IEC 61157 Edition 2.1-2013 Standard means for the reporting of the acoustic output of medical diagnostic ultrasonic equipment《医用超声诊断设备的声学输出报告用标准平均值》.pdf

《IEC 61157 Edition 2.1-2013 Standard means for the reporting of the acoustic output of medical diagnostic ultrasonic equipment《医用超声诊断设备的声学输出报告用标准平均值》.pdf》由会员分享，可在线阅读，更多相关《IEC 61157 Edition 2.1-2013 Standard means for the reporting of the acoustic output of medical diagnostic ultrasonic equipment《医用超声诊断设备的声学输出报告用标准平均值》.pdf（72页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 61157 Edition 2.1 2013-01 INTERNATIONAL STANDARD NORME INTERNATIONALE Standard means for the reporting of the acoustic output of medical diagnostic ultrasonic equipment Critres normaliss de dclaration des missions acoustiques des appareils de diagnostic mdical ultrasons IEC61157:2007+A1:2013 co

2、lourinsideTHIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2013 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without pe

3、rmission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee

4、for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de la CEI o

5、u du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pays de rsidence. IEC Central Office

6、Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic an

7、d related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Useful links: IEC publications search - www.iec.ch/searchpub T

8、he advanced search enables you to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications.

9、 Just Published details all new publications released. Available on-line and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms and definitions in English and French, with equivalen

10、t terms in additional languages. Also known as the International Electrotechnical Vocabulary (IEV) on-line. Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. A prop

11、os de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publications CEI Le contenu technique des publications

12、de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.iec.ch/searchpub La recherche avance vous permet de trouver des publications CEI en utilisant diffrents cr

13、itres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications de la CEI. Just Published dtaille les nouvelles publications par

14、ues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en franais, ainsi que les termes quivalents dans les langue

15、s additionnelles. Egalement appel Vocabulaire Electrotechnique International (VEI) en ligne. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec.ch. IEC 61157 Edition 2.1 2013-01 INTERNATIONAL ST

16、ANDARD NORME INTERNATIONALE Standard means for the reporting of the acoustic output of medical diagnostic ultrasonic equipment Critres normaliss de dclaration des missions acoustiques des appareils de diagnostic mdical ultrasons INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE I

17、NTERNATIONALE ICS 11.040.50, 17.140.50 ISBN 978-2-8322-0634-8 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention! Veuillez

18、vous assurer que vous avez obtenu cette publication via un distributeur agr. colourinside 2 61157 IEC:2007+A1:2013 CONTENTS FOREWORD . 3 INTRODUCTION . 5 1 Scope . 6 2 Normative references . 6 3 Terms, definitions and symbols 6 4 Requirements . 17 4.1 General . 17 4.2 Requirements for the reporting

19、of acoustic output information . 19 4.2.1 Technical data sheets information format 19 4.2.2 Detailed operating mode data sheets information format . 19 4.2.3 Background information . 21 4.2.4 Diagnostic fields in the absence of scan-frame synchronization . 22 4.2.5 Dataset for low acoustic output eq

20、uipment . 22 5 Compliance statement 22 5.1 General . 22 5.2 Maximum probable values . 23 5.3 Sampling . 23 6 Test methods . 23 7 Presentation of results 23 Annex A (normative) Presentation of acoustic output information . 24 Annex B (informative) Reporting requirements for extensive systems 26 Annex

21、 C (informative) Rationale 27 Index of defined terms 31 Bibliography 33 Figure C.1 Schematic diagram showing the relationship between the various defined surfaces and distances for a mechanical sector scanner with water stand-off distance when applied to a patient 28 Figure C.2 Schematic diagram sho

22、wing the relationship between the various defined parameters and distances for a mechanical sector scanner during the measurement of acoustic output . 28 Figure C.3 Schematic diagram showing various defined parameters associated with the distribution of the scan lines in a linear array scanner and m

23、echanically-scanned sector scanner 29 Figure C.4 Schematic diagram illustrating the peak-rarefactional acoustic pressure during an acoustic pulse . 30 Table 1 List of symbols 16 Table A.1 An example of reporting of the acoustic output of a 3,5 MHz scan-head for a phased-array sector scanner in accor

