IEC 60721-2-1-2013 Classification of environmental conditions - Part 2-1 Environmental conditions appearing in nature - Temperature and humidity《环境条件的分类 第2-1部分 大自然呈现的环境条件 温度与湿度》.pdf

《IEC 60721-2-1-2013 Classification of environmental conditions - Part 2-1 Environmental conditions appearing in nature - Temperature and humidity《环境条件的分类 第2-1部分 大自然呈现的环境条件 温度与湿度》.pdf》由会员分享，可在线阅读，更多相关《IEC 60721-2-1-2013 Classification of environmental conditions - Part 2-1 Environmental conditions appearing in nature - Temperature and humidity《环境条件的分类 第2-1部分 大自然呈现的环境条件 温度与湿度》.pdf（26页珍藏版）》请在麦多课文档分享上搜索。

1、 IEC 60721-2-1 Edition 2.0 2013-06 INTERNATIONAL STANDARD NORME INTERNATIONALE Classification of environmental conditions Part 2-1: Environmental conditions appearing in nature Temperature and humidity Classification des conditions denvironnement Partie 2-1: Conditions denvironnement prsentes dans l

2、a nature Temprature et humidit IEC60721-2-1:2013 colourinsideTHIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2013 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanica

3、l, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication, please contact the address

4、 below or your local IEC member National Committee for further information. Droits de reproduction rservs. Sauf indication contraire, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocop

5、ie et les microfilms, sans laccord crit de la CEI ou du Comit national de la CEI du pays du demandeur. Si vous avez des questions sur le copyright de la CEI ou si vous dsirez obtenir des droits supplmentaires sur cette publication, utilisez les coordonnes ci-aprs ou contactez le Comit national de la

6、 CEI de votre pays de rsidence. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes Intern

7、ational Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. Useful link

8、s: IEC publications search - www.iec.ch/searchpub The advanced search enables you to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives information on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpub

9、lished Stay up to date on all new IEC publications. Just Published details all new publications released. Available on-line and also once a month by email. Electropedia - www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing more than 30 000 terms an

10、d definitions in English and French, with equivalent terms in additional languages. Also known as the International Electrotechnical Vocabulary (IEV) on-line. Customer Service Centre - webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance, please con

11、tact the Customer Service Centre: csciec.ch. A propos de la CEI La Commission Electrotechnique Internationale (CEI) est la premire organisation mondiale qui labore et publie des Normes internationales pour tout ce qui a trait llectricit, llectronique et aux technologies apparentes. A propos des publ

12、ications CEI Le contenu technique des publications de la CEI est constamment revu. Veuillez vous assurer que vous possdez ldition la plus rcente, un corrigendum ou amendement peut avoir t publi. Liens utiles: Recherche de publications CEI - www.iec.ch/searchpub La recherche avance vous permet de tro

13、uver des publications CEI en utilisant diffrents critres (numro de rfrence, texte, comit dtudes,). Elle donne aussi des informations sur les projets et les publications remplaces ou retires. Just Published CEI - webstore.iec.ch/justpublished Restez inform sur les nouvelles publications de la CEI. Ju

14、st Published dtaille les nouvelles publications parues. Disponible en ligne et aussi une fois par mois par email. Electropedia - www.electropedia.org Le premier dictionnaire en ligne au monde de termes lectroniques et lectriques. Il contient plus de 30 000 termes et dfinitions en anglais et en frana

15、is, ainsi que les termes quivalents dans les langues additionnelles. Egalement appel Vocabulaire Electrotechnique International (VEI) en ligne. Service Clients - webstore.iec.ch/csc Si vous dsirez nous donner des commentaires sur cette publication ou si vous avez des questions contactez-nous: csciec

16、.ch. IEC 60721-2-1 Edition 2.0 2013-06 INTERNATIONAL STANDARD NORME INTERNATIONALE Classification of environmental conditions Part 2-1: Environmental conditions appearing in nature Temperature and humidity Classification des conditions denvironnement Partie 2-1: Conditions denvironnement prsentes da

17、ns la nature Temprature et humidit INTERNATIONAL ELECTROTECHNICAL COMMISSION COMMISSION ELECTROTECHNIQUE INTERNATIONALE L ICS 19.040 PRICE CODE CODE PRIX ISBN 978-2-83220-899-1 Registered trademark of the International Electrotechnical Commission Marque dpose de la Commission Electrotechnique Intern

18、ationale Warning! Make sure that you obtained this publication from an authorized distributor. Attention! Veuillez vous assurer que vous avez obtenu cette publication via un distributeur agr. colourinside 2 60721-2-1 IEC:2013 CONTENTS FOREWORD . 3 INTRODUCTION . 5 1 Scope . 6 2 Normative references

19、. 6 3 Terms and definitions, abbreviations, quantities and units 6 4 General information regarding data collection and analysis 6 5 General validation process . 7 6 Open air climates . 8 6.1 General . 8 6.2 Environmental parameters . 8 6.3 Identification of statistical open-air climates 8 6.4 Map of

