DLA MS35118 REV E-2013 CONNECTOR RECEPTACLE SERIES SM UG-695 U.pdf

《DLA MS35118 REV E-2013 CONNECTOR RECEPTACLE SERIES SM UG-695 U.pdf》由会员分享，可在线阅读，更多相关《DLA MS35118 REV E-2013 CONNECTOR RECEPTACLE SERIES SM UG-695 U.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、 MS35118E 01 August 2013 SUPERSEDING MS35118D 26 July 2006 DETAIL SPECIFICATION SHEET CONNECTOR, RECEPTACLE, SERIES SM, UG-695/U This specification is approved for use by all Departments and Agencies of the Department of Defense The requirements for acquiring the product described herein shall consi

2、st of this specification sheet and MIL-DTL-27434. Inches mm Inches mm .001 .003 .038 .132 .175 0.02 0.08 0.96 3.35 4.44 .266 .363 .375 .414 .875 6.76 9.22 9.52 10.51 22.22 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for information only. 3. Unless otherwise specified toleranc

3、es shall be .003 Inch (0.08 mm). FIGURE 1. Connector, receptacle, series SM, UG-695/U. AMSC N/A FSC 5935 INCH-POUND Inactive for new design after 15 June 1999 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS35118E Engineering Information: Frequency

4、 range: DC to 500 MHz. Voltage rating: 100 volts peak. Applicable drawings Requirements: Dimensions and configuration shall be specified on figure 1. The insulator shall have no visible cracks or flaws. All metal parts shall be free from chips, burrs and scratches in accordance with best commercial

5、practices. All metal parts (except the center contact) shall have a silver plate in accordance with ASTM B700 a minimum thickness of 0.000200 inches, (5.08 m). Center contacts shall be gold plated to a minimum of 50 inches in accordance with ASTM B488, type II, code C, class 1.27. Corrosion: In acco

6、rdance with test procedure EIA/ECA 364-26, test condition B. All threads shall be in accordance with FED-STD-H28. Part or Identifying Number (PIN): MS35118-1. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. 2 Q

7、uantity Description Material Drawing or MS 2 1 1 1 2 Insulator Contact Body Lock washer Nut, Hex Plastic Brass Brass Ph. Bronze Brass SC-B-72190 SC-B-72191 SC-B-72192 MS25082-S13 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS35118E Referenced doc

8、uments. In addition to MIL-DTL-27434, this document references the following: SC-B-72190 SC-B-72191 SC-B-72192 ASTM B488 ASTM B700 EIA/ECA 364-26 FED-STD-H28 CONCLUDING MATERIAL Custodians: Preparing activity: Army CR DLA CC DLA CC (Project 5935-2013-156) NOTE: The activities listed above were inter

9、ested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-