IEEE 650-2017 en Qualification of Class 1E Static Battery Chargers Inverters and Uninterruptible Power Supply Systems for Nuclear Power Generating Stations.pdf

《IEEE 650-2017 en Qualification of Class 1E Static Battery Chargers Inverters and Uninterruptible Power Supply Systems for Nuclear Power Generating Stations.pdf》由会员分享，可在线阅读，更多相关《IEEE 650-2017 en Qualification of Class 1E Static Battery Chargers Inverters and Uninterruptible Power Supply Systems for Nuclear Power Generating Stations.pdf（61页珍藏版）》请在麦多课文档分享上搜索。

1、IEEE Standard for Qualification of Class 1E Static Battery Chargers, Inverters, and Uninterruptible Power Supply Systems for Nuclear Power Generating StationsIEEE Std 650-2017(Revision of IEEE Std 650-2006)IEEE Power and Energy SocietySponsored by the Nuclear Power Engineering CommitteeIEEE3 Park Av

2、enueNew York, NY 10016-5997USAIEEE Std 650-2017 (Revision of IEEE Std 650-2006) IEEE Standard for Qualification of Class 1E Static Battery Chargers, Inverters, and Uninterruptible Power Supply Systems for Nuclear Power Generating Stations Sponsor Nuclear Power Engineering Committee of the IEEE Power

3、 and Energy Society Approved 6 December 2017 IEEE-SA Standards Board 2 Copyright 2018 IEEE. All rights reserved. Abstract: Methods for qualifying static battery chargers, inverters and uninterruptible power supply (UPS) systems for Class 1E installations outside containment in nuclear power generati

4、ng stations are described in this standard. Similar electronic equipment for use in applications outside containment, where specific standards for such equipment are not available, may also be qualified using these methods. A combination of type testing and analysis, the latter including a justifica

5、tion of methods, theories, and assumptions used, are employed in the qualification methods set forth. Requirements of IEC/IEEE 60780-323 are met by these procedures. Keywords: battery charger, IEEE 650, inverter, qualification, uninterruptible power supply (UPS) systems The Institute of Electrical a

6、nd Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2018 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 28 February 2018. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness

7、 for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IE

8、EE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is ap

9、proved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or

10、 entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice

11、of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA,

12、 OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE

13、 AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. 4 Copyright 2018 IEEE. All rights reserved. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE shoul

14、d be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be consi

15、dered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal po

16、sition of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for chang

17、es in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. F

18、or this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests

19、. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of

20、IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable re

21、gulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copy

22、right laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these

23、documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. 5 Copyright 2018 IEEE. All rights reserved. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to

24、 photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permiss

25、ion to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of

26、 new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subje

27、cted to review at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine th

28、at they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Xplore at http:/ieeexplore.ieee.org/ or contact IEEE at the address li

29、sted previously. For more information about the IEEE-SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/i

30、ndex.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to

31、 the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Lett

32、ers of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such license

33、s. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any

34、 licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringem

35、ent of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2018 IEEE. All rights reserved. 6 Participants At the time this IEEE standard was completed, the working group on static battery chargers, inverters, and UPS s

36、ystems (SC2.13) had the following membership: Dennis E. Dellinger, Chair Suresh Channarasappa, Co ChairGert Andersen John H. Bickel Kenneth Caldwell William Gunther Zaccaria Koita Thomas Koshy Michael May Edward Mohtashemi Tania Martinez-Navedo Haissam Nasrat Sheila Ray Thomas Stomberski At the time

37、 this IEEE standard was completed, the Subcommittee 2 on Qualification had the following membership: Ed Mohtashemi, Chair Jonathan Cornelius, Vice Chair Marie Nemier, Secretary Chris Abernathy Saleem Akhtar Steve Benson David Breeding Thomas Brewington Steve Casadevall Suresh Channarasappa James Dea

38、n Dennis E. Dellinger Yikang Dou Mike Dougherty Yasutaka Eguchi Gary Elam Robert Francis James F. Gleason Patrick Gleason Dirk-Christian Hopp Ken Kettle Robert Konnik Thomas Koshy Serena Krause Cory Laudenslager Bruce Lory Ikeda Masaaki Daniel Mikow Asif Mohiuddin Jeffrey Mulvehill Rie Nakamura Toma