20、 open-air climates . 9 Annex A (informative) Map of climate classification 10 Bibliography 11 Figure A.1 Climate classifications 10 Table 1 Climate classifications . 7 Table 2 Climate classification definitions 7 Table 3 Classification of climates by extreme daily mean values 8 Table 4 Classificatio

21、n of climates by annual extreme values 8 Table 5 Classification of climates by absolute extreme value . 9 60721-2-1 IEC:2013 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _ CLASSIFICATION OF ENVIRONMENTAL CONDITIONS Part 2-1: Environmental conditions appearing in nature Temperature and humidity FOREWO

22、RD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to promote international co-operation on all questions concerning standardization in the elect

23、rical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides (hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to tech

24、nical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising with the IEC also participate in this preparation. IEC collaborates closely with the International Organ

25、ization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international consensus of opinion on the relevant subjects since each technical

26、 committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. While all reasonable efforts are made to ensure that the technical content of IEC Publicati

27、ons is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake to apply IEC Publications transparently to the maximum extent possible in their national

28、 and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestation of conformity. Independent certification bodies provide conformity assessment service

29、s and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of this publication. 7) No liability shall attach to IEC or its directors, employees, servant

30、s or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or indirect, or for costs (including legal fees) and expenses arising out of the publication,

31、 use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for the correct application of this publication. 9) Attention is drawn to the possibility th

32、at some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 60721-2-1 has been prepared by IEC technical committee 104: Environmental conditions, classification and me

33、thods of test. This second edition cancels and replaces the first edition published in 1982 and its amendment 1 (1987), and constitutes a technical revision. The main changes with respect to the previous edition are in the definitions of climate types. 4 60721-2-1 IEC:2013 The text of this standard

34、is based on the following documents: FDIS Report on voting 104/610/FDIS 104/617/RVD Full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2.

35、 A list of all the parts in the IEC 60068 series, under the general title Classification of environmental conditions, can be found on the IEC website. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC web site under “h

36、ttp:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTANT The colour inside logo on the cover page of this publication indicates that it contains colours which are consider

37、ed to be useful for the correct understanding of its contents. Users should therefore print this document using a colour printer. 60721-2-1 IEC:2013 5 INTRODUCTION Electrotechnical products are used in almost all areas of the world under varying climatic conditions and have to meet the stresses impo

38、sed by these climatic conditions with the necessary reliability. A detailed knowledge of the climatic conditions to which the product will be subjected is necessary in the design stage to ensure that reliability is met. Data on open-air temperature and humidity have been collected and statistically

39、processed for many years throughout the world. Such data is represented in this part of IEC 60721. In addition to open-air temperature, temperature stresses on a product depend on a number of other environmental parameters, for example solar radiation, air velocity or heating from adjacent equipment

40、. The effects of humidity depend on temperature, temperature changes and impurities in the humid air. In many cases the extremes of temperature and humidity are of great importance even if they occur for a short time. In other cases, where large time constants for heat or water penetration are invol

41、ved, the mean values of temperature and humidity over a certain period may be more important. It has therefore been considered useful to present here both the mean value over many years of the annual extreme values of temperature and humidity, which will occur only for short periods (a few hours), a

42、nd the mean value over many years of the extreme daily mean values of temperature and humidity, which will occur for longer periods. In order to cover cases where rare events need to be taken into account, the absolute extreme temperatures and humidity levels, observed over a period of many years, h

43、ave also been presented. 6 60721-2-1 IEC:2013 CLASSIFICATION OF ENVIRONMENTAL CONDITIONS Part 2-1: Environmental conditions appearing in nature Temperature and humidity 1 Scope This part of IEC 60721 presents classifications of open-air climates in terms of temperature and humidity. It is intended t

44、o be used as part of the background material when selecting appropriate temperature and humidity severities for product testing and application. The climates cover all areas of the world, excluding the central Antarctic and high altitudes (above 5 000 m). This presentation may be used as background

45、material when issuing climatic environmental classes for product applications. This standard defines a limited number of open-air climate classifications, in terms of temperature and humidity, which represent the conditions most frequently met by products while being transported, stored, installed a

46、nd used. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including

47、any amendments) applies. IEC 60721-1:1990, Classification of environmental conditions Part 1: Environmental parameters and their severities IEC/TR 62130, Climatic field data including validation MIL210 Extreme and Percentile Environmental Reference Tables (ExPERT) database (Version 1.0 July 1997) PE

48、ARCE, E.A., and SMITH, C.G., The Hutchinson World Weather Guide by Helicon Publishing Ltd (ISBN 1-85986-342-6, 2000) KOTTEK, M., GRIESER, J., BECK, C., RUDOLF, B. and RUBEL, F., World Map of the Kppen-Geiger climate classification updated: 2006, Meteorol. Z., 15, 259-263 3 Terms and definitions, abb

49、reviations, quantities and units Terms and definitions are defined, in context, throughout the present standard. 4 General information regarding data collection and analysis Climatic data was collected and validated in IEC/TR 62130. The two principle data sources were the MIL210 ExPERT and The Hutchinson World Weather Guide. 60721-2-1 IEC:2013 7 The MIL210 ExPERT database contained daily temperature and humidity