ANSI CSA AM Z21.92B-2010 CSA 6.29B-2010 Manually Operated Electric Gas Ignition Systems And Components (Addenda to the First Edition).pdf

《ANSI CSA AM Z21.92B-2010 CSA 6.29B-2010 Manually Operated Electric Gas Ignition Systems And Components (Addenda to the First Edition).pdf》由会员分享，可在线阅读，更多相关《ANSI CSA AM Z21.92B-2010 CSA 6.29B-2010 Manually Operated Electric Gas Ignition Systems And Components (Addenda to the First Edition).pdf（1页珍藏版）》请在麦多课文档分享上搜索。

1、NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.Approved August 27, 2010 by American National Standards Institute, Inc.Approved September 27, 2010 by Interprovincial Advisory Council. Effective in Canada April 1, 2012.Standards DeveolperCSA America, Inc. Canadian St

2、andards Association8501 East Pleasant Valley Road 5060 Spectrum Way, Suite 100Cleveland, Ohio 44131 Mississauga, Ontario, Canada L4W 5N6Published - October 2010 Page 1 of 1Copyright 2010Canadian Standards AssociationPermission is granted to republish material herein in laws or ordinances, and in reg

3、ulations, administrative orders, or similar documents issued by public authorities. Those desiring permission for other republication should consult Canadian Standards Association at 5060 Spectrum Way, Suite 100, Mississauga, Ontario, Canada L4W 5N6.Copyright 2010CSA America, Inc.Permission is grant

4、ed to republish material herein in laws or ordinances, and in regulations, administrative orders, or similar documents issued by public authorities. Those desiring permission for other republication should consult CSA America, Inc. at 8501 East Pleasant Valley Road, Cleveland, Ohio 44131.Addenda to

5、the Fourth EditionANSI Z21.92-2001 CSA 6.29-2001 andANSI Z21.92a-2005 CSA 6.29a-2005American National Standard/CSA Standard ForManually Operated Electric Gas Ignition Systems And Components ANSI Z21.92b-2010CSA 6.29b-2010Part III Manufacturing And Production TestsThe manufacturer shall submit to the

6、 certifying agency a plan which is mutually acceptable to the manufacturer and certifying agency and which describes the programs and test procedures specified in 3.1 and 3.2 and the records to be kept by the manufacturer.3.1The manufacturer shall use a program to qualify raw materials, parts, assem

7、blies and purchased components.3.2The manufacturer shall use a program which includes a mutually acceptable schedule(s) to conduct the following tests as applicable. The manufacturer shall submit to the certifying agency a description of the test procedures used during production testing.a. Arc-Overs;b. Ignition;c. Endurance; andd. Dielectric strength.