ASD-STAN PREN 3235-1-2003 Aerospace Series Heat Resisting Alloys Wrought Products Technical Specification Part 1 - General Requirements (Edition P 2)《航空航天系列 耐热合金锻件的技术规范 第1部分 一般要求 第.pdf

《ASD-STAN PREN 3235-1-2003 Aerospace Series Heat Resisting Alloys Wrought Products Technical Specification Part 1 - General Requirements (Edition P 2)《航空航天系列 耐热合金锻件的技术规范 第1部分 一般要求 第.pdf》由会员分享，可在线阅读，更多相关《ASD-STAN PREN 3235-1-2003 Aerospace Series Heat Resisting Alloys Wrought Products Technical Specification Part 1 - General Requirements (Edition P 2)《航空航天系列 耐热合金锻件的技术规范 第1部分 一般要求 第.pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、AECMA STANDARD NORME AECMA AECMA NORM prEN 3235-1 Edition P 2 May 2003 ICs: Descriptors: ENGLISH VERSION Aerospace series Heat resisting alloys Wrought products Technical specification Part 1 : General requirements Supersedes edition P 1 October 1993 Serie arospatiale Alliages rsistant a chaud Produ

2、its corroys Spcification technique Partie 1 : Exigences gnrales Luft- und Raumfahrt Hochwarmfeste Legierungen Umgeformte Erzeugnisse Technische Lieferbedingungen Teil 1 : Allgemeine Anforderungen of AECMA-STAN (The on green paper for the by the experts of the shall not be changed to an thout re-iden

3、tification of the of AECMA-STAN it will be submitted as a ndardization) for formal vote. concerned Domain folio After examinati NOTE: Plate, sheet and strip see prEN 4700-1 Bar and section see prEN 4700-2 Tube see prEN 4700-3 Wire see prEN 4700-4 Replace page 1 of the previous edition by this page Withdrawal approved 15 May 2003 Comments should be sent within six months after the date of publication to AECMA-STAN Metallic Material Domain I Copyright 2003 O by AECMA-STA1