IEC 60891-2009 Photovoltaic devices - Procedures for temperature and irradiance corrections to measured I-V characteristics《光伏器件.测定I-V特性的温度和辐照度校正方法用程序》.pdf

《IEC 60891-2009 Photovoltaic devices - Procedures for temperature and irradiance corrections to measured I-V characteristics《光伏器件.测定I-V特性的温度和辐照度校正方法用程序》.pdf》由会员分享，可在线阅读，更多相关《IEC 60891-2009 Photovoltaic devices - Procedures for temperature and irradiance corrections to measured I-V characteristics《光伏器件.测定I-V特性的温度和辐照度校正方法用程序》.pdf（44页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 60891 Edition 2.0 2009-12 INTERNATIONAL STANDARD NORME INTERNATIONALE Photovoltaic devices Procedures for temperature and irradiance corrections to measured I-V characteristics Dispositifs photovoltaques Procdures pour les corrections en fonction de la temprature et de lclairement appliquer aux

2、 caractristiques I-V mesures IEC 60891:2009 THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2009 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including phot

3、ocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address below or your lo

4、cal IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfi

5、lms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la CEI de votre pay

6、s de rsidence. IEC Central Office 3, rue de Varemb CH-1211 Geneva 20 Switzerland Email: inmailiec.ch Web: www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic

7、 and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Catalogue of IEC publications: www.iec.ch/searchpub The IEC

8、 on-line Catalogue enables you to search by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, withdrawn and replaced publications. IEC Just Published: www.iec.ch/online_news/justpub Stay up to date on all new IEC publications. Just Published

9、 details twice a month all new publications released. Available on-line and also by email. Electropedia: www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 20 000 terms and definitions in English and French, with equivalent terms in addi

10、tional languages. Also known as the International Electrotechnical Vocabulary online. Customer Service Centre: www.iec.ch/webstore/custserv If you wish to give us your feedback on this publication or need further assistance, please visit the Customer Service Centre FAQ or contact us: Email: csciec.c

11、h Tel.: +41 22 919 02 11 Fax: +41 22 919 03 00 A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des pu

12、blications CEI Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Catalogue des publications de la CEI: www.iec.ch/searchpub/cur_fut-f.htm Le Catalogue en-ligne de la CE

13、I vous permet deffectuer des recherches en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Il donne aussi des informations sur les projets et les publications retires ou remplaces. Just Published CEI: www.iec.ch/online_news/justpub Restez inform sur les nouvelles publications d

14、e la CEI. Just Published dtaille deux fois par mois les nouvelles publications parues. Disponible en-ligne et aussi par email. Electropedia: www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 20 000 termes et dfinitions en anglais

15、 et en franais, ainsi que les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International en ligne. Service Clients: www.iec.ch/webstore/custserv/custserv_entry-f.htm Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez d

16、es questions, visitez le FAQ du Service clients ou contactez-nous: Email: csciec.ch Tl.: +41 22 919 02 11 Fax: +41 22 919 03 00 IEC 60891 Edition 2.0 2009-12 INTERNATIONAL STANDARD NORME INTERNATIONALE Photovoltaic devices Procedures for temperature and irradiance corrections to measured I-V charact

17、eristics Dispositifs photovoltaques Procdures pour les corrections en fonction de la temprature et de lclairement appliquer aux caractristiques I-V mesures INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE R ICS 27.160 PRICE CODE CODE PRIX ISBN 2-8318-1073-1 Regist

18、ered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Internationale 2 60891 IEC:2009 CONTENTS FOREWORD.3 1 Scope.5 2 Normative references .5 3 Correction procedures 5 3.1 General .5 3.2 Correction procedure 16 3.3 Correction procedure 27 3.4

19、Correction procedure 38 4 Determination of temperature coefficients.13 4.1 General .13 4.2 Apparatus13 4.3 Procedure in natural sunlight.14 4.4 Procedure with a solar simulator .15 4.5 Calculation of temperature coefficients15 5 Determination of internal series resistance R Sand R S .15 5.1 General

20、.15 5.2 Correction procedure 116 5.3 Correction procedure 217 6 Determination of the curve correction factor and 18 6.1 General .18 6.2 Procedure .18 7 Reporting .19 Bibliography21 Figure 1 Example of the correction of the I-V characteristics by Equations (6) and (7) .10 Figure 2 Schematic diagram o

21、f the relation of G 3and T 3which can be chosen in the simultaneous correction for irradiance and temperature, for a fixed set of T 1 , G 1 , T 2 , and G 2by Equations (8) and (9)11 Figure 3 Schematic diagram of the processes for correcting the I-V characteristics to various ranges of irradiance and

