DLA MIL-PRF-15160 38 B-2011 FUSES STYLE F38.pdf

《DLA MIL-PRF-15160 38 B-2011 FUSES STYLE F38.pdf》由会员分享，可在线阅读，更多相关《DLA MIL-PRF-15160 38 B-2011 FUSES STYLE F38.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、AMSC N/A FSC 5920 INCH-POUND MIL-PRF-15160/38B 12 October 2011 SUPERSEDING MIL-PRF-15160/38A 14 March 2005 PERFORMANCE SPECIFICATION SHEET FUSES, STYLE F38 This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product

2、described herein shall consist of this specification sheet and MIL-PRF-15160. Ltr Inches mm Min Max Min Max A 2.969 3.031 75.41 76.99 B .782 .844 19.86 21.44 C 2.094 2.156 53.19 54.76 D .234 .296 5.94 7.52 E .281 .343 7.14 8.71 F .406 .468 10.31 11.89 G .234 .296 5.94 7.52 H .782 .844 19.87 21.44 J

3、.719 .781 18.26 19.84 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. FIGURE 1. Style F38. INACTIVE FOR NEW DESIGN AFTER 27 DECEMBER 1990 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-15160/

4、38B 2 REQUIREMENTS: Interface and physical dimensions: See figure 1. Body: Fiber. Ferrule: Brass. Terminal strength: 5 inch-pounds. Type designation: Type designation shall be as specified in table 1. Electrical: Voltage rating: 125 volts dc maximum. Overload interrupt: Characteristic A: Maximum 1 h

5、our at 135 percent of rated current. Characteristic B: Maximum 1 hour at 135 percent of rated current, and a minimum of 5 seconds at 300 percent. Short circuit interrupt: 10,000 amperes at 125 volts dc. Current rating: See table 1. Voltage rating: See table 1. Characteristic: See table 1. TABLE 1. T

6、ype designation and electrical rating. Style Characteristic Voltage Current F38 A 125 V 35 A F38 A 125 V 40 A F38 A 125 V 50 A F38 A 125 V 60 A F38 B 125 V 35 A F38 B 125 V 40 A F38 B 125 V 50 A F38 B 125 V 60 A VERIFICATION: Qualification is not applicable for this specification sheet and is replac

7、ed by successful completion of group A and group B inspections in MIL-PRF-15160, before product is delivered. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-15160/38B 3 The margins of this specification are marked with vertical lines to indi

8、cate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irresp

9、ective of the marginal notations and relationship to the last previous issue. Custodians: Preparing activity: Army - CR DLA - CC Navy - SH Air Force - 85 (Project 5920-2011-036) DLA - CC Review activities: Air Force - 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-