UL 60950-22 (ND)-2007 National Differences For UL 60950-22 Information Technology Equipment - Safety - Part 22 Equipment to be Installed Outdoors (First Edition)《UL 60950-22信息技术设备的.pdf

《UL 60950-22 (ND)-2007 National Differences For UL 60950-22 Information Technology Equipment - Safety - Part 22 Equipment to be Installed Outdoors (First Edition)《UL 60950-22信息技术设备的.pdf》由会员分享，可在线阅读，更多相关《UL 60950-22 (ND)-2007 National Differences For UL 60950-22 Information Technology Equipment - Safety - Part 22 Equipment to be Installed Outdoors (First Edition)《UL 60950-22信息技术设备的.pdf（8页珍藏版）》请在麦多课文档分享上搜索。

1、 National Differences For UL 60950-22 Information Technology Equipment - Safety - Part 22: Equipment to be Installed Outdoors 2 NATIONAL DIFFERENCES FOR UL 60950-22 APRIL 23, 2007 _ Underwriters Laboratories Inc. National Differences For UL 60950-22 Information Technology Equipment - Safety - Part 2

2、2: Equipment to be Installed Outdoors Edition: 1 Edition Date: April 23, 2007 This is the publication of the first edition of UL 60950-22 which includes the adoption of the UL national differences to IEC 60950-22. This document provides a single listing of the National Differences included in the UL

3、 adoption of the corresponding IEC standard. Editorial differences appearing in the UL standard are not included in this technical compilation. The complete listing of National Differences is available in the UL standard. The master for this standards document at ULs Northbrook Office is the officia

4、l standards document insofar as it relates to a UL service and the compliance of a product with respect to the requirements for that product and service, or if there are questions regarding the accuracy of this document. ULs standards documents are copyrighted by UL. Neither a printed copy of a stan

5、dards document, nor the electronic file for a standards document should be altered in any way. All of ULs standards documents and all copyrights, ownerships, and rights regarding those standards documents shall remain the sole and exclusive property of UL. All rights reserved. No part of this standa

6、rds document may be reproduced, stored in a retrieval system, or transmitted in any form by any means, electronic, mechanical photocopying, recording, or otherwise without prior permission of UL. UL provides this standards document “as is“ without warranty of any kind, either expressed or implied, i

7、ncluding but not limited to, the implied warranties of merchantability or fitness for any purpose. In no event will UL be liable for any special, incidental, consequential, indirect or similar damages, including loss of profits, lost savings, loss of data, or any other damages arising out of the use

8、 of or the inability to use this standards document, even if UL or an authorized UL representative has been advised of the possibility of such damage. In no event shall ULs liability for any damage ever exceed the price paid for this standards document, regardless of the form of the claim. UL reserv

9、es the right to change the format, presentation, file types and formats, delivery methods and formats, and the like of both its printed and electronic Standards documents without prior notice. 3 NATIONAL DIFFERENCES FOR UL 60950-22 APRIL 23, 2007 _ Underwriters Laboratories Inc. Purchasers of the el

10、ectronic versions of ULs standards documents agree to defend, indemnify, and hold UL harmless from and against any loss, expense, liability, damage, claim, or judgement (including reasonable attorneys fees) resulting from any error or deviation introduced while purchaser is storing an electronic sta

11、ndards document on the purchasers computer system. If a single-user version electronic standards document was purchased, one copy of this standards document may be stored on the hard disk of a single personal computer, or on a single LAN file-server or the permanent storage device of a multiple-user

12、 computer, or made available through the purchasers Intranet in such a manner that this standards document may only be accessed by one user at a time and for which there is no possibility of multiple simultaneous, concurrent access. If a multiple-user version electronic standards document was purcha

13、sed, one copy of the standards document may be stored on a single LAN file-server, or on the permanent storage device of a multiple-user computer, or made available through the purchasers Intranet. The number of simultaneous, concurrent users shall not exceed the number of users authorized. Electron

14、ic standards documents are intended for on-line use, such as for viewing the requirements of a standards document, conducting a word search, and the like. Only one copy of the standards document may be printed from each single-user version of an electronic standards document. Only one copy of the st

15、andards document may be printed for each authorized user of a multiple-user version of an electronic standards document. Because of differences in the computer/software/printer setup used by UL and those of electronic standards document purchasers, the printed copy obtained by a purchaser may not lo

16、ok exactly like the on-line screen view or the printed standards document. An employee of an organization purchasing a UL standards document can make a copy of the page or pages being viewed for their own fair and/or practical internal use. Copyright 2009 Underwriters Laboratories Inc. 4 NATIONAL DI

