NAVY A-A-59771-2005 SELF-CONTAINED BREATHING APPARATUS (SCBA)《独立式呼吸器》.pdf

《NAVY A-A-59771-2005 SELF-CONTAINED BREATHING APPARATUS (SCBA)《独立式呼吸器》.pdf》由会员分享，可在线阅读，更多相关《NAVY A-A-59771-2005 SELF-CONTAINED BREATHING APPARATUS (SCBA)《独立式呼吸器》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、 INCH POUND A-A-59771 22 February 2005 COMMERCIAL ITEM DESCRIPTION SELF-CONTAINED BREATHING APPARATUS (SCBA) The General Services Administration has authorized the use of this commercial item description, for all federal agencies. 1. SCOPE. This commercial item description covers a National Fire Pro

2、tection Association (NFPA) 1981 compliant Self-Contained Breathing Apparatus (SCBA) to be used to provide breathing air for fire fighting and damage control activities aboard Navy ships where atmospheres are classified as being Immediately Dangerous to Life or Health (IDLH). 2. SALIENT CHARACTERISTI

3、CS. 2.1 Physical characteristics. The basic components of the SCBA shall include a compressed air cylinder secured to the users back with a back frame and harness, a first stage regulator, a facepiece, and a mask-mounted, second stage regulator. The SCBA shall conform to the following characteristic

4、s in addition to those specified in NFPA 1981. 2.1.1 Air cylinder. The SCBA air cylinder shall be fully wound carbon fiber wrapped composite construction and certified under current requirements established by the Department of Transportation (DOT). 2.1.1.1 Pressure indicator. The cylinder valve sha

5、ll include a pressure indicator, which shall provide a continuous reading of cylinder pressure. 2.1.1.2 Cylinder valve connection. The cylinder valve shall utilize a Compressed Gas Association (CGA) 347 connection. 2.1.1.3 Cylinder supplied. The SCBA shall be delivered with a 30-minute or a 45-minut

6、e cylinder as specified (see 6.2), as rated by NIOSH in accordance with 42 CFR 84, installed in the SCBA back frame. 2.1.1.4 Charge air. All cylinders shall be delivered fully charged with Type 1, Grade D quality air in accordance with ANSI/CGA G-7.1 and with a moisture content of 65 F dew point. 2.

7、1.2 Back frame and harness. 2.1.2.1 Cylinder size adjustment. The back frame shall be able to accommodate either a 30-minute or a 45-minute cylinder as rated by NIOSH in accordance with 42 CFR 84. Adjustments to the back frame to switch between cylinder sizes shall be made without tools and require

8、less than ten seconds. 2.1.2.2 Air cylinder replacement. It shall be possible to remove and reinstall an air cylinder in less than 60 seconds while the SCBA is being worn by another user without the use of tools. 2.1.2.3 Harness adjustment range. The backpack harness waist and shoulder straps or bel

9、ts shall fit a range of user sizes (body dimensions) from the 5thpercentile female to the 95thpercentile male as defined by ASTM F1166. 2.1.3 Voice projection unit (VPU). The VPU shall be facepiece mounted and shall attach to and be completely supported by the SCBA facepiece. 2.1.3.1 Operating contr

10、ols. The operating controls shall be limited to a single, watertight, on/off switch for activation. Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data that may improve this document should be sent to: Commander, Naval Sea Systems Command, ATTN: SEA 05Q, 133

11、3 Isaac Hull Avenue, SE, Stop 5160, Washington Navy Yard DC 20376-5160 or emailed to commandstandardsnavsea.navy.mil, with the subject line “Document Comment”. Since contact information can change, you may want to verify the currency of this address information using the ASSIST Online database at ht

12、tp:/assist.daps.dla.mil. FSC 4240 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59771 2.1.3.2 On/off indication. The VPU shall have a light emitting diode (LED) on the exterior of the VPU, which illuminates whenever power is on, but is not in t

