FORD W-GT3-1999 DOUBLE END STEP LIMIT THREAD PLUG GAUGE L1 AND L3 FOR DRYSEAL USA STANDARD TAPER PIPE THREAD N P T F RANGE UP TO 2 INCHES《干密封件用两端行程限制的螺纹塞规L1和L3 美国标准锥管螺纹N P T F 量程2英.pdf

《FORD W-GT3-1999 DOUBLE END STEP LIMIT THREAD PLUG GAUGE L1 AND L3 FOR DRYSEAL USA STANDARD TAPER PIPE THREAD N P T F RANGE UP TO 2 INCHES《干密封件用两端行程限制的螺纹塞规L1和L3 美国标准锥管螺纹N P T F 量程2英.pdf》由会员分享，可在线阅读，更多相关《FORD W-GT3-1999 DOUBLE END STEP LIMIT THREAD PLUG GAUGE L1 AND L3 FOR DRYSEAL USA STANDARD TAPER PIPE THREAD N P T F RANGE UP TO 2 INCHES《干密封件用两端行程限制的螺纹塞规L1和L3 美国标准锥管螺纹N P T F 量程2英.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、MINIMUMDEPTHMINIMUMDEPTHL1 THREAD PLUGL3 THREAD PLUGNational Standard Code (0=None, 1=ISO, 2=ANSI, 3=BSI, 4=DIN) G Tauging Standard hread GaugeGT3 12.0 0 1/418Thread Pitch (Threads Per Inch)Nominal Thread SizeWorkpiece Minimum Thread Depth3=Taper Pipe ThreadSTANDARDNUMBER:ISSUEDATE:REV:GLOBAL MANUFA

2、CTURING STANDARDSEXAMPLE OF FORD STANDARD PART NUMBERPURPOSE.FOR ORDERING A DOUBLE END THREAD PLUG GAUGEFOR A WORKPIECE SPECIFICATION OF 1/4 18 NPSF MINIMUM THREAD DEPTH 12 mm.1 OF 1DIMENSIONS IN mmPrinted copies are uncontrolled.DOUBLE END STEP LIMIT THREAD PLUG GAUGEwGT3FOR DRYSEAL USA STANDARD TA

3、PER PIPE THREAD N.P.T.F.RANGE UP TO 2 INCHESTAPERLOCK STYLETHE L1 THREAD PLUG MEMBER IS USED FOR CHECKING THE FUNCTIONALDIAMETER OVER THE HAND ENGAGEMENT OR L1 THREAD LENGTH, AND THETHREAD PLUG MEMBER CHECKS THE TAPER OVER THE FULL THREAD LENGTH.NOTE:AS A CHECKON PART THREAD THE L1 AND L3 GAUGES SHALL GAUGE THESAME WITH RELATION TO THEIR RESPECTIVE NOTCHES WITHIN 1/2 TURN.L1 AND L3This standard is issued to govern the requirements for a Double End Step Limit Thread Plug Gauge19991201