IEEE 1900 4 1-2013 en Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Networks《异构无线网络.pdf

《IEEE 1900 4 1-2013 en Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Networks《异构无线网络.pdf》由会员分享，可在线阅读，更多相关《IEEE 1900 4 1-2013 en Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Networks《异构无线网络.pdf（131页珍藏版）》请在麦多课文档分享上搜索。

1、 IEEE Standard for Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Networks Sponsored by the IEEE DySPAN Standards Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Communications Society IEEE Std 1900.4.1-2013 IE

2、EE Std 1900.4.1TM-2013 IEEE Standard for Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Networks Sponsor IEEE DySPAN Standards Committee of the IEEE Communications Society Approved 3 May 2013 IEEE-SA Standards Board Abstract

3、: Interfaces and service access points defined in IEEE Std 1900.4TMare described in detail, enabling distributed decision making in heterogeneous wireless networks and obtaining context information for this decision making. Keywords: distributed decision making, dynamic spectrum access, heterogeneou

4、s wireless networks, IEEE 1900.4TM, interface, protocol, radio resource usage optimization The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2013 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Publis

5、hed 24 June 2013. Printed in the United States of America. IEEE and 802 are registered trademarks in the U.S. Patent +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Copyright 2013

6、IEEE. All rights reserved. iv Notice to users Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of

7、the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights This document

8、is copyrighted by the IEEE. It is made available for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making this document ava

9、ilable for use and adoption by public authorities and private users, the IEEE does not waive any rights in copyright to this document. Updating of IEEE documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or ma

10、y be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. In order to determine whether a given document

11、is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/standards.ieee.org/index.html or contact the IEEE at the address listed previously. For more information about the IEEE Standards Association or the IE

12、EE standards development process, visit IEEE-SA Website at http:/standards.ieee.org/index.html. Errata Errata, if any, for this and all other standards can be accessed at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodi

13、cally. Copyright 2013 IEEE. All rights reserved. v Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validi

14、ty of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may ind

15、icate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Clai

16、ms may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or cond

17、itions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is e

18、ntirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2013 IEEE. All rights reserved. viParticipants At the time this IEEE standard was completed, the IEEE 1900.4 Working Group had the following membership: Masayuki Ariyoshi, Chair Hiros

19、hi Harada, Vice Chair ISB Corporation National Institute of Information and Communications Technology (NICT) NEC CorporationThe Working Group gratefully acknowledges the contributions of the following entities and participants. Without their assistance and dedication, this standard would not have be

20、en completed. The following entities submitted technical contributions or commented on the draft standard at various stages of the project development. Alcatel-Lucent France Tlcom Hitachi, Ltd. ISB Corporation KDDI R&D Laboratories, Inc. NEC Corporation NICT The following individuals submitted techn

21、ical contributions or commented on the draft standard at various stages of the project development. Saloua Ammari Masayuki Ariyoshi Sana Ben Jemaa Stanislav Filin Jens Gebert Seishi Hanaoka Hiroshi Harada Paul Houz Kentaro Ishizu Vincent Mrat Go Miyamoto Taeko Mori Shinji Murai Homare Murakami Hitom

22、i Nakamura Klaus Nolte Jean-Marc Picard Toshinori Suzuki The following members of the entity balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Aruba Networks, Inc. Fraunhofer-Gesellschaft ISB Corporation Lantiq Marvell Semiconductor, Inc.

23、NEC Corporation NICT Nippon Telegraph and Telephone Corporation (NTT) Nokia Sony Corporation STMicroelectronicsCopyright 2013 IEEE. All rights reserved. vii When the IEEE-SA Standards Board approved this standard on 3 May 2013, it had the following membership: John Kulick, Chair David J. Law, Vice C

24、hair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Masayuki Ariyoshi Peter Balma Farooq Bari Ted Burse Wael William Diab Stephen Dukes Jean-Philippe Faure Alexander Gelman Mark Halpin Gary Hoffman Paul Houz Jim Hughes Michael Janezic Joseph L. Koepfinger* Oleg Logvinov Ron Peters

25、en Gary Robinson Jon Walter Rosdahl Adrian Stephens Peter Sutherland Yatin Trivedi Phil Winston Yu Yuan *Member Emeritus Also included are the following nonvoting IEEE-SA Standards Board liaisons: Richard DeBlasio, DOE Representative Michael Janezic, NIST Representative Patrick Gibbons IEEE Standard

26、s Program Manager, Document Development Lisa Perry IEEE Standards Program Manager, Technical Program Development Matthew Ceglia IEEE Standards Professional Services Manager viii Copyright 2013 IEEE. All rights reserved. Introduction This introduction is not part of IEEE Std 1900.4.1-2013, IEEE Stand

27、ard for Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Networks. Multimode reconfigurable devices are increasingly being adopted within the wireless industry. The choice among various supported air interfaces on a single wir

28、eless device is already a reality today, with devices offering, for example, second-, third-, and fourth-generation cellular radio access technologies and IEEE 802 wireless standards. Last but not least, devices and networks with dynamic spectrum access capabilities that allow the use of spectrum re

29、source simultaneously among different systems are emerging and will be part of the radio eco space. Furthermore, there has been an advocated need for these devices and networks being capable of operation in white space frequency bands to improve spectrum usage. This standard and its baseline, IEEE S

30、td 1900.4TM-2009, define an overall system architecture and information exchange between the network and devices that will allow the devices to optimally choose among the available radio resources in heterogeneous wireless access networks. Whereas IEEE Std 1900.4-2009 is limited to the architectural

