Line 6, add the following sentence “Controls shall comply with MIL-STD-1472 a ndMIL-C-81774.”3.3.4: Delete paragraph title and substitute “ Information panel .” Line 4 , delete “plasticlighting plate” and substitute “information panel.”3.3.5: Delete in its entire

12、ty and substitute the following paragraph:“3.3.5 Light assembly . Light assemblies, if employed, shall be in accordance with therequirements for Type V panels of specification MIL-P-7788.”PAGE 43.5, lines 8, 13, and 14 : Delete “plastic lighting plate” and substitute “information panel.”Line 15 , de

13、lete “plastic plate” and substitute “information panel.”PAGE 53.7: Delete “MIL-C-18012” and substitute “MIL-M-18012.”3.7.1: Delete “MS25176 and substitute “MS33742.” Line 4 , delete “plastic lighting plate”and substitute “information panel.”PAGE 73.16: Delete “MIL-E-5557” and substitute “TT-E-489.”

14、Delete “MIL-E-5556” andsubstitute “TT-E-527.” Line 2 , delete “plastic lighting plate” and substitute “information panel.”* 3.16: Delete “MIL-P-8585” and substitute “TT-P-1757.”PAGE 84.1: Lin e 3, delete “plastic lighting” and substitute “information panel.”4.2.1: Delete paragraph in its entirety an

15、d substitute:“4.2.1 Environmental tests . The control panel shall be tested for conformance withthe following tests of MIL-STD-810:T emperature-Altitude Test Method No. 504Vibration Test Method No. 514.1Shock Test Method No. 516.1Humidity Test Method No. 507Provided by IHSNot for ResaleNo reproducti

16、on or networking permitted without license from IHS-,-,-MIL-C-6781BAMENDMENT 24Salt Spray Test Method No. 509Explosion Test Method No. 511Sand and Dust Test Method No. 510Fungu s Resistance Test Method No. 508”NOTE: The margins of this amendment are marked with asterisks to indicate where changesfro

17、m the previous amendment were made. This was done as a convenience only and theGovernment assumes no liability whatsoever for any inaccuracies in these notations. Biddersand contractors are cautioned to evaluate the requirements of this document based on the entirecontent irrespective of the marginal notations and relationship to the last previous amendment.Custodians: Preparing activity:Army AV Navy ASNavy ASAir Force 11 (Project 1680-0833)Review activity:Air Force 99Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-