17、FFERENCES FOR UL 60950-22 APRIL 23, 2007 _ Underwriters Laboratories Inc. Preface This document provides a single listing of the technical National Differences included in the UL adoption of the corresponding IEC standard. Editorial National Differences (those marked DE) are not included in this tec

18、hnical compilation. In its IEC-based standards, UL uses the notations indicated below to identify national difference type, and these types are additionally noted in this document. The standard may not use all types of these deviations. DR - These are differences based on the National Electrical Cod

19、e (NEC) and other U.S. Regulatory Requirements. D1 - These are differences which are based on basic safety principles and requirements, elimination of which would compromise safety for U.S. consumers and users of products. Requirements related to these National Differences are based on North America

20、n regulatory requirements and are specified in Annex NAE. D2 - These are differences based on safety practices. These are differences for IEC requirements that may be acceptable, but adopting the IEC requirements would require considerable retesting or redesign on the manufacturers part. Some of the

21、se National Differences are Markings and Instructions Requirements and are specified in Annex NAA. D3 These are national differences based on bi-national requirements which result in less stringent requirements than in IEC 60950-1. DC - These are differences based on the component standards and will

22、 not be deleted until a particular component standard is harmonized with the IEC component standard. Component requirements for these deviations are specified in Annexes P.1 and P.2. DE These are differences based on editorial comments or corrections. 5 NATIONAL DIFFERENCES FOR UL 60950-22 APRIL 23,

23、 2007 _ Underwriters Laboratories Inc. National Differences 1.2 D2 Modification by replacing IEC 61024-1 reference with: NFPA 780 or CAN/CSA-B72 2 Modified by the following: Addition: D2 All references to IEC 60950-1 in this standard are replaced by the equivalent UL and CSA 60950-1 binational Stand

24、ards as listed below. (Either the first or second editions of CSA/UL 60950-1 may be used.) All relevant Standards referenced in the Part 1 Standard (Annex P, including P.1 and P.2) also apply to this Part 22 Standard and are not listed below. All references to clauses and subclauses in IEC 60950-1 a

25、re to the second edition. If the relevant clause or subclause has been renumbered in IEC 60950-1, second edition, the first edition reference is identified in parentheses directly after the second edition reference. D2 CAN/CSA-B72-M87 (R2003), Installation Code for Lightning Protection Systems D2 CS

26、A C22.3, Canadian Electrical Code, Part III D2 CAN/CSA-C22.2 No. 60950-1-03 or CAN/CSA-C22.2 No. 60950-1-07, Information Technology Equipment - Safety - Part 1: General Requirements D2 NFPA 780, Standard for the Installation of Lightning Protection Systems D2 UL 60950-1, First or Second Edition, Inf

27、ormation Technology Equipment - Safety - Part 1: General Requirements DC IEEE C62.11, Standard for Metal-Oxide Surge Arresters for AC Power Circuits (1 kV) Deletion D2 the reference to IEC 60950-1-2005. 4.2 DC Modified by adding the following: As an alternative, components used to reduce the Overvol

28、tage Category may comply with ANSI/IEEE C62.11, CSA Certification Notice No. 516, CSA C22.2 No. 1, or UL 1449. Suitability of the component for the application shall be determined for the intended installation. 6 NATIONAL DIFFERENCES FOR UL 60950-22 APRIL 23, 2007 _ Underwriters Laboratories Inc. (F

29、or example, some devices are suitable for installation on the load side of the service entrance only, and some are suitable for use with cord-connected equipment only.) 5 D1 Modified by adding the following: Additionally, OUTDOOR ENCLOSURES shall be classified and marked in accordance with UL 50 or

30、CAN/CSA C22.2 No. 94. 7 D1 Modified by adding the following: The applicable parts of the Canadian Electrical Code, Part I, CSA C22.1; Canadian Electrical Code, Part III, CSA C22.3; the National Electrical Code, NFPA 70; and the National Electrical Safety Code, ANSI/IEEE C2, shall apply as appropriat

31、e. 8.2 DC Modified by adding the following: As an alternative, materials tested in accordance with the requirements and test procedures of UL 746C, Sections 25 (UV Exposure) and 57 (UV Light Exposure Test), or CAN/CSA-C22.2 No. 0.17, Clause 5.9, are considered equivalent and acceptable for this appl

