GMKOREA EDS-T-4523-2008 THE TEST PROCEDURE OF REAR SEAT BACK FRONTWARD LOADING STRENGTH.pdf

《GMKOREA EDS-T-4523-2008 THE TEST PROCEDURE OF REAR SEAT BACK FRONTWARD LOADING STRENGTH.pdf》由会员分享，可在线阅读，更多相关《GMKOREA EDS-T-4523-2008 THE TEST PROCEDURE OF REAR SEAT BACK FRONTWARD LOADING STRENGTH.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、GM DAEWOO Auto & Technology EDS Engineering, GM DAEWOO Auto & Technology Standards THE TEST PROCEDURE OF REAR SEAT BACK FRONTWARD LOADING STRENGTH Do Not Use on New Programs. Being Replaced by GMW 14601&GMW15785 EDS-T-4523 ISSUED DATE: 1998. 05. 30 REVISED DATE: 2008. 10. 15 VERSION: 3 (Superceded)

2、EDS-T-4523THE TEST PROCEDURE OF REAR SEAT BACK FRONTWARD LOADING STRENGTH PAGE: 1/2 ISSUED DATE: 1998. 05. 30 REVISED DATE: 2008. 10. 15 VERSION: 3 GM DAEWOO Auto & Technology Note: This standard may be applied only for current project (incl. T255 Program). It is Superceded for all future projects a

3、nd replaced by GMW14601 & GMW15785. 1. PURPOSE This standard aims at determining the frontward loading strength of the rear seat back when trunk is loaded. 2. SCOPE This standard applies to the rear seat of the vehicle whose rear seat back is loaded. 3. TEST SAMPLES At least 3 new seat assemblies sh

4、all be tested. 4. TEST EQUIPMENT AND JIG 4.1. Jig or BIW with which to fix the seat in the vehicle condition 4.2. Groove plate 4.3. Loading device It shall be capable of loading and measuring with accuracy not exceeding 0.5Kgf. 4.4. Loading jig Un-deformed 100mm thick plate with width larger than se

5、at back width 5. TEST METHOD AND SPECIFICATIONS 5.1. Test preparation 5.1.1. Fix the seat fixture jig onto the groove plate and install the seat onto the jig. 5.1.2. Fix the seat at design standard point 5.2. Test procedure 5.2.1. As shown in Fig 1, install the loading jig to the mid point between t

6、he rear seat back upper end and trunk floor and apply load as in 5.2.2. 5.2.2. Loading shall be as follows: F = (GVW - CVW - P) 0.88 GVW : maximum allowable weight (Kgf) CVW : curb weight (Kgf) F : Applied load (Kgf) EDS-T-4523THE TEST PROCEDURE OF REAR SEAT BACK FRONTWARD LOADING STRENGTH PAGE: 2/2 ISSUED DATE: 1998. 05. 30 REVISED DATE: 2008. 10. 15 VERSION: 3 GM DAEWOO Auto & Technology P : No. of occupants on front seat 70 (Kgf) Figure 1 5.3. Evaluation 5.3.1. No troubles or dismantling at the rock device. 5.3.2. No projection harmful to occupants