ARMY MIL-C-62135 A (2)-1989 CRANE MATERIAL HANDLING (BASIC AND REBUILD)《物料搬运(基本和重建)起重机》.pdf

《ARMY MIL-C-62135 A (2)-1989 CRANE MATERIAL HANDLING (BASIC AND REBUILD)《物料搬运(基本和重建)起重机》.pdf》由会员分享，可在线阅读，更多相关《ARMY MIL-C-62135 A (2)-1989 CRANE MATERIAL HANDLING (BASIC AND REBUILD)《物料搬运(基本和重建)起重机》.pdf（5页珍藏版）》请在麦多课文档分享上搜索。

1、MIL-C-62135A(AT) AMENDMENT 2 SUPERCEDING AMENmNT 1 29 November 1982 89 MILITARY SPECIFICATION CRANE: MATERIAL HANDLING (BASIC AND REBUILD) This amendment forms a kt of Military Specification MIL-C-62135AAT), dated 21 May 1976, and is approved for use by US Army Tank-Automotive Command. Department of

2、 the Army. and is available for use by all Departments and Agencies of the Department of Defense. PAGE 1 *l.l. delete and substitute: “1.1 m. This specification covers the basic and rebuilt models of a revolving type material handling crane, having a lifting capacity of not less than 2.500 pounds at

3、 its maximum reach.“ Beneficial comments paragraph. line 4. after the word “Command“ insert “ATTN: AMSTA-GDS, Warren, MI 48397-5000“. PAGE 2 2.1. under “DRAWING“. line 1, delete “Receptable“ and substitute “Receptacle“ . *Add new paragraph 2-2 as follows: “2.2 urder of D- In the event of a conflict

4、between the text of this apecification and the references cited herein (except for associated detail specifications, specification sheets, MS standards or drawings). the text of this specification shall take precedence, specification. however, shall supersede applicable laws and regulations unless a

5、 specific exemption has been obtained.“ Nothing in this AMSC N/A 1 of 5 FSC 3950 :- Approved for public release: distribution is un1 imi ted. .- Y Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- .e. *I flL-C-hZL35A. (2) 39 999990b 0288i.10 :I MIL-C-

6、62135A(AT) AMENDMENT 2 PAGE 3 *Add new paragraph 3-2.1 as follows: I There are no “3.2.1 reel- requirements for the exclusive use of virgin materials, or reclaimed (recovered) materials is acceptable provided that all other requirements of this specification are met see 6.5-11. The use of recycled P

7、AGE 4 X3.3.1. line 7. after “operations,“. add sentence as follows: “The two part line provided shall be corrosion resistant cable conforming to type I. class 2. 6x19 of RR-W-410. and have a rated breaking strength of not less than 5,000 pounds.“ PAGE 6 *3.9. delete inits entirety and substitute: “3

8、.9 Installationns and owratma manual . The contractors commercial operators manual with a breakdown of his commercial part numbers and installation instruction shall be packaged in a waterproof envelope. and placed in the location specified by the contracting officer see 6.2 and 6-91 .“ PAGE 7 *Add

9、new paragraph 4.1.3 as follows: . All items must meet all “4.1.3 N The inspection set forth in this . requirements of sections 3 and 5. specification shall become a part of the contractors overall inspection system or quality program, The absence of any inspection requirements in the specification s

10、hall not relieve the contractor of the responsibility of assuring that all products or supplies submitted to the Government for acceptance comply with all requirements of the contract, inspection. as part of manufacturing opkrations. is an acceptable practice to ascertain conformance to requirements

11、. however. this does not authorize submission of known defective material. either indicated or actual. nor does it commit the Government to acceptance of defective material.“ Sampling PAGE 10 #4.4.1.4. line 1, delete “(see 6.8)“. 2 . -y Provided by IHSNot for ResaleNo reproduction or networking perm

12、itted without license from IHS-,-,-I, .- ; -. . I !I ! *4.4.1.5. line 1. delete “(see 6.8)“. WAEEZ I. defect number 202. delete “Instructions: and substitute “Installation instructions and operators manual: location. improperly packaged“ - Improper. Not Legible“ Improper PAGE 14 *4.9, delete in its

13、entirety: *EI delete in its entirety and add: “5. PACKAGING 5.1 Presemration.nc. D- - Preservation. packaging. packing, and marking for the desired level shall be in accordance with the applicable packaging requirements specified by the contracting authority ( see 6.2 1. I *6.2, delete item (c) and

