ASTM D5324-2016 Standard Guide for Testing Water-Borne Architectural Coatings《水性建筑涂料试验的标准指南》.pdf
《ASTM D5324-2016 Standard Guide for Testing Water-Borne Architectural Coatings《水性建筑涂料试验的标准指南》.pdf》由会员分享,可在线阅读,更多相关《ASTM D5324-2016 Standard Guide for Testing Water-Borne Architectural Coatings《水性建筑涂料试验的标准指南》.pdf(13页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D5324 10D5324 16Standard Guide forTesting Water-Borne Architectural Coatings1This standard is issued under the fixed designation D5324; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A numbe
2、r in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This guide covers the selection and use of procedures for testing water-borne coatings to be used on exterior, interior or bothtypes of surf
3、aces (Note 1). The properties that can be examined or, in some cases, the relevant test procedures are listed in Table1Table 1 and Table 2. Table 2.NOTE 1The term “architectural coating” as used here combines the definition in Terminology D16 with that in the FSCT Paint/Coatings Dictionary,2,as foll
4、ows: “Organic coatings intended for on-site application to interior or exterior surfaces of residential, commercial, institutional, or industrialbuildings, in contrast to industrial coatings. They are protective and decorative finishes applied at ambient temperatures. Often called Trade SalesCoating
5、s.”NOTE 2Architectural coatings that are designed to give better performance than most conventional coatings because they are tougher and more stainand abrasion resistant are covered by Guide D3730.1.2 The types of organic coatings covered by this guide are as follows:(1) Type 1 Interior Latex Flat
6、Wall Paints,(1) Type 1 Interior Latex Flat Wall Paints,(2) Type 2 Exterior Latex House Paints,(3) Type 3 Water-Borne Floor Paints, and(4) Type 4 Interior Latex Semigloss and Gloss Paints.(2) Type 2 Exterior Latex House Paints,(3) Type 3 Water-Borne Floor Paints, and(4) Type 4 Interior Latex Semiglos
7、s and Gloss Paints.1.2.1 Each is intended for application by brushing, rolling, spraying or other means to the material appropriate for its type,which may include plaster, masonry, wallboard, wood, steel, previously painted surfaces, and other architectural substrates.1.3 The values stated in SI uni
8、ts are to be regarded as the standard. The values given in parentheses are for information only.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibilityof the user of this standard to establish appropriate safety and health p
9、ractices and determine the applicability of regulatorylimitations prior to use.2. Referenced Documents2.1 ASTM Standards:3D16 Terminology for Paint, Related Coatings, Materials, and ApplicationsD185 Test Methods for Coarse Particles in PigmentsD215 Practice for the Chemical Analysis of White Linseed
10、 Oil Paints (Withdrawn 2005)4D344 Test Method for Relative Hiding Power of Paints by the Visual Evaluation of BrushoutsD358 Specification for Wood to Be Used as Panels in Weathering Tests of Coatings (Withdrawn 2014)4D522 Test Methods for Mandrel Bend Test of Attached Organic CoatingsD523 Test Metho
11、d for Specular GlossD562 Test Method for Consistency of Paints Measuring Krebs Unit (KU) Viscosity Using a Stormer-Type Viscometer1 This guide is under the jurisdiction ofASTM Committee D01 on Paint and Related Coatings, Materials, andApplications and is the direct responsibility of SubcommitteeD01.