13、he wearers field of vision where it becomes a distraction to the user in low-light conditions. 2.1.3.3 Replaceability. It shall be possible for the user to remove a VPU from the facepiece and attach an identical replacement unit to the facepiece in less than 30 seconds, while wearing gloves and with

14、out the use of tools. 2.1.3.4 Maintenance. The VPU shall not require periodic maintenance, other than cleaning and replacement of batteries. 2.1.4 Power supply. 2.1.4.1 Batteries. The VPU and Heads-Up Display (HUD) shall be powered by alkaline batteries and shall use no more than the indicated numbe

15、r of one of the following battery types for each VPU or HUD: NEDA 14A (C cell): 1 battery per set NEDA 15A (AA cell): 2 batteries per set NEDA 1604A (9 volt): 1 battery per set 2.1.4.2 Batteries supplied. Upon delivery, batteries for the HUD and VPU shall be supplied with the SCBA in a separate, sea

16、led package. 2.1.5 Size limitation. 2.1.5.1 Stowage size. The SCBA with a 30-minute or a 45-minute cylinder installed shall fit into a stowage area not to exceed 12 inches wide by 25 inches high by 11 inches deep. 2.1.5.2 Maximum depth. The SCBA with a 30-minute cylinder shall not have a depth great

17、er than 8.5 inches, including cylinder retention band. 2.1.6 Facepiece. The facepiece shall be clearly marked to identify facepiece size if available in more than one size. 2.1.6.1 Lens replacement. The facepiece lens shall be replaceable without the use of special tools and the time to replace the

18、lens shall not exceed 8 minutes. The lens shall be interchangeable with all facepiece sizes, if applicable. 2.1.6.2 Nosecup. The facepiece shall be equipped with a nosecup and shall have size clearly marked, if applicable. The nosecup shall be removable without the use of special tools and interchan

19、geable with all size facepieces. 2.1.6.3 Corrective spectacles. The SCBA shall have a NIOSH approved spectacle kit available as an accessory. 2.1.7 Cleaning and disinfecting. 2.1.7.1 Facepiece. The facepiece shall be fully immersible in a dilute sanitizing solution, defined as 2 tablespoons of Wesco

20、dyne G or sodium hypochlorite per 1 gallons of water, for the purpose of cleaning and disinfecting. Preparation time, i.e., removal of non-immersible parts such as the VPU, for full immersion shall be less than 30 seconds. 2.1.7.2 Second stage regulator. If any part of the second stage regulator is

21、exposed to the exhalation path, the second stage regulator shall be fully immersible in a dilute sanitizing solution, defined as 2 tablespoons of Wescodyne G or sodium hypochlorite per 1 gallons of water, for the purpose of routine cleaning and disinfecting. 2.2 Performance requirements. The SCBA sh

22、all meet the following performance requirements in addition to all requirements specified in NFPA 1981. 2.2.1 Certification. The SCBA shall be certified to 42 CFR 84 and certified by NIOSH for fire fighting and emergency responder use in Chemical, Biological, Radiological, and Nuclear (CBRN) environ

23、ments. 2.2.2 Rated duration. The SCBA shall have a minimum rated service time of thirty minutes and forty-five minutes depending on the size of the installed air cylinder, when tested by NIOSH in accordance with 42 CFR 84. 2 Provided by IHSNot for ResaleNo reproduction or networking permitted withou

24、t license from IHS-,-,-A-A-59771 2.2.3 VPU operating time. The VPU shall have a minimum operating life of 6 hours. 2.2.4 Second stage regulator operation. The second stage regulator shall operate in the pressure demand mode. 2.2.4.1 Bypass. Second stage regulators shall include a separate control fo

25、r admitting purge air into the facepiece to clear fogging. 2.2.4.2 Air shutoff control. The second stage regulator shall include a separate control for air shutoff. The air shutoff control shall provide a convenient means to stop the flow of breathing air to the facepiece when the user is in a safe

26、breathing environment. 2.2.5 Recharge capability. It shall be possible to fully recharge the air cylinder while the SCBA is being worn and in use (user is “on air”). It shall be possible to fully recharge an empty 45-minute air cylinder (pressure less than 500 psig) to 4500 psig in this manner in le

