DLA SMD-5962-00506 REV C-2013 MICROCIRCUIT DIGITAL LOW VOLTAGE CMOS QUADRUPLE 2-LINE TO 1-LINE DATA SELECTOR MULTIPLEXER MONOLITHIC SILICON.pdf
《DLA SMD-5962-00506 REV C-2013 MICROCIRCUIT DIGITAL LOW VOLTAGE CMOS QUADRUPLE 2-LINE TO 1-LINE DATA SELECTOR MULTIPLEXER MONOLITHIC SILICON.pdf》由会员分享,可在线阅读,更多相关《DLA SMD-5962-00506 REV C-2013 MICROCIRCUIT DIGITAL LOW VOLTAGE CMOS QUADRUPLE 2-LINE TO 1-LINE DATA SELECTOR MULTIPLEXER MONOLITHIC SILICON.pdf(15页珍藏版)》请在麦多课文档分享上搜索。
1、 REVISIONS LTR DESCRIPTION DATE (YR-MO-DA) APPROVED A Make corrections to table I minimum propagation delay times at 2.7 V. Update boilerplate to MIL-PRF-38535 requirements. jak 00-12-12 Thomas M. Hess B Update boilerplate to MIL-PRF-38535 requirements. LTG 07-10-24 Thomas M. Hess C Update boilerpla
2、te paragraphs to the current MIL-PRF-38535 requirements. - LTG 13-01-25 Thomas M. Hess REV SHEET REV SHEET REV STATUS REV B B B B B B B B B B B B B B OF SHEETS SHEET 1 2 3 4 5 6 7 8 9 10 11 12 13 14 PMIC N/A PREPARED BY Joseph A. Kerby DLA LAND AND MARITIME COLUMBUS, OHIO 43218-3990 http:/www.landan
3、dmaritime.dla.mil STANDARD MICROCIRCUIT DRAWING THIS DRAWING IS AVAILABLE FOR USE BY ALL DEPARTMENTS AND AGENCIES OF THE DEPARTMENT OF DEFENSE AMSC N/A CHECKED BY Charles F. Saffle, Jr. APPROVED BY Monica L. Poelking MICROCIRCUIT, DIGITAL, LOW VOLTAGE CMOS, QUADRUPLE 2-LINE TO 1-LINE DATA SELECTOR/M
4、ULTIPLEXER, MONOLITHIC SILICON DRAWING APPROVAL DATE 00-07-11 REVISION LEVEL C SIZE A CAGE CODE 67268 5962-00506 SHEET 1 OF 14 DSCC FORM 2233 APR 97 5962-E213-13 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 596
5、2-00506 DLA LAND AND MARITIME COLUMBUS, OHIO 43218-3990 REVISION LEVEL C SHEET 2 DSCC FORM 2234 APR 97 1. SCOPE 1.1 Scope. This drawing documents two product assurance class levels consisting of high reliability (device class Q) and space application (device class V). A choice of case outlines and l
6、ead finishes are available and are reflected in the Part or Identifying Number (PIN). When available, a choice of Radiation Hardness Assurance (RHA) levels is reflected in the PIN. 1.2 PIN. The PIN is as shown in the following example: 5962 - 00506 01 Q E A Federal stock class designator RHA designa
7、tor (see 1.2.1) Device type (see 1.2.2) Device class designator Case outline (see 1.2.4) Lead finish (see 1.2.5) / (see 1.2.3) / Drawing number 1.2.1 RHA designator. Device classes Q and V RHA marked devices meet the MIL-PRF-38535 specified RHA levels and are marked with the appropriate RHA designat
8、or. A dash (-) indicates a non-RHA device. 1.2.2 Device type(s). The device type(s) identify the circuit function as follows: Device type Generic number Circuit function 01 54LVC157A 2-line to 1-line data selector/multiplexer 1.2.3 Device class designator. The device class designator is a single let
9、ter identifying the product assurance level as follows: Device class Device requirements documentation Q or V Certification and qualification to MIL-PRF-38535 1.2.4 Case outline(s). The case outline(s) are as designated in MIL-STD-1835 and as follows: Outline letter Descriptive designator Terminals
10、Package style E GDIP1-T16 or CDIP2-T16 16 Dual-in-line F GDFP2-F16 or CDFP3-F16 16 Flat pack 2 CQCC1-N20 20 Square leadless chip carrier 1.2.5 Lead finish. The lead finish is as specified in MIL-PRF-38535 for device classes Q and V. Provided by IHSNot for ResaleNo reproduction or networking permitte
11、d without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 5962-00506 DLA LAND AND MARITIME COLUMBUS, OHIO 43218-3990 REVISION LEVEL C SHEET 3 DSCC FORM 2234 APR 97 1.3 Absolute maximum ratings. 1/ 2/ 3/ Supply voltage range (VCC) -0.5 V dc to +6.5 V dc DC input voltage range (VIN) -0.5 V d