24、dance with this standard 25 61157 IEC:2007+A1:2013 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ STANDARD MEANS FOR THE REPORTING OF THE ACOUSTIC OUTPUT OF MEDICAL DIAGNOSTIC ULTRASONIC EQUIPMENT FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standard

25、ization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes Intern

26、ational Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate

27、in this preparatory work. International, governmental and non-governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between th

28、e two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications hav

29、e the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misi

30、nterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding natio

31、nal or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services c

32、arried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National

33、Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is dra

34、wn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not

35、 be held responsible for identifying any or all such patent rights. This consolidated version of IEC 61157 consists of the second edition (2007) documents 87/356/CDV and 87/374/RVC, its amendment 1 (2013) documents 87/517/FDIS and 87/523/RVD and its corrigendum of August 2008. It bears the edition n

36、umber 2.1. The technical content is therefore identical to the base edition and its amendment and has been prepared for user convenience. A vertical line in the margin shows where the base publication has been modified by amendment 1. Additions and deletions are displayed in red, with deletions bein

37、g struck through. 4 61157 IEC:2007+A1:2013 International Standard IEC 61157 has been prepared by IEC technical committee 87: Ultrasonics. The changes with respect to the previous edition are listed below: maintenance on this standard and the referenced standards IEC 61161 and IEC 62127-1. a clause o

38、n compliance has been added. This bilingual version (2012-06) corresponds to the monolingual English version, published in 2007-08. The French version of this standard has not been voted upon. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. NOTE The following pri

39、nt types are used: Requirements: in roman type Test specifications: in italic type Notes: in small roman type Words in bold in the text are defined in Clause 3. The committee has decided that the contents of the base publication and its amendments will remain unchanged until the stability date indic

40、ated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTANT The “colour inside” logo on the cover page of this publication indicates that it

41、contains colours which are considered to be useful for the correct understanding of its contents. Users should therefore print this publication using a colour printer. 61157 IEC:2007+A1:2013 5 INTRODUCTION This International Standard specifies a standard means and format for the reporting of the aco

42、ustic output of medical diagnostic ultrasonic equipment. The numerical values for reporting purposes represent the average values for the maximum output conditions for a given discrete- or combined-operating mode and are derived from measurements made in water. Intensity parameters are specified in

43、this standard, but these are regarded as derived quantities that are meaningful only under certain assumptions related to the ultrasonic field being measured. 6 61157 IEC:2007+A1:2013 STANDARD MEANS FOR THE REPORTING OF THE ACOUSTIC OUTPUT OF MEDICAL DIAGNOSTIC ULTRASONIC EQUIPMENT 1 Scope This Inte

44、rnational Standard is applicable to medical diagnostic ultrasonic equipment. It provides a set of traceable acoustic parameters describing the acoustic fields. It defines a standard means and format for the reporting of the acoustic output information. It also describes a reduced dataset recommended

45、 for equipment generating low acoustic output levels. NOTE The information tabulated in this standard format can be used for a) exposure planning for biological effects studies; b) exposure data for prospective epidemiological studies conducted using exposure conditions similar to those reported in

46、this standard. In the absence of actual exposure data for retrospective epidemiological studies, the information tabulated in this standard format might also be used with cautionary comment. 2 Normative references The following referenced documents are indispensable for the application of this docum

47、ent. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60050-801:1994, International Electrotechnical Vocabulary Chapter 801: Acoustics and electroacoustics IEC 60050-802, International

48、Electrotechnical Vocabulary Chapter 802: Ultrasonics IEC 61161, Ultrasonics Power measurement Radiation force balances and performance requirements IEC 62127-1:2007, Ultrasonics Hydrophones Part 1: Measurement and characterization of medical ultrasonic fields up to 40 MHz Amendment 1:2013 ISO 16269-

49、6:2005, Statistical interpretation of data Part 6: Determination of statistical tolerance intervals ISO/IEC Guide 98:1995, Guide to the expression of uncertainty in measurement (GUM) ISO/IEC Guide 98-3, Uncertainty of measurement Part 3: Guide to the expression of uncertainty in measurement (GUM:1995) 3 Terms, definitions and symbols For the purposes of this document, the terms and definitions given in IEC