SAE AMS 3623E-2011 Elastomeric Tubing Electrical Insulation Irradiated Polychloroprene Flexible Heat-Shrinkable 1 750 to 1 Shrink Ratio《收缩率为1 750 1的热收缩挠性辐照处理的电绝缘弹性管》.pdf

《SAE AMS 3623E-2011 Elastomeric Tubing Electrical Insulation Irradiated Polychloroprene Flexible Heat-Shrinkable 1 750 to 1 Shrink Ratio《收缩率为1 750 1的热收缩挠性辐照处理的电绝缘弹性管》.pdf》由会员分享，可在线阅读，更多相关《SAE AMS 3623E-2011 Elastomeric Tubing Electrical Insulation Irradiated Polychloroprene Flexible Heat-Shrinkable 1 750 to 1 Shrink Ratio《收缩率为1 750 1的热收缩挠性辐照处理的电绝缘弹性管》.pdf（11页珍藏版）》请在麦多课文档分享上搜索。

1、_ SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising there

2、from, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2011 SAE International All rights reserved. No part of this publication m

3、ay be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside U

4、SA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org SAE values your input. To provide feedback on this Technical Report, please visit http:/www.sae.org/technical/standards/AMS3623EAEROSPACEMATERIALSPECIFICATIONAMS3623 REV. E Issued 1968-11 Revised 1993-07Stabilized

5、 2011-08 Superseding AMS3623D Tubing, Irradiated Polychloroprene Elastomer, Electrical Insulation Flexible, Heat-Shrinkable, 1.750 to 1 Shrink Ratio RATIONALE This document has been determined to contain basic and stable technology which is not dynamic in nature. Design authorities may determine tha

6、t this document is no longer to be used for new design. This determination should be made by each design authority. STABILIZED NOTICE This document has been declared “Stabilized“ by SAE AE-8D, Wire and Cable Committee, and will no longer be subjected to periodic reviews for currency. Users are respo

7、nsible for verifying references and continued suitability of technical requirements. Newer technology may exist. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 2 of 11 Copyright SA

8、E International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 3 of 11 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license f

9、rom IHS-,-,-SAE AMS3623E Page 4 of 11 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 5 of 11 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo repr

10、oduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 6 of 11 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 7 of 11 Copyright SAE International Provided

11、by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 8 of 11 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E

12、Page 9 of 11 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 10 of 11 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE AMS3623E Page 11 of 11 STABILIZED BY SAE COMMITTEE AE-8D, WIRE AND CABLE Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-