FORD WSS-M1H915-A-2008 FABRIC TERRA DESIGN PILE KNITTED UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《TERRA图案的不分层长毛绒针织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

《FORD WSS-M1H915-A-2008 FABRIC TERRA DESIGN PILE KNITTED UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《TERRA图案的不分层长毛绒针织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf》由会员分享，可在线阅读，更多相关《FORD WSS-M1H915-A-2008 FABRIC TERRA DESIGN PILE KNITTED UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《TERRA图案的不分层长毛绒针织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 08 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2002 10 31 Activated N. J. Komatsu Printed copies are uncontrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, TE

2、RRA DESIGN, PILE KNITTED, WSS-M1H915-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a weft knitted jacquard 28 gauge polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for 2

3、003 C195. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. Material specification requirements are to be used for initial qualification of materials. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Materi

4、al suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10 % tolerance (ASTM D 3887) Wales 115 wales/10 cm Courses 260 courses/10 cm 3.2.2 Fabric Weight, +/- 15 % tolerance 310 g/m2(

5、FLTM BN 106-01) 3.3 COMPOSITION (ASTM D 629) Fabric 100 % polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Ground 167 dtex f72 (polyester, filament yarn, round, semi-dull) Pile 89 dtex f34 (polyester, texturized, round, semi-dull) ENGINEERING MATERIAL SPECIFICATION WSS-M1H915-A Page 2 of 2 Copyright 20

6、08, Ford Global Technologies, Inc. 3.5 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.6 FINISHING OPERATIONS As approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.