27、ss than one minute. 2.2.6 Stowage and survivability. The SCBA shall pass shock and vibration testing while stowed in a Model 12 locker in accordance with NAVSEA DWG 53711-664-7246014. 2.2.6.1 Shock. The SCBA shall be shock tested in accordance with MIL-S-901, Shock Grade A, Class II, Test Type A. Up

28、on completion of test, the SCBA shall pass a functional test in accordance with the Testing subsection of NFPA 1852. 2.2.6.2 Vibration. The SCBA shall be vibration tested in accordance with MIL-STD-167-1, Type I. The exploratory variable range shall be 4 Hz to 50 Hz. Upon completion of test, the SCB

29、A shall pass a functional test in accordance with the Testing subsection of NFPA 1852. 2.3 Safety. All parts or components of the equipment, as well as the assembled units delivered, shall, as a minimum, be fabricated to eliminate hazards to personnel, interfacing equipment, and the equipment itself

30、. The equipment shall be safe to use in the intended environment as specified herein and shall include over-pressurization protection. 3. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of

31、 the Federal Acquisition Regulation (FAR). 4. PRODUCT CONFORMANCE PROVISIONS. 4.1 Product conformance. The products provided shall meet the salient characteristics of this Commercial Item Description, conform to the producers own drawings, specifications, standards, and quality assurance practices,

32、and be the same product offered for sale in the commercial marketplace. The government reserves the right to require proof of such conformance. 4.2 Market acceptability. The following market acceptability criteria are necessary to document the quality of the product to be provided under the CID. 4.2

33、.1 The manufacturer of the item must have been producing a product meeting the requirements of this CID for at least 2 years. 4.2.2 The manufacturer must have sold at least 1000 units meeting this CID in the commercial market over the past 2 years. 5. PACKAGING. Preservation, packing, and marking sh

34、all be as specified in the contract or order. 6. NOTES. 6.1 Source of documents. 6.1.1 ANSI. ANSI standards are available from the American National Standards Institute, 25 W. 43rdSt, 4 floor, New York, NY 10036 or online at http:/www.ansi.org. 3 Provided by IHSNot for ResaleNo reproduction or netwo

35、rking permitted without license from IHS-,-,-A-A-59771 6.1.2 ASTM. ASTM standards are available from ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959 or online at http:/www.astm.org/. 6.1.3 CFR. The Code of Federal Regulations (CFR) may be obtained from the Superintendent

36、of Documents, U.S. Government Printing Office, Washington, DC 20401 or online at http:/www.gpoaccess.gov/index.html. 6.1.4 CGA. CGA specifications and standards are available from the Compressed Gas Association, Inc., 4221 Walney Road, 5thFloor, Chantilly, VA 20151-2923 or online at http:/. 6.1.5 MI

37、L-SPECs. Military Specifications are available at http:/astimage.daps.dla.mil/quicksearch/ or http:/assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Bldg. 4D, Philadelphia, PA 19111-5094. 6.1.6 MIL-STDs. Military Standards are available at http:/astimage.daps.

38、dla.mil/quicksearch/ or http:/assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Bldg. 4D, Philadelphia, PA 19111-5094. 6.1.7 NFPA. National Fire Protection Association (NFPA) standards are available from NFPA, 1 Batterymarch Park, Quincy, MA 02169-7471 or onlin

39、e at www.nfpa.org. 6.2 Ordering data. The contract or order should specify the following: a. CID document number and revision. b. Cylinder supplied (see 2.1.1.3). c. Product conformance provisions. d. Packaging requirements. 6.3 Keywords. Air CBRN Cylinder Damage control Fire fighting Investigator P

40、ersonnel protection equipment Respirator Safety equipment MILITARY INTERESTS Custodians:Army EA Preparing Activity: Navy SH Navy SH Air Force 03 (Project 4240-0693-000) Review Activities: Navy AS Air Force 11, 84, 99 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without lice

41、nse from IHS-,-,-A-A-59771 5 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-