14、add new items (c) and (d) as follows: “(cl (d) Location of installation instructions and operators manual. Selection of applicable level and packaging requirements (see 5-11.“ PAGE 15 X6.4. delete and substitute: A crane mission is the loading nd unloading of an “6.4 8 ton palletized cargo from an M

15、877 cargo truck every second mission of the truck. A truck mission and life operational profile are: a. One M877 truck mission shall consist of 100 miles of operation under the following conditions of load. speed. distance. terrain and environment with special tractor and cargo carrying functions de

16、scribed. Terrain Distance Operating speed range MPH 20 miles O - 30 Secondary 40 miles O - 30 Hard surface Level cross country 16 miles Level cross country (mud) 1/ 4 miles Hilly cross country 1/ 20 miles Swimming i/ Traverse water barrier 3 O - 30 o - 10 O - 15 5 minute operation Provided by IHSNot

17、 for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-62135A(AT) AMENDMENT 2 Terrain Distance Operating speed range MPH 60% grades 1/10 of 1% of hilly cross country operation w/o towed load 1/10 of 1% of hilly CMSS country operation w/o towed load. 30% side slopes l/

18、4-Wheel drive: 100% mud and swim. cross country as required. all other operation is in 2-Wheel drive. CLIMATIC EXTlEMES Temperature: -250F to 125OF ambient. Altitude : 500 to 5000 feet. TRACR FUNCTIONS Idle: 30 minutes. starts: One cold. one hot at two minutes. one hot at 15 minutes after shutdown (

19、cold means coolant and oil at ambient. hot at maximum obtained) - Reverse : 10 operations at 130 feet each. Front winch: Once each 10 missions: One overload attempt (110% of rated capacity) followed by recovery of a load at 90% capacity. CARGO CARRYING FUNCTION Operat ion: MHE Crane: 50% of time at

20、i3 ton payload. 25% of time at 4 ton payload, and 25% at no load. 10% with towed load. Load and unload 8 ton palletized cargo everv second miss ion. b. An M877 truck typical life operational profile is: Average speed - 20.0 miles per hour. 1. Renewal life - 25,000 miles or 1250 hours- 2. 3. Total mi

21、ssions - 250. 4. Mission - 100 miles in 5 hours.“ *Add new paragraph 6-5 as follows: . “6.5 Definitions. 6.5 - 1 Becoverod materials “Recovered materials“ means materials that have been collected or recovered from solid waste (see 6-5-21. 4 Provided by IHSNot for ResaleNo reproduction or networking

22、permitted without license from IHS-,-,-I 6.5.2 Colid. “Solid waste“ means (a1 any garbage. refuse. or sludge from a waste treatment plant, water supply treatment plant, or air pollution control facility; and (b) other discarded material, including solid, liquid, semisolid. or contained gaseous mater

23、ial resulting from industrial, commercial. mining, and agricultural operations. and from community activities. It does not include solid or dissolved material in domestic sewage. or solid or dissolved material in irrigation return flows or industrial discharges which are point sources subject to per

24、mits under section 402 of the Clean Water Act. (33 U.S.C. 1342 et seq.1, or some. special nuclear, or byproduct material as defined by the Atomic Energy Act of 1954 (42 U.S.C. 2011 et seq,) (Source: Federal Acquisition Regulations. section 23.402 1. Is PAGE 16 *6.8. line 1. delete “(2) paragraph 6.8

25、 “Ilefinitions of Recurrinaior d MinorDefects.“ and substitute “6.8 Deficiencv-“ *Add new paragraph 6.9 as follows: “6-9 UOs manual I The contracting officer shall specify in the contract the location on the crane for storing the instructions and manual. and the quantity and office symbols of other

26、organizations to be furnished this material (see 3.91.“ Add new paragraph 6-10 as follows: “6.10 Wett term (kev word) Ildaxc. Crane assembly Data plates Radio Interference Suppression Safety features Treatment and painting“ The margins of this amendment are marked with asterisks to indicate where ch

27、anges (additions. modifications. corrections, deletioris) from the previous amendment were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this

28、document based on the entire content irrespective of the marginal notations and relationship to the last previous amendment- Custodian: Army - AT 5 y- Preparing activity: Army - AT ( Proj ect 395O-AO07) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-