39、s Nalsen Bill Newell James Parello Janez Pavsek Jan Pirrong Robert Queenan Eric Rasmussen Sheila Ray Kjell Spang Rebecca Steinman Marek Tengler Ying Wang John White Richard Wood At the time this standard was completed, the Nuclear Power Engineering Committee had the following membership: Thomas Kosh

40、y, Chair Daryl Harmon, Vice Chair John White, Secretary Satish Aggarwal Ijaz Ahmad George Attarian George A. Ballassi Farouk D. Baxter* Royce Beacom Mark D. Bowman Daniel F. Brosnan Nissen M. Burstein Keith Bush Robert C. Carruth John P. Carter Suresh Channarasappa Dennis E. Dellinger David R. Desau

41、lniers John Disosway Walter F. Emerson Stephen Fleger Robert J. Fletcher Robert Francis Robert B. Fuld David Gladey James F. Gleason Dale T. Goodney Robert Hall Kuljit Hara Dirk C. Hopp David A. Horvath Paul R. Johnson Christopher J. Kerr Bok-Ryul Kim James K. Liming Bruce A. Lord John D. Macdonald

42、J. Scott Malcolm Alexander Marion* Michael H. Miller Edward R. Mohtashemi Yasushi Nakagawa Copyright 2018 IEEE. All rights reserved. vii Dheya Al-Othmany James Parello Julius Persensky* Ted Riccio Mark F. Santschi Glen E. Schinzel Zdenko Simic James E. Stoner, Jr.* Marek Tengler James E. Thomas Masa

43、fumi Utsumi Michael Waterman Edward Wenzinger Paul L. Yanosy, Sr. Won Young Yun David J. Zaprazny Oon-Pyo Zhu *Non-voting member The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. William Ackerman Sat

44、ish Aggarwal George A. Ballassi Robert Beavers John H. Bickel Thomas Brewington Demetrio Bucaneg, Jr. Nissen M. Burstein Robert C. Carruth Suresh Channarasappa Ashley Chappell Dennis E. Dellinger John Disosway Wells Fargo Kevin Fellhoelter Stephen Fleger Randall Groves Daryl Harmon Hamidreza Heidari

45、safa Werner Hoelzl Peter Kelly Yuri Khersonsky Chad Kiger Robert Konnik Thomas Koshy Jose Marrero Michael May Edward R. Mohtashemi Haissam Nasrat James Parello Bansi Patel Jan Pirrong Fredrick Roy Hugo Ricardo Sanchez Reategui Rebecca Steinman John Stevens Thomas Stomberski John Vergis Kenneth White

46、 Hughes Wike When the IEEE-SA Standards Board approved this standard on 6 December 2017, it had the following membership: Jean-Philippe Faure, Chair Gary Hoffman, Vice Chair John D. Kulick, Past Chair Konstantinos Karachalios, Secretary Chuck Adams Masayuki Ariyoshi Ted Burse Stephen Dukes Doug Edwa

47、rds J. Travis Griffith Michael Janezic Thomas Koshy Joseph L. Koepfinger* Kevin Lu Daleep Mohla Damir Novosel Ronald C. Petersen Annette D. Reilly Robby Robson Dorothy Stanley Adrian Stephens Mehmet Ulema Phil Wennblom Howard Wolfman Yu Yuan *Member Emeritus Copyright 2018 IEEE. All rights reserved.

48、 viii Introduction This introduction is not part of IEEE Std 650-2017, IEEE Standard for Qualification of Class 1E Static Battery Chargers, Inverters, and Uninterruptible Power Supply Systems for Nuclear Power Generating Stations. This standard provides the methods of qualifying Class 1E static batt

49、ery chargers, inverters, and uninterruptible power supply (UPS) systems in accordance with IEC/IEEE 60780-323. The static battery chargers, inverters, and UPS systems discussed in this standard are Class 1E. This document, however, addresses this equipment only as a subsystem in the safety-related electrical system. The techniques and information contained in this standard may be applied to other similar electronic equipment. The reliability analysis requirements of IEEE Std 577 and the methods described in IEEE Std 352 have been used along with statistical data. The s