GMKOREA EDS-T-4554-2008 THE TEST PROCEDURE OF LUMBAR SUPPORT OPERATION DURABILITY.pdf

《GMKOREA EDS-T-4554-2008 THE TEST PROCEDURE OF LUMBAR SUPPORT OPERATION DURABILITY.pdf》由会员分享，可在线阅读，更多相关《GMKOREA EDS-T-4554-2008 THE TEST PROCEDURE OF LUMBAR SUPPORT OPERATION DURABILITY.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、GM DAEWOO Auto & Technology EDS Engineering, GM DAEWOO Auto & Technology Standards THE TEST PROCEDURE OF LUMBAR SUPPORT OPERATION DURABILITY Do Not Use on New Programs. Being Replaced by GMW14407 EDS-T-4554 ISSUED DATE: 1998. 08. 30 REVISED DATE: 2008. 10. 15 VERSION: 3 (Superceded) EDS-T-4554THE TE

2、ST PROCEDURE OF LUMBAR SUPPORT OPERATION DURABILITY PAGE: 1/2 ISSUED DATE: 1998. 08. 30 REVISED DATE: 2008. 10. 15 VERSION: 3 GM DAEWOO Auto & Technology Note: This standard may be applied only for current project (incl. T255 Program). It is Superceded for all future projects and replaced by GMW1440

3、7. 1. PURPOSE This procedure verifies durability of the lumbar support against the operation fatigue. 2. SCOPE Seats with lumbar support function 3. TEST SAMPLES Minimum three new assemble seat 4. TEST EQUIPMENT AND JIG 4.1. Jig for fitting seats in vehicle conditions 4.2. Jig for placing the seat b

4、ack in horizontal direction 4.3. Back pan (weight 29 kg) 4.4. Durability tester 5. METHODS AND SPECIFICATIONS OF TEST 5.1. Test Method 5.1.1. Fit the BIW or the seat-fixing jig on the durability tester, and then mount a seat on the jig. 5.1.2. Set the seat back to the position specified in the desig

5、n standard, and then fix the seat back horizontal with the jig as shown in fig. 1. 5.1.3. Load the back pan with weight of 29 kg on the seat back. 5.1.4. Move the seat back to the forefront position with the lumbar support knob, and then to the rearmost position. 5.1.5. Repeat the test for 5000 cycl

6、es in speed of 10 20cpm. Each cycle consists of the procedure defined in item 5.1.4. 5.2. Measurement method of operating force 5.2.1. Fit the BIW or the seat-fixing jig on the durability tester, and then mount a seat on the jig. 5.2.2. Measure the operating force throughout the zones while moving t

7、he seat back to the foremost position with the lumbar support knob, and then to the rearmost position. EDS-T-4554THE TEST PROCEDURE OF LUMBAR SUPPORT OPERATION DURABILITY PAGE: 2/2 ISSUED DATE: 1998. 08. 30 REVISED DATE: 2008. 10. 15 VERSION: 3 GM DAEWOO Auto & Technology 5.2.3. If the knob is of le

8、ver type, measure the load at the point 10 mm from the end of the lever. If the knob is of dial type, measure the momentum operating force. 5.3. Evaluation 5.3.1. No abnormal noise shall occur during the test. 5.3.2. The back frame and the lumber support devices shall be free of crack and damage. 5.3.3. The lumber support devices shall be free of abnormal operation. 5.3.4. The front/rear operating force before and after the durability test shall satisfy the specifications in the drawings. Figure 1