EN 60721-3-1-1997 en fr Classification of Environmental Conditions Part 3 Classification of Groups of Environmental Parameters and Their Severities Section 1 Storage (Remains Curre.pdf

《EN 60721-3-1-1997 en fr Classification of Environmental Conditions Part 3 Classification of Groups of Environmental Parameters and Their Severities Section 1 Storage (Remains Curre.pdf》由会员分享，可在线阅读，更多相关《EN 60721-3-1-1997 en fr Classification of Environmental Conditions Part 3 Classification of Groups of Environmental Parameters and Their Severities Section 1 Storage (Remains Curre.pdf（26页珍藏版）》请在麦多课文档分享上搜索。

1、STD*BSI BS EN b0721-3-L-ENGL II977 = lb24bb9 Ob317b2 720 BRITISH STANDARD Classification of environmental conditions Part 3. Classification of groups of environmental parameters and their severities Section 1. Storage The European Stan- EN 6072151 : 1997 has the status of a , British Standard ICs 19

2、.040 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGEPT LAW BS EN 60721-3-1 : 1997 IEC 607213-1 : 1997 STD-BSI BS EN bD721-3-1-ENGL 1997 lb29bb9 Ob317b3 bb7 9 BS EN 607213-1 : 1997 This Briish Standard, having been prepared under the direction of the Elcal Sector Board, was publishe

3、d under the authority of the standards Board and comes into effect on 16 August 1997 National foreword “his British Standard is the higlish language version of EN 60721-3-1 : 1997. It is identical with IEC 60721-3-1 : 1997. It supemedes BS EN 60721-3-1 : 1993 which is withdrawn. The UK participation

4、 in its prepamtion was entrusted to Technid Committee GEIJSO, EnvirOnmental testing of electmtechnical products, which has the responsibilityto: - aid enquirem to understand the tee - present to the responsible intmnationaVEumpean committee any enquiries on the interpretation, or proposals for chang

5、e, and keep the UK interests iIlf0 - monitor reW intedonal and European developments and promulgate them in the UK. A iist of organizations represented on this committee can be obtained on request to its secretary. Cross-references Attention is drawn to the fact that CEN and CENELEC Standards nom in

6、clude an annex which lists normative references to internationai publications with their corresponding European publications. The British Standards which implement these international or European publications may be found in the BSI Standards Catalogue under the section entitled internationai Stan-

7、Correspondence index, or using the Find facity of the BSI Standards Electronic Catalogue. Compliance with a British Standard does not of itself confer immunity from legai obligations. Summary of pages This document comprises a front cover, an inside front cover, the EN title page, pages 2 to 23, a b

8、lank page, an inside back cover and a back cover. Amendments issued since publication 0 BSI 1997 ISBN O 880 27809 3 EUROPEAN STANDARD NORME EUROPEENNE EUROPISCHE NORM EN 60721-3-1 March 1997 English version Classification of environmental conditions Patt 3: Classification of groups of environmental

9、parameters and their severities Section 1: Storage -.(IEC 60721-3-1:1997) Classification des conditions denvironnement Teil 3: Klassen von Partie 3: Classification des groupements des agents denvironnement et de leurs sdvdrit6s Section 1: Stockage (CE1 6072 1 -3- 1 : 1 997) Klassifizierung von Umwel

10、tbedingungen Umwelteinflugren und deren Grenzwerte Hsuptabschnitt 1 : Langzeitiagerung - - (IEC 60721-3-1 : 1997) _. - _I II This European Standard was appiovd bv CENELEC on 1998-1 2-09. CENELEC mom heating, cooling or humidification being used where necessary to maintain required conditions; exposu

11、re to some solar and heat radiation; movement of surrounding air, such as through open windows; without particular risk of biological attacks; with normal levels of contaminants experienced in urban areas with industrial activities scattered over the whole area, or with heavy traffic; without specia

12、l precautions to minimize presence of dust or sand, but not situated in proximity to dust and sand sources; experiencing vibration of low significance. In addition to the conditions covered by IEll, IE12 applies to locations having neither temperature nor humidity control; heating may be used to rai

13、se low temperatures; with buildings constructed to avoid extremely high temperatures; with risk of condensation, dripping water, formation of ice. In addition to the conditions covered by IE12, IE13 applies to locations in buildings provided with minimal protection from daily variations of outside c

14、limate; exposure to solar radiation, wind-driven precipitation; with risk of mould growth and attacks by animals except termites; in close proximity to sand and dust sources, including those of urban areas. In addition to the conditions covered by IE13, IE14 applies to non-weatherprotected locations

15、; negligible heat radiation; fair movement of surrounding air; experiencing significant shock, for example that transmitted from machines or passing vehicles in the vicinity. STDOBSI BS EN bO721-3-1-ENGL 1777 = Lb24bb7 Ob31783 455 Page 20 EN 60721-3-1 : 1997 Annex C (informative) Explanation of the

16、environmental conditions in tropical areas as specified in classes 1 K10 and 1 K11 C.l General The tropics are the areas within the Northern and Southern tropics (between 2327 south and 2327 north). In tropical areas, the following types of open-air climate, as specified in IEC 721-2-1, apply: Warm

17、Dry (WDr) Mild Warm Dry (MWDr) Extremely Warm Dry (EWDr) Warm Damp (WDa) Warm Damp Equable (WDaE) The tropics are the zones of the earth in which, during daytime, high temperatures, frequently combined with high precipitation, prevail. In these areas, seasonal changes are scarcely pronounced. The tr