32、ication. 9.1 DC - Modified by adding: See Clause 5. 7 NATIONAL DIFFERENCES FOR UL 60950-22 APRIL 23, 2007 _ Underwriters Laboratories Inc. Added Annex D1 - Annex NAE (informative) U.S. and Canadian regulatory requirements This annex provides examples of and references for regulatory requirements tha

33、t might apply to some equipment. Applicability of these requirements is dependent on the construction of the equipment and its intended installation and use. This annex is not intended to provide a complete list of all of the applicable requirements, only to serve as a reference for requirements tha

34、t most commonly apply to this type of equipment. The National Electrical Code, ANSI/NFPA 70, covers equipment installed on public and private premises, including buildings, structures, mobile homes, recreational vehicles, floating buildings, yards, lots, parking lots, carnivals, and industrial subst

35、ations. Installation of outdoor equipment in a communications utilitys outside plant is covered by the National Electrical Safety Code (NESC), ANSI/IEEE C2. For complete requirements, the National Electrical Code, ANSI/NFPA 70, the Canadian Electrical Code, Part I, the National Electrical Safety Cod

36、e (NESC), ANSI/IEEE C2, or other referenced document must be consulted. Any undated reference to a code or standard appearing in the requirements of this standard shall be interpreted as referring to the latest edition of that code or standard. NOTE 1 Underlining to indicate text added to IEC 60950-

37、22 is not used in this annex. NOTE 2 The complete text of Annex NAE is a D1 national difference. D1 Annex NAE Clause No. Topic/summary NEC CEC 1.1 Equipment Covered Since CSA/UL 60950-22 is a Part 2 document to CSA/UL 60950-1, normative and informative parts of CSA/UL 60950-1, including Annex NAE, o

38、f CSA/UL 60950-1 apply to ITE to be installed outdoors, unless further amended by this Annex. NFPA 70, IEEE C2 CEC 22.1 3 Definitions for Outdoor Locations The location of the equipment is formally classified as either “Dry Location,“ “Damp Location“ or “Wet Location,“ depending on its degree of pro

39、tection from the elements. 100 0 3 Definitions for Outdoor Equipment and Outdoor Enclosure The terms “Equipment“ and “Enclosure“ in ANSI/NFPA 70 are defined differently than in Clause 3. 100 2-400 8 NATIONAL DIFFERENCES FOR UL 60950-22 APRIL 23, 2007 _ Underwriters Laboratories Inc. 4 Communication

40、Systems ITE installed outdoors with connections to communication systems shall have its external cables, wiring, and antenna systems, as applicable, installed per the applicable parts of Chapter 8 of ANSI/NFPA 70. Chapter 8 60 - Communication Circuits 800 - Radio and Television Equipment 810 - Commu

41、nity Antenna Television and Radio Distributions Systems 820 54 - Network-Powered Broadband Communication Systems 830 4.2 Power Supply Cords ITE installed outdoors containing a power supply cord used in Wet Locations shall have the suffix “W“, “W-A“, or the words “water resistant“ or “outdoor“ marked

42、 on the flexible cord. 400.4, Table 400.4 (Note 13) 4-010 Table 11 4.2 Installation of Surge Arrestors Installation of Surge Arrestors external to the ITE to reduce overvoltages or to bypass surge current shall be installed per Article 280 of ANSI/NFPA 70. 280 26-500 4.2 Installation of Transient Vo

43、ltage Surge Suppressors: TVSS Installation of Transient Voltage Surge Suppressors external to the ITE to reduce overvoltages or to bypass surge current shall be installed per article 285 of ANSI/NFPA 70 285 18-062 5 (9.1) Marking of Enclosures (Due to Deteriorating Agents) Equipment intended for use

44、 in damp or wet locations shall be investigated and identified for use in this type of operating environment. 110.11 2-200, 22 2-402 7 Markings for Class 2 Terminals Wiring terminals intended to supply Class 2 outputs in accordance with Article 725 of the National Electrical Code, ANSI/NFPA 70, or S

45、ection 16 of the Canadian Electrical Code, Part 1, CSA C22.1, shall be marked with the voltage rating and “Class 2“ or the equivalent. The marking shall be located adjacent to the terminals and shall be visible during wiring. Special note should be made to the lower voltages specified in Chapter 9 T

46、ables 11(A) and 11(B) of ANSI/NFPA 70 when wet contact is likely to occur. 725.2, 725.41, 725.42, 725.51, 725.52 16 9.1, 5 Marking of Enclosures (Due to Deteriorating Agents) 110.11 2-200, 22 2-402 11 Storage Batteries Stationary installations of storage batteries external to the ITE shall comply with Article 480 of ANSI/NFPA 70. 480 26-540