31、 and functional definitions, this standard provides detailed descriptions of interfaces and service access points that will enable distributed decision making in heterogeneous wireless networks and obtaining context information for this decision making. This standard also facilitates innovative, cos

32、t-effective, and multi-vendor production of network-side and terminal-side components of an IEEE 1900.4 system and accelerates commercialization of this system to improve capacity and quality of service in heterogeneous wireless networks. The IEEE 1900 Standards Committee was established in the firs

33、t quarter of 2005 jointly by the IEEE Communications Society and the IEEE Electromagnetic Compatibility Society. The objective of this effort is to develop supporting standards dealing with new technologies and techniques being developed for next-generation radio and advanced spectrum management. On

34、 March 22, 2007, the IEEE Standards Association Standards Board (SASB) approved the reorganization of the IEEE 1900 effort as IEEE Standards Coordinating Committee 41 (IEEE SCC41) on Dynamic Spectrum Access Networks (DySPAN). The IEEE Communications Society and the IEEE Electromagnetic Compatibility

35、 Society were sponsoring societies for this effort, as they had been for the IEEE 1900 effort. On December 8, 2010, the IEEE SASB authorized that all activities of IEEE SCC41 be transferred to the IEEE Communication Society and that IEEE SCC41 be disbanded. On June 8, 2012, the IEEE SASB approved th

36、e IEEE DySPAN Standards Committee (IEEE DySPAN-SC) as a sponsor under the IEEE Communications Society and that all the IEEE 1900.x projects be transferred to IEEE DySPAN-SC. The IEEE 1900.4 working group was launched in February 2007, originating from the IEEE 1900.B study group, and entitled “Archi

37、tectural Building Blocks Enabling Network-Device Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Access Networks.” ix Copyright 2013 IEEE. All rights reserved. Contents 1. Overview 1 1.1 Scope . 1 1.2 Purpose 1 2. Normative references 2 3. Definitions 2 3.1 D

38、efinitions, acronyms, and abbreviations 2 3.2 Acronyms and abbreviations . 3 4. General system description . 4 4.1 IEEE 1900.4 system 4 4.2 Reference system architecture . 4 5. Format and data of the message exchanged between entities . 6 5.1 Message format 6 5.2 Message data 6 6. Interface between

39、the NRM and the TRM.11 6.1 NRM state transition .11 6.2 TRM state transition .12 6.3 Sequence .13 6.4 Message interface .19 7. Service access point and primitives .30 7.1 General description .30 7.2 Usage scenarios 31 7.3 Transport SAP 33 Annex A (normative) Information tree and ASN.1type definition

40、 .41 A.1 Information tree .41 A.2 ID definition.63 A.3 ASN.1 Type Definition 73 Annex B (informative) Interface between the OSM and the NRM 98 B.1 OSM state transition 98 B.2 NRM state transition 98 B.3 Sequence 99 B.4 Message interface .102 Annex C (informative) Service access points .106 C.1 TMC_r

41、CFG_MEDIA_SAP .106 C.2 TRC_rCFG_MEDIA_SAP 114 Annex D (informative) Bibliography .119 1 Copyright 2013 IEEE. All rights reserved. IEEE Standard for Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Networks IMPORTANT NOTICE: IE

42、EE Standards documents are not intended to ensure safety, health, or environmental protection, or ensure against interference with or from other devices or networks. Implementers of IEEE Standards documents are responsible for determining and complying with all appropriate safety, security, environm

43、ental, health, and interference protection practices and all applicable laws and regulations. This IEEE document is made available for use subject to important notices and legal disclaimers. These notices and disclaimers appear in all publications containing this document and may be found under the

44、heading “Important Notice” or “Important Notices and Disclaimers Concerning IEEE Documents.” They can also be obtained on request from IEEE or viewed at http:/standards.ieee.org/IPR/disclaimers.html. 1. Overview 1.1 Scope This standard provides a detailed description of interfaces and service access

45、 points defined in the baseline, IEEE Std 1900.4TM, enabling distributed decision making in heterogeneous wireless networks and obtaining context information for this decision making. 1.2 Purpose This standard facilitates innovative, cost-effective, and multi-vendor production of network side and te

46、rminal side components of an IEEE 1900.4TMsystem and accelerates commercialization of this system to improve capacity and quality of service in heterogeneous wireless networks. IEEE Std1900.4.1-2013 IEEE Standard for Interfaces and Protocols Enabling Distributed Decision Making for Optimized Radio R

47、esource Usage in Heterogeneous Wireless Networks 2 Copyright 2013 IEEE. All rights reserved. 2. Normative references The following referenced documents are indispensable for the application of this document (i.e., they must be understood and used, so each referenced document is cited in text and its

48、 relationship to this document is explained). For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments or corrigenda) applies. IEEE Std 1900.4, IEEE Standard for Architectural Building Blocks Enabling Networ

49、k-Device Distributed Decision Making for Optimized Radio Resource Usage in Heterogeneous Wireless Access Networks.1,2ISO/IEC 8824-1, Information Technology Abstract Sytax Notation One (ASN.1): Specification of Basic Notation.33. Definitions 3.1 Definitions, acronyms, and abbreviations For the purposes of this document, the following terms and definitions apply. The IEEE Standards Dictionary Online should be consulted for terms not defined in this clause. 4base station (BS): This term is used to refer to any radio node on the network side from radio interface,