18、opical climate extends from warm damp climatic conditions in tropical rainforests at the equator to the warm dry climate in the deserts near the tropics. Consequently, two types of tropical climate should be distinguished: - tropical dry as a combination of the Warm Dry, Mild Warm Dry and Extremely

19、Warm Dry types of climate; and - tropical damp as a combination of the Warm Damp and Warm Damp Equable types of climate. There are also regions where the climate, owing to the particular altitude, deviates considerably from the usual conditions of those latitudes, for example solar radiation and air

20、 pressure or ice and snow on mountain summits. In many areas in the tropics, environmental conditions are identified by uniform conditions, and in other regions by very extreme climatic conditions: Balanced conditions: - minimum daily temperature fluctuations of less than 1 OC and annual temperature

21、 fluctuations of maximum 6 OC; - balanced duration of daylight periods between 10,5 h and 13,5 h; - uniform intensity of solar radiation; - balanced conditions for an abundant fauna. Extreme conditions: - precipitation: rainfall the whole year round near the equator, heavy rainfall during certain pe

22、riods of the year near the tropics; - tropical cyclones in sea areas: wind velocities of 30 m/s with peaks attaining more than 60 mis, for example in typhoons in the Western Pacific and in hurricanes in the Caribbean Sea; - unfavourable soil conditions: erosion of humus and minerals in areas with he

23、avy rainfalls; - rapid drying of soil in the desert as a result of high temperatures and strong winds; - lush vegetation in tropical rainforests, less dense vegetation in mountain forests; - grass areas of savannahs and steppes, absence of vegetation in the desert. C.2 Climatograms Climatograms for

24、the two classes describing climatic conditions in tropical areas are given in figure C.1. They are based on the mean value of annual extreme values of air temperature and humidity for the types of climate specified in C.l above. STD-BSI BS EN b0721-3-1-ENGL 1777 m 1b24bb9 Ob31785 228 Page 22 EN 6072

25、1-3-1 : 1997 Humidit8 absolue de air Absolute air humidity gm -80 -70 -60 -so -40 -30 -io -io 8 io io io io 50 60 OC Temprature de lair Air temperature IEC 620W Figure C.l - Climatogrammes correspondant au type de climat tropical humide et au type de climat tropical sec Climatograms for tropical dam

26、p type of climate and tropical dry type of climate STD-BSI BS EN b0721-3-1-ENGL 1977 W Lb24bb7 Ub3L78b Lb4 W Page 23 EN 60721-3-1 : 1997 Annex ZA (normative) Normatbe referoncas to intemadonal publicadau with thair corresponding European pubii- This European Standard incorporates by dated or undated

27、 reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when inc

28、orporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments). NOTE: Wtn M int.maiond publicadon haa beon modifid by common modificrtioru, indicated by (mod), tha relevant EN/HD applies. EAuiaQQ IEC 721-1 + Al IEC 72

29、1-2-1 + Al IEC 721-3-0 * v! * + Al IEC 6072 1 -3-2 IEC 721-3-3 IEC 721-3-4 yent 1990 1992 1982 1987 1984 1987 1997 1994 1995 Classification of environmentd conditions Pafl 1 : Environmental parametws and thdr sever ides Part 2: Environmental conditions appearing in nature - Temperature and humidity

30、Part 3: Classification of groups of environmentai parameters and thdr severides - Introduction Section 2: Transportation Secdon 3: Stationary use at weatherprotected locations Section 4: Stationary use at non-weatherprotecte locations EN 60721-1 HO 478.2.1 S1 ypnr 1995 1989 EN 60721-3-0 1993 EN 6072

31、1 -3-2 1997 EN 60721 -3-3 1995 EN 60721-3-4 1995 BS EN 60721-3-1 : 1997 IEC 60721-3-1 1997 BSI 389 Chiswick High Road London w4 4AL BSI - British Standards Institution 3SI is the independent national body responsible for preparing British Standards. It )resents the UK view on standards in Europe and

32、 at the international level. It is ncorporated by Royal Charter. Zontract requirements 4 British Standard does not purport to include all the necessary provisions of a :onxact Users of British Standards are responsible for their correct application. Revisions British Standards are updated by amendme

33、nt or revision. Users of British Standards should make sinre LI they poses the latest amendments or editions. t is the constant aim of BSI to improve the quaity of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this British Standard would inf

34、orm the Secretary of the responsible technical committee, the identity of which can be found on the inside front cover. Tel: 0181 996 9000; Fax: 0181 996 7400. BSI offers members an individual updating service cded PLUS which ensures that subscribers automatically receive the latest editions of stan

35、dards. Buying standards Orders for all BSI, international and foreign standards publications should be adressed to Customer Services, Sales Department at Chiswick Tel 0181 996 7000; Fax: 0181 996 7001. In response to orders for international standards, it is BSI policy to supply the BSI knl , p.emet

36、Aion of %ose that have been published as British Standards, unless othew4se iequesteci. Information on standards BSI provides a wide range of information on national, European and international standards through its Library, the Standardiine Database, the BSI Information Technology Service (BITS) an

37、d its Technical Help to Exporters Service. Contact the Information Department at Chiswick Tel 0181 996 7111; Fax: 0181 996 7048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and o

38、ther benefits contact Customer Services, Membership at Chiswick Tel 0181 996 7002; Fax: 0181 996 7001. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyrig

39、ht, Designs and Patents Act 1988 no extract may be reproduced, stored in a relrieval system or transmitted in any form or by any means - electronic, photocopying, recording or otherwise - without prior written permission from BSI. This does not preclude the free use, in the course of implementing th

40、e standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager, BSI, 389 Chiswick High Road, London W4 4AL