22、 temperature based on three measured characteristics 12 Figure 4 Schematic diagram of the processes for correcting the I-V characteristics to various ranges of irradiance and temperature based on four measured characteristics .13 Figure 5 Positions for measuring the temperature of the test module be

23、hind the cells14 Figure 6 Determination of internal series resistance.16 Figure 7 Determination of V OCirradiance correction factor and internal series resistance.18 Figure 8 Determination of curve correction factor.19 60891 IEC:2009 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ PHOTOVOLTAIC DEVICES

24、 PROCEDURES FOR TEMPERATURE AND IRRADIANCE CORRECTIONS TO MEASURED I-V CHARACTERISTICS FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is t

25、o promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and G

26、uides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the I

27、EC also participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as

28、 possible, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sens

29、e. While all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees unde

30、rtake to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any att

31、estation of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition

32、 of this publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct

33、 or indirect, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensabl

34、e for the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 60891 has bee

35、n prepared by IEC technical committee 82: Solar photovoltaic energy systems. This second edition cancels and replaces the first edition issued in 1987 and its Amendment 1 (1992) and constitutes a technical revision. The main technical changes with regard the previous edition are as follows: extends

36、edition 1 translation procedure to irradiance change during I-V measurement; adds 2 new translation procedures; revises procedure for determination of temperature coefficients to include PV modules; defines new procedure for determination of internal series resistance; defines new procedure for dete

37、rmination of curve correction factor. 4 60891 IEC:2009 The text of this standard is based on the following documents: FDIS Report on voting 82/581/FDIS 82/588/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This

38、publication has been drafted in accordance with the ISO/IEC Directives, Part 2. The committee has decided that the contents of this publication will remain unchanged until the maintenance result date indicated on the IEC web site under “http:/webstore.iec.ch“ in the data related to the specific publ

39、ication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. 60891 IEC:2009 5 PHOTOVOLTAIC DEVICES PROCEDURES FOR TEMPERATURE AND IRRADIANCE CORRECTIONS TO MEASURED I-V CHARACTERISTICS 1 Scope This standard defines procedures to be followed for te

40、mperature and irradiance corrections to the measured I-V (current-voltage) characteristics of photovoltaic devices. It also defines the procedures used to determine factors relevant for these corrections. Requirements for I-V measurement of photovoltaic devices are laid down in IEC 60904-1. NOTE 1 T

41、he photovoltaic devices include a single solar cell with or without a protective cover, a sub-assembly of solar cells, or a module. A different set of relevant parameters for I-V correction applies for each type of device. Although the determination of temperature coefficients for a module (or sub-a

42、ssembly of cells) may be calculated from single cell measurements, it should be noted that the internal series resistance and curve correction factor should be separately measured for a module or subassembly of cells. NOTE 2 The term “test specimen” is used to denote any of these devices. NOTE 3 Car

43、e should be taken regarding the use of I-V correction parameters. The parameters are valid for the PV device for which they have been measured. Variations may occur within a production lot or the type class. 2 Normative references The following referenced documents are indispensable for the applicat

44、ion of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60904-1, Photovoltaic devices Part 1: Measurements of photovoltaic current-voltage characteristics IEC 60904-2, Ph

45、otovoltaic devices Part 2: Requirements for reference solar devices IEC 60904-7, Photovoltaic devices Part 7: Computation of the spectral mismatch correction for measurements of photovoltaic devices IEC 60904-9, Photovoltaic devices Part 9: Solar simulator performance requirements IEC 60904-10, Phot

46、ovoltaic devices Part 10: Methods of linearity measurement 3 Correction procedures 3.1 General Three procedures for correcting measured current-voltage characteristics to other conditions of temperature and irradiance (such as STC) can be applied. The first is identical to the procedure given in Edi

47、tion 1 of this standard, but the equation has been rewritten for easier understanding. The second procedure is an alternative algebraic correction method which yields better results for large irradiance corrections (20 %). Both procedures require that correction parameters of the PV device are known

48、. If not known they need to be determined prior to performing the correction. The third procedure is an interpolation method which does not require correction parameters as input: It can be applied when a minimum of three current-voltage curves have been measured for the test device. These three cur

49、rent-voltage curves span the temperature and irradiance range for which the correction method is applicable. 6 60891 IEC:2009 All methods are applicable to linear devices as defined in IEC 60904-10. NOTE 1 An estimate on the translation accuracy is required (see Clause 7). NOTE 2 All PV devices should be linear within a limited range of irradiances and device temperature. Detail