IEC TR 60725-2012 Consideration of reference impedances and public supply network impedances for use in determining the disturbance characteristics of electrica.pdf

《IEC TR 60725-2012 Consideration of reference impedances and public supply network impedances for use in determining the disturbance characteristics of electrica.pdf》由会员分享，可在线阅读，更多相关《IEC TR 60725-2012 Consideration of reference impedances and public supply network impedances for use in determining the disturbance characteristics of electrica.pdf（62页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC/TR 60725 Edition 3.0 2012-06 TECHNICAL REPORT RAPPORT TECHNIQUE Consideration of reference impedances and public supply network impedances for use in determining the disturbance characteristics of electrical equipment having a rated current 75 A per phase tude des impdances de rfrence et des im

2、pdances des rseaux publics dalimentation aux fins de la dtermination des caractristiques de perturbation des quipements lectriques utilisant un courant nominal 75 A par phase IEC/TR 60725:2012 THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2012 IEC, Geneva, Switzerland All rights reserved. Unless

3、 otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have an

4、y questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication

5、 ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous

6、dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch Abo

7、ut the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant revie

8、w by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Useful links: IEC publications search - www.iec.ch/searchpub The advanced search enables you to find IEC publications by a variety of criteria (reference number, text, technical c

9、ommittee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available on-line and also once a month by email. Electropedia

10、 - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary (IEV) on-line. Customer

11、Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et p

12、ublie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amen

13、dement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.iec.ch/searchpub La recherche avance vous permet de trouver des publications CEI en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications

14、 remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications de la CEI. Just Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier diction

15、naire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (VEI) en ligne. Service Clients - websto

16、re.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC/TR 60725 Edition 3.0 2012-06 TECHNICAL REPORT RAPPORT TECHNIQUE Consideration of reference impedances and public supply network impedances for use in determini

17、ng the disturbance characteristics of electrical equipment having a rated current 75 A per phase tude des impdances de rfrence et des impdances des rseaux publics dalimentation aux fins de la dtermination des caractristiques de perturbation des quipements lectriques utilisant un courant nominal 75 A

18、 par phase INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE U ICS 33.100.01 PRICE CODE CODE PRIX ISBN 978-2-83220-161-9 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Mak

19、e sure that you obtained this publication from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. 2 TR 60725 IEC:2012 CONTENTS FOREWORD . 4 1 Scope . 6 2 Normative references . 6 3 Systems of low-voltage supply 6 Three-phase su

20、pply systems . 6 3.1Single-phase two-wire supply systems 7 3.2Single-phase three-wire supply systems 7 3.3 4 Supply impedances 7 Typical residential premises 7 4.1Large residential, commercial and light industrial premises . 10 4.2General . 10 4.2.1Supply impedance relevant to the connection of thre

21、e-phase 4.2.2 equipment . 11 Supply impedances relevant to the connection of single-phase 4.2.3 equipment . 11 5 Reference impedances . 12 General . 12 5.1Reference impedances for equipment with current ratings 16 A . 12 5.2Overview . 12 5.2.150 Hz and 60 Hz low-voltage supply systems 13 5.2.2Refere

22、nce impedance for 50 Hz and 60 Hz equipment with current ratings 5.3 16 A and 75 A per phase . 15 6 Impedance at frequencies above the supply frequency . 15 Annex A (informative) Methods for determining the maximum modulus values of public electricity supply low-voltage network impedances relevant t

23、o three-phase services of more than 100 A per phase at 50 Hz . 16 Annex B (informative) Methods for determining the maximum modulus values of public electricity supply low-voltage network impedances relevant to three-phase services of more than 100 A per phase at 60 Hz . 24 Annex C (informative) Mea

24、surement of supply impedance and survey method . 26 Bibliography 29 Figure 1 Representation of a single-phase three-wire supply system . 7 Figure A.1 Model used for determining the impedance of a network line conductor from a transformer to a three-phase service cut-out 18 Figure A.2 Three-phase imp

