FORD ESF-M1C26-A-2008 GREASE - LOW TEMPERATURE TO BE USED WITH FORD WSS-M99P1111-A 《耐低温润滑脂 与标准FORD WSS-M99P1111-A一起使用 ［使用 FORD WSS-M13P13-A FORD WSS-M13P13-A］》.pdf

《FORD ESF-M1C26-A-2008 GREASE - LOW TEMPERATURE TO BE USED WITH FORD WSS-M99P1111-A 《耐低温润滑脂 与标准FORD WSS-M99P1111-A一起使用 ［使用 FORD WSS-M13P13-A FORD WSS-M13P13-A］》.pdf》由会员分享，可在线阅读，更多相关《FORD ESF-M1C26-A-2008 GREASE - LOW TEMPERATURE TO BE USED WITH FORD WSS-M99P1111-A 《耐低温润滑脂 与标准FORD WSS-M99P1111-A一起使用 ［使用 FORD WSS-M13P13-A FORD WSS-M13P13-A］》.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 10 09 N-STATUS Replaced by WSS-M13P14-A L. Schmalz, FNA 2003 10 20 Revised Para 3.0 inserted; para 3.9 and 4 deleted 1963 06 24 Released F6-1069 Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, Inc. Page 1 of 1 GR

2、EASE - LOW TEMPERATURE ESF-M1C26-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a modified calcium soap, low temperature grease, with zinc oxide and extreme pressure additives. This grease is operative at -40 C. 2. APPLICATION This specification was released o

3、riginally for grease used for starting motor shafts. 3. REQUIREMENTS 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1 DROPPING POINT, min 127 C (ASTM D 566) 3.2 P

4、ENETRATION, (mm/10) 290 - 320 (ASTM D 217, worked 60 stroked) 3.3 OXIDATION STABILITY (Pressure Drop, max) 5 psi (34 kPa) (ASTM D 942, 100 hours) 3.4 EVAPORATION LOSS, max 10% (ASTM D 972, at 99 C) 3.5 SOAP CONTENT (CALCIUM) 9.0 - 14.0% (ASTM D 128) 3.6 FILLER (ZINC OXIDE) 4 - 6% (ASTM D 128) 3.7 LOW TEMPERATURE TORQUE (-40 C) (ASTM D 1478) Starting, max 1000gcm Running, max 800 gcm 3.8 TIMKEN EXTREME PRESSURE TEST, min 20 lb (9 kg) (ASTM D 2782)