12、42 on Architectural Coatings.Current edition approved Dec. 1, 2010Dec. 1, 2016. Published December 2010February 2017. Originally approved in 1992. Last previous edition approved in 20032010as D5324 03.D5324 10. DOI: 10.1520/D5324-10.10.1520/D5324-16.2 Available from Federation of Societies for Coati
13、ngs Technology (FSCT), 492 Norristown Rd., Blue Bell, PA 19422-2350, http:/www.coatingstech.org.3 For referencedASTM standards, visit theASTM website, www.astm.org, or contactASTM Customer Service at serviceastm.org. For Annual Book of ASTM Standardsvolume information, refer to the standards Documen
14、t Summary page on the ASTM website.4 The last approved version of this historical standard is referenced on www.astm.org.This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Becauseit
15、may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current versionof the standard as published by ASTM is to be considered the official document.Copyright ASTM International, 100 Barr Ha
16、rbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States1TABLE 1 List of Standards in Sectional OrderProperty (or related test) Section ASTMStandard Federal Test MethodStandard 141DSampling 6.2 D3925Liquid Coating PropertiesCondition in container 7.1 3011Coarse particles and foreign
17、matter 7.2 D185Density or weight per gallon 7.3 D1475Fineness of dispersion 7.4 D1210Odor 7.5 D1296Colorant acceptance 7.6 D5326pH 7.7 E70Package stability 7.8Heat stability 7.8.1 D1849Freeze-thaw stability 7.8.2 D2243Settling 7.8.3 D869Microorganism resistance 7.8.4 D2574, D3273Coating Application
18、and Film FormationApplication properties 8.1Brush application 8.1.1 D5068Brush drag 8.1.1.1 D4958Roller application 8.1.2 2112Roller spatter 8.1.2.1 D4707Spray application 8.1.3 2131Touch-up uniformity 8.2 D3928, D7489Low-temperature coalescence 8.3 D3793, D7306Rheological properties 8.4Consistency
19、(Low-shear viscosity) 8.4.1 D562Rheological properties of non-Newtonian materials 8.4.2 D2196, D4287Sag resistance 8.4.3 D4400 4494Levelling properties 8.4.4 D4062Drying properties 8.5 D1640, D5895Wet-to-Dry Hiding Change 8.5.1 D5007Appearance of Dry FilmColor difference 9.1 . . .Color appearance 9.
20、1.1Color differences by visual comparison 9.1.2 D1729Color differences using instrumental measurements 9.1.3 D2244Directional reflectance 9.2 E1347Gloss 9.3Gloss, 60 9.3.1 D523Sheen (85 gloss) 9.3.2 D523Hiding power 9.4 D344, D2805, D5150Burnish Resistance 9.5 D6736Enamel Holdout 9.6 D7786Properties
21、 of Dry FilmInterior and Exterior Coatings 10.1Abrasion resistance 10.1.1 D968, D4060, D6037 6192Adhesion 10.1.2 D2197, D3359, D5179Wet adhesion 10.1.3 D6900 6301Flexibility 10.1.4 D522, D2370 6221AResistance to household chemicals 10.1.5 D1308Efflorescence from the film 10.1.6Efflorescence from the
22、 substrate 10.1.7 D7072Surfactant Stain Resistance 10.1.8 D7190Interior Finishes 10.2Block resistance 10.2.1 D4946Print resistance 10.2.2 D2064Film porosity 10.2.3 D3258, D6583Washability and cleansability 10.2.4Washability 10.2.4.1 D2486, D4213Cleansability 10.2.4.2 D3450, D4828 6141BInk Stainblock
23、ing 10.2.5 D7514Exterior Coatings 10.3Adhesion to chalky surfaces 10.3.1 6301Dirt pick-up 10.3.2 D3719Fume resistance 10.3.3Fume resistance test 10.3.3.1Blister resistance 10.3.4 D4585Exposure resistance 10.3.5 D1006, D1014Chalking 10.3.5.2 D4214Checking 10.3.5.3 D660Cracking 10.3.5.4 D661Erosion 10
24、.3.5.5 D662Flaking 10.3.5.6 D772Fade resistance 10.3.5.8 D2244D5324 162D660 Test Method for Evaluating Degree of Checking of Exterior PaintsD661 Test Method for Evaluating Degree of Cracking of Exterior PaintsD662 Test Method for Evaluating Degree of Erosion of Exterior PaintsD772 Test Method for Ev
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMD53242016STANDARDGUIDEFORTESTINGWATERBORNEARCHITECTURALCOATINGS 水性 建筑 涂料 试验 标准 指南 PDF

链接地址:http://www.mydoc123.com/p-519480.html