FORD WSS-M1H1086-A-2016 FABRIC SAGRES PATTERN WOVEN JACQUARD TO BE USED WITH FORD WSS-M99P1111-A .pdf

《FORD WSS-M1H1086-A-2016 FABRIC SAGRES PATTERN WOVEN JACQUARD TO BE USED WITH FORD WSS-M99P1111-A .pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M1H1086-A-2016 FABRIC SAGRES PATTERN WOVEN JACQUARD TO BE USED WITH FORD WSS-M99P1111-A .pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions 2016 05 05 N Status No longer used D. Murtonen, NA 2006 06 12 Activated L. Neves Copyright 2016, Ford Global Technologies, LLC Page 1 of 2 FABRIC, SAGRES PATTERN, WOVEN JACQUARD WSS-M1H1086-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The materia

2、l defined by this specification is a woven jacquard polyester fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for BV 226 - 2008 Model Year Low Series. 3. REQUIREMENTS Material specification requirements are to be used for initial qualifi

3、cation of materials. In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements for Productio

4、n Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, range (ASTM D 3775) Warp 27 - 29 yarn/cm Fill 18 - 20 yarn/cm 3.2.2 Fabric Weight, range (FLTM BN 106-01) Seat (laminated to 4 mm foam + backing fabric) 360 - 450 g/m 3.3 COMPOSITION (ASTM D 629) Fabric 100% Polyester Foam PUR

5、/Polyether Backing Fabric 100% Polyamide ENGINEERING MATERIAL SPECIFICATION WSS-M1H1086-A Copyright 2016, Ford Global Technologies, LLC Page 2 of 2 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 384 dtex, f 96, Semi Dull, Round, Textured Polyester Fill 570 dtex, f 144, Semi Dull, Round, Air Textured Polye

6、ster 3.5 METHOD OF DYEING Warp Solution Dyed Fill Yarn Dyed 3.6 FINISHING OPERATIONS Heat Set 3.7 THICKNESS, mm, range (ASTM D 1777) Seat (laminated to 4 mm foam + backing fabric) 2.0 3.15 mm 3.8 TRIMMABILITY PROPERTIES 3.8.1 Stretch, %, range (SAE J855) Seat and Door Panel Warp 2.0 6.0% Fill 1.5 4.

7、0% 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that material defined in this specification and shipped to anyone assembly plant will be produced by one supplier only.