25、edance diagram of a typical 500 kVA transformer and mains cable 19 Figure B.1 Model used for determining the impedance of a network line conductor from a transformer to a three-phase service cut-out 24 Figure C.1 Measurement of impedance at a customers premises 27 Table 1 Residential consumers compl

26、ex supply impedances at 50 Hz . 8 Table 2 Single-phase device capacities 100 A per phase . 9 Table 3 Three-phase service capacities 100 A per phase . 9 TR 60725 IEC:2012 3 Table 4 Single or two-phase service capacities 100 A per phase 10 Table 5 Three-phase service capacities 100 A per phase . 10 Ta

27、ble 6 Modulus values of supply impedance, in ohms at 50 Hz, relevant to the connection of three-phase equipment and having a 95 % probability of not being exceeded 11 Table 7 Modulus values of supply impedance, in ohms at 50 Hz, relevant to the connection of single-phase equipment and having a 95 %

28、probability of not being exceeded 12 Table 8 Reference impedances for testing purposes 13 Table 9 Reference impedances for 100 V/200 V and 120 V/240 V supply systems 100 A 14 Table 10 Reference impedances for 200 V to 240 V supply systems 100 A 14 Table 11 Reference impedances for 200 V to 240 V sup

29、ply systems, 100 A per phase . 15 Table 12 Reference impedances for testing purposes, for 200 V to 240 V supply systems, 100 A . 15 Table A.1 Modulus values of the maximum supply impedance, in ohms, of the line- conductors of 230 V/400 V, 50 Hz, public electricity supply networks, relevant to three-

30、phase services having service capacities of 200 A per phase 21 Table A.2 Modulus values of the maximum supply impedance, in ohms, of the line and neutral conductors of 230 V/400 V, 50 Hz, public electricity supply networks, relevant to three-phase services having service capacities of 200 A per phas

31、e . 22 Table C.1 Impedance values for copper conductor installation wiring . 28 4 TR 60725 IEC:2012 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ CONSIDERATION OF REFERENCE IMPEDANCES AND PUBLIC SUPPLY NETWORK IMPEDANCES FOR USE IN DETERMINING THE DISTURBANCE CHARACTERISTICS OF ELECTRICAL EQUIPMENT HA

32、VING A RATED CURRENT 75 A PER PHASE FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questio

33、ns concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)

34、”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC also participate in this preparation. IEC collab

35、orates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on

36、 the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure

37、that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to th

38、e maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification b

39、odies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach

40、to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) a

41、nd expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication.

42、9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. The main task of IEC technical committees is to prepare International Standards. However, a

43、 technical committee may propose the publication of a technical report when it has collected data of a different kind from that which is normally published as an International Standard, for example “state of the art“. IEC 60725, which is a technical report, has been prepared by subcommittee 77A: EMC

44、 Low frequency phenomena, of IEC technical committee 77: Electromagnetic compatibility. This third edition cancels and replaces the second edition, published in 2005, and constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous

45、edition: new survey and other data from countries having public supply networks operating at 60 Hz have been included; recommendations that were applicable to 50 Hz systems are now mirrored by new recommendations that are relevant to 60 Hz systems. TR 60725 IEC:2012 5 The text of this technical repo

46、rt is based on the following documents: Enquiry draft Report on voting 77A/784/DTR 77A/789/RVC Full information on the voting for the approval of this technical report can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC

47、Directives, Part 2. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn

48、, replaced by a revised edition, or amended. 6 TR 60725 IEC:2012 CONSIDERATION OF REFERENCE IMPEDANCES AND PUBLIC SUPPLY NETWORK IMPEDANCES FOR USE IN DETERMINING THE DISTURBANCE CHARACTERISTICS OF ELECTRICAL EQUIPMENT HAVING A RATED CURRENT 75 A PER PHASE 1 Scope This Technical Report records the i

49、nformation that was available and the factors that were taken into account in arriving at the reference impedances that were incorporated in IEC 60555 and which are now incorporated in some parts of IEC 61000-3. In addition, information is given on the impedances of public supply networks associated with service current capacities 100 A per phase. 2 Normative references The following docu