FORD SB1-8-1988 LEATHER GLOVE FOR GLASS PLANT《玻璃厂用皮手套》.pdf

《FORD SB1-8-1988 LEATHER GLOVE FOR GLASS PLANT《玻璃厂用皮手套》.pdf》由会员分享，可在线阅读，更多相关《FORD SB1-8-1988 LEATHER GLOVE FOR GLASS PLANT《玻璃厂用皮手套》.pdf（2页珍藏版）》请在麦多课文档分享上搜索。

1、FORD HANUFACTURING STANDARDS 81-8 JULY, 1988 LEATHER GLOVE FOR GLASS PLANT Sel-8 Page I 1. 2. 2.1 2.2 2.3 I 2.4 2.5 3. SIZE - HENS: 4. - 4.1 4.2 5. USAGE: The safety unit must approve this glove prior to usage. hATERI AL: Select No.1 thermal chrome tanned side split cowhide in 3-l/2 to 4 ounce weigh

2、t per square foot on palm. thumb saddle and cuff patch. Select No.1 thermal chrome tanned side split cowhide in 3 to 3-l/2 ounce weight per squar.e foot on backs of 2nd, 3rd and 4th fingers. Cuff No.1 chrome tannad side split cowhide in 4 to 4-l/t-ounce weight per square foot. Thread must be of 30/4

3、 Kevlar. Hatcrial entering into the manufacture of this glove must be of such quality as to produce a glove which will be impervious to normal dry c 1 ean i ng processes. Hinimum length-from tip of middle finger to base of cuff Width of palm at thumb crotch Wi.dth of palm reinforcement Size of cuff

4、patch to be Minimum cuff length 8 inches (203mm) 5-l/4 i nches (133mm) l-5/8 i nthes ( 4lmm) C-1/2 x l-3/4 inches (114 x 44mm) 2-l/2 i nches ( 63mm) CONSTRUCfl ON: Clute pattern with continuous thumb and back seams joined outseam. The special design of the one piece patch is to be secureLy sewn to t

5、he cover face of.the thumb with the index finger crossing the palm . and wrapping around the index finger for l-1/4 inches (31mm). Tht.cuff must be banded with double stitching row to glove body outseam wi th the cuff patch inserted between the cuff and the glove face. SUPPLIERS RESPONSIBILITY: All

6、material supplied to this standard must be equivalent in all characteristics to the material upon which approval was originally granted, and shall be satisfactory for the intended application. FORD HANUFACTURING STANDARDS SBl-8 JULY, 1988 LEATHER GLOVE FOR GLASS PLANT SBl-8 Page 2 6. APPROVAL OF NEW

7、 SUPPLIERS: 6.1 I I I 6.2 Pricing of gloves from proposed new suppliers should be determined to be cost competitive by Purchasing and Supply Staff prior to obtaining laboratory and shop trial approvals. After the product has been determined to be cost competitive, gloves submitted by new manufacture

8、rs to this standard and concluded to be cost competitive must have laboratory and shop trial approvals. Recommendations for the addition of new manufacturers to the Manufacturing Approved Source List (ASL) must be made by the appropriate division standards activity in writing to the Plant Engineering Office, Hanufacturing Staff. All supporting data must accompany the written request. The Plant Engineering Office, nanufacturing Staff, and the Environmental Health and Safety Hanager, Employee Relations Staff, wi 11 review requests to determine approval