12、c to +6.5 V dc 4/ DC output voltage range (VOUT) . -0.5 V dc to VCC+ 0.5 V dc 4/ 5/ Input clamp current (IIK) (VINVCC) . -50 mA Continuous output current (IO) . 50 mA Continuous current through VCCor GND . 100 mA Maximum power dissipation at TA= +55C (in still air) (PD) . 550 mW 6/ Storage temperatu
13、re range (TSTG) . -65C to +150C Lead temperature (soldering, 10 seconds) +300C Thermal resistance, junction-to-case (JC) . See MIL-STD-1835 Junction temperature (TJ) +150C 1.4 Recommended operating conditions. 2/ 3/ 7/ Supply voltage range (VCC): Operating . +2.0 V dc to +3.6 V dc Data retention onl
14、y . +1.5 V dc Minimum high level input voltage (VIH): VCC= 2.7 V to 3.6 V . +2.0 V Maximum low level input voltage (VIL): VCC= 2.7 V to 3.6 V +0.8 V Input voltage range (VIN) +0.0 V dc to 5.5 V dc Output voltage range (VOUT). +0.0 V dc to VCCMaximum high level output current (IOH): VCC= 2.7 V -12 mA
15、 VCC= 3.0 V -24 mA Maximum low level output current (IOL): VCC= 2.7 V +12 mA VCC= 3.0 V +24 mA Input transition rise or fall rate (t/V):. 0.0 to 10.0 ns/V Case operating temperature range (TC) . -55C to +125C _ 1/ Stresses above the absolute maximum rating may cause permanent damage to the device. E
16、xtended operation at the maximum levels may degrade performance and affect reliability. 2/ Unless otherwise noted, all voltages are referenced to GND. 3/ The limits for the parameters specified herein shall apply over the full specified VCCrange and case temperature range of -55C to +125C. 4/ The in
17、put and output negative-voltage ratings may be exceeded provided that the input and output clamp-current ratings are observed. 5/ The value of VCCis provided in the recommended operating conditions table. 6/ The maximum package power dissipation is calculated using a junction temperature of 150C and
18、 a board trace length of 750 mils. 7/ Unused inputs must be held high or low to prevent them from floating. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 5962-00506 DLA LAND AND MARITIME COLUMBUS, OHIO 43218-399
19、0 REVISION LEVEL C SHEET 4 DSCC FORM 2234 APR 97 2. APPLICABLE DOCUMENTS 2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents
20、 are those cited in the solicitation or contract. DEPARTMENT OF DEFENSE SPECIFICATION MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for. DEPARTMENT OF DEFENSE STANDARDS MIL-STD-883 - Test Method Standard Microcircuits. MIL-STD-1835 - Interface Standard Electronic Componen
21、t Case Outlines. DEPARTMENT OF DEFENSE HANDBOOKS MIL-HDBK-103 - List of Standard Microcircuit Drawings. MIL-HDBK-780 - Standard Microcircuit Drawings. (Copies of these documents are available online at https:/assist.dla.mil/quicksearch/ or from the Standardization Document Order Desk, 700 Robbins Av
22、enue, Building 4D, Philadelphia, PA 19111-5094.) 2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a spe
23、cific exemption has been obtained. 3. REQUIREMENTS 3.1 Item requirements. The individual item requirements for device classes Q and V shall be in accordance with MIL-PRF-38535 as specified herein, or as modified in the device manufacturers Quality Management (QM) plan. The modification in the QM pla
24、n shall not affect the form, fit, or function as described herein. 3.2 Design, construction, and physical dimensions. The design, construction, and physical dimensions shall be as specified in MIL-PRF-38535 and herein for device classes Q and V. 3.2.1 Case outlines. The case outlines shall be in acc
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLASMD596200506REVC2013MICROCIRCUITDIGITALLOWVOLTAGECMOSQUADRUPLE2LINETO1LINEDATASELECTORMULTIPLEXERMONOLITHICSILICONPDF

链接地址:http://www.mydoc123.com/p-698172.html