ASTM C1589 C1589M-2014 Standard Practice for Outdoor Weathering of Construction Seals and Sealants《建筑用密封材料和密封剂的室外浸蚀的标准实施规程》.pdf
《ASTM C1589 C1589M-2014 Standard Practice for Outdoor Weathering of Construction Seals and Sealants《建筑用密封材料和密封剂的室外浸蚀的标准实施规程》.pdf》由会员分享,可在线阅读,更多相关《ASTM C1589 C1589M-2014 Standard Practice for Outdoor Weathering of Construction Seals and Sealants《建筑用密封材料和密封剂的室外浸蚀的标准实施规程》.pdf(16页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: C1589/C1589M 13C1589/C1589M 14Standard Practice forOutdoor Weathering of Construction Seals and Sealants1This standard is issued under the fixed designation C1589/C1589M; the number immediately following the designation indicates theyear of original adoption or, in the case of revision,
2、 the year of last revision. A number in parentheses indicates the year of lastreapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This practice describes outdoor exposure procedures to be used as part of a test designed to determine th
3、e weatherabilityof building construction, seals and sealants.NOTE 1See Practice G24 for Exposures to Daylight Filtered Through Glass.1.2 This practice includes three procedures for outdoor weathering. Procedure A exposes specimens to outdoor weatheringwithout movement. Procedure B and Procedure C ar
4、e, respectively, continuous natural and periodic manual techniques forsubjecting specimens to the combination of cyclic movement and exposure to outdoor weathering.1.3 This practice is limited to the method by which the construction seals or sealants are exposed to outdoor weathering as partof a tes
5、t program. It refers to the types of evaluations to be performed following the outdoor exposure but does not describe thetest methods.1.4 Means of evaluation of the effects of weathering will depend on the intended use of the test material.1.5 The values stated in either SI units or inch-pound units
6、 are to be regarded separately as standard. The values stated in eachsystem may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from thetwo systems may result in non-conformance with the standard.1.6 This standard does not purport to addres
7、s all of the safety concerns, if any, associated with its use. It is the responsibilityof the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatorylimitations prior to use.2. Referenced Documents2.1 ASTM Standards:2C717 Terminology o
8、f Building Seals and SealantsC718 Test Method for Ultraviolet (UV)-Cold Box Exposure of One-Part, Elastomeric, Solvent-Release Type Sealants(Withdrawn 2002)3C719 Test Method for Adhesion and Cohesion of Elastomeric Joint Sealants Under Cyclic Movement (Hockman Cycle)C1135 Test Method for Determining
9、 Tensile Adhesion Properties of Structural SealantsC1257 Test Method for Accelerated Weathering of Solvent-Release-Type SealantsC1442 Practice for Conducting Tests on Sealants Using Artificial Weathering ApparatusC1735 Test Method for Measuring the Time Dependent Modulus of Sealants Using Stress Rel
10、axationE631 Terminology of Building ConstructionsE732 Specification for Disposable Pasteur-Type PipetE734 Specification for Disposable Glass Blood Sample Capillary Tube (Microhematocrit)E772 Terminology of Solar Energy ConversionG7 Practice for Atmospheric Environmental Exposure Testing of Nonmetall
11、ic MaterialsG24 Practice for Conducting Exposures to Daylight Filtered Through GlassG84 Practice for Measurement of Time-of-Wetness on Surfaces Exposed to Wetting Conditions as in Atmospheric CorrosionTestingG113 Terminology Relating to Natural and Artificial Weathering Tests of Nonmetallic Material
12、sG147 Practice for Conditioning and Handling of Nonmetallic Materials for Natural and Artificial Weathering Tests1 This practice is under the jurisdiction of ASTM Committee C24 on Building Seals and Sealants and is the direct responsibility of Subcommittee C24.40 on Weathering.Current edition approv
13、ed May 15, 2013April 1, 2014. Published June 2013May 2014. Originally approved in 2004. Last previous edition approved in 20052013 asC1589-05.-13. DOI: 10.1520/C1589-13.10.1520/C1589-14.2 For referencedASTM standards, visit theASTM website, www.astm.org, or contactASTM Customer Service at serviceast
14、m.org. For Annual Book of ASTM Standardsvolume information, refer to the standards Document Summary page on the ASTM website.This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Becaus
15、eit may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current versionof the standard as published by ASTM is to be considered the official document.Copyright ASTM International, 100 Bar
16、r Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States1G169 Guide for Application of Basic Statistical Methods to Weathering TestsG178 Practice for Determining theActivation Spectrum of a Material (Wavelength Sensitivity to an Exposure Source) Using theSharp Cut-On Filter or Sp
17、ectrographic Technique3. Terminology3.1 DefinitionsDefinitions are found in Terminologies C717, G113, E631, and E772.4. Significance and Use4.1 Tests conducted in accordance with this practice are used to evaluate the weatherability of construction seals and sealantmaterials when they are exposed to
18、 outdoor weather conditions. The weatherability of seals and sealants in actual outdoor use canbe very different depending on the location,location because of differences in solar radiation, moisture, temperature, pollutants, andother factors. Sealant color may also affect weatherability.4.2 This pr
19、actice allows for three options: Option 1 Procedure A in which the effect of movement during weathering is notconsidered; Option 2 Procedure B in which specimens are weathered in conjunction with movement based on thermal changes.The applied strain is proportional to a combination of the temperature
20、 at the time the equipment is set up and subsequent thermalchanges. This option closely mimics the actual movements that occur in many sealant installations, but is less repeatable than themovement in Procedure C; Option 3 Procedure C in which the strain during weathering is manually applied. This p
21、rocedureallows for excellent control and repeatability, but is less representative of movement in actual use conditions than the movementin Procedure B. Options 2 and 3 have been added to this practice based on peer reviewed scientific literature demonstrating thatapplied strain separately and in co
22、mbination with other weathering stresses causes changes in the weatherability of sealants.4.3 The type, frequency and amount of movement of sealants varies with location and may affect weatherability. It cannot beassumed, therefore, that results from one exposure in a single location will be useful
23、for determining weatherability in a differentlocation. Exposures in several locations with different climates (for example, solar radiation, moisture, temperature, pollutants,biological and other factors) that represent a broad range of anticipated service conditions are recommended.4.4 It is strong
24、ly recommended that control materials of similar composition and construction to the test specimens and withknown weatherability be exposed along with the test specimens for the purpose of comparing the performance of test materialsto the controls. It(See 6.2is preferable to use two control material
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
下载文档到电脑,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTMC1589C1589M2014STANDARDPRACTICEFOROUTDOORWEATHERINGOFCONSTRUCTIONSEALSANDSEALANTS 建筑 密封材料 密封剂 室外
![提示](http://www.mydoc123.com/images/bang_tan.gif)
链接地址:http://www.mydoc123.com/p-465226.html