NAVY MIL-STD-1323-5-1987 UNIT LOAD FOR UNDERWAY REPLENISHMENT CHARGE PROPELLING 5-INCH 54 IN PALLET ADAPTER MK 16 MOD 0《MK 16MOD 0货盘适配器5-英寸 54推进航行中充电的负载》.pdf

《NAVY MIL-STD-1323-5-1987 UNIT LOAD FOR UNDERWAY REPLENISHMENT CHARGE PROPELLING 5-INCH 54 IN PALLET ADAPTER MK 16 MOD 0《MK 16MOD 0货盘适配器5-英寸 54推进航行中充电的负载》.pdf》由会员分享，可在线阅读，更多相关《NAVY MIL-STD-1323-5-1987 UNIT LOAD FOR UNDERWAY REPLENISHMENT CHARGE PROPELLING 5-INCH 54 IN PALLET ADAPTER MK 16 MOD 0《MK 16MOD 0货盘适配器5-英寸 54推进航行中充电的负载》.pdf（3页珍藏版）》请在麦多课文档分享上搜索。

1、E f ., MIL-STD-I 323-5 (NAVY) MILITARY STANDARD FOR UNDERWAY REPLENISHMENT IM BALLET ADAPTER, MK 16 MOD O 8 JUIE 1987 UNK LOAD SUPFRSEDING M1-54/5C 24 APRIL 1973 CHARGE, PROPELLNG, 5-INCH/54 M 12 MOD O fX 12 UNIT LOAD DATA NUEBER OF CARTRIDGES PER TANK . NUIBER OF TANKS PER UNIT LOAD i 39 NUIBER OF

2、CARTRIOGES PER UNIT LOA0 39 WEIGHT OF ADAPTER . 54 LBS 1 EIGHT OF STEEL STRAPPIKG . 7 LES 72 LES EIGHT OF PALLET 110 LES 43 IN OIHENSION A. 43-718 IN 43.9 CU FT CUBE W.3 CU FT MK 14 39.1 LBS 1.696 LES 1.658 LES 1.790 LBS 1.752 LES EK 14 MOD 1 Yi. 5 LES ld( 21 iD O Y2.0 LES 1,809 LES 1.771 LBS REDUCE

3、D. tX 14 32.0 LBS 1.419 LBS 1.381 LBS A O0 NOT USE FOR SHIPPIKG PURPOSES DO KOT STACK YORE THAN 554 CARTRIGE TANK M 14 - 389112 M 14 MOD 1. 10ODl-2127876 f.8( 21 m#, i, 1366407 CAUTION FRONT AND RFAR FRAES MUST BE CORRECTLY POSITIONED TO ENSURE A PROPERLY PALLETIZED LOAD. WHEN IDENTIFICATION MARKING

4、 IS NOT LEGIBLE. FRONT AND REAR FRAKS MY BE IDENTIFIED BY CWARING THEIR SS SECTIONS. ON PAGE 3. - 4 UNIT LOADS HIGH IN STORAGE DOT CLASS E CG CLASS 11-8 DOOICINACC D297 D309 D304 D310 0305 D324 D306 D326 . MSC NO. - H/A KOTES: 1. UNLESS OTHERWISE SPECIFIER. DIHENSIOHS ARE IN INCHES. DISTRIBOTION 2.

5、FOR CROSS REFERENCE TO ASSOCIATED TRUCKLMDING. CONTAINERLOAD1r;G . APPROVED FOR -suwmu PUBLIC RELEASE AND CARLOAOING MILITARY STANDARDS. REFER TO INDEX TO STANDARDS MIL-HDBK-236 (NAW). DISTRIBUTION IS UNLIMITED fEFiiz SHIPPING, HANDLING. OF THIS UNIT LOAD SHALL CONSIST * QF PHIS DOCUMENT AND THE LAT

6、EST STORAGE AND TRANSFER-AT-SEA. IT MAY ALSO BE USED FOR DOMESTIC SHIPMENT IN COMPLIANCE WITH DOT REGUUTIONS. Licensed by Information Handling ServicesProvided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-STD-1323 -5 3 9999911 0073390 3 MIL-STD-1323-5

7、(NAVY) PALLETIZ ING PROCEDURE (A) THREAD THE LONGITUDINAL STRAPPING, ITEM 5. BETMEN DECK WIRES OF PALLET, ITEM i. AS SHOWN IN DETAIL A. USING HK 12 MOO 1 PALLET. THREAD THE LATERAL STRAP. ITEM 7. UNDER DECK WIRES AND THROUGH THE CENTER VERTICAL SUPPORT OF PALLET. BETWEEN DECK WIRES AND DECK SUPPORT

8、AS SHOLJN IN DETAIL D. POSITION THE FRONT FRAK. ITEM 2. AND REAR FRAME, ITEM 3. ALONG THE LEIYGTMSE DIKNSION OF THE PALLET. FIRST TANK WITH THE COVER END IN THE RIGHT END OF THE FRONT FRAN AND ALTERNATE END POSITIONS OF THE NEXT FIVE TANKS IN THE FIRST ROU. AS SHOUN. POSITION THE SECOND ROW OF TANKS

9、, WITH THE COVER END Of THE FIRST TANK IN THE RIGHT END CORNER OF THE FRONT FRAHE. ALTERNATING END POSITIONS OF THE SUCCEEDING SIX TANKS. (E) POSITION THE LOUER GIRTHUISE STRAPPING, ITEM 6. AND APPLY LIGHT TENSION. (FI, POSITION THE NEXT Tu0 ROWS OF TANKS, WITH COVER ENDS OF THE FIRST TANK IN EACH R

10、OW AT THE RIGHT FND OF THE FRONT FRAK. ALTERNATING END POSITIONS OR SUCCEEDING TANKS. AS SHOUN. COERLFTE TENSIONING OF THE LOMR GIRTHWISE STRAP AND DOUBLE NOTCH SEAL. ITEM 8. (6) USING HK 12 MOD D PALLET, THREAD THE LATERAL STRAP, ITEM 7. (CI SEE DETAILS B AND C FOR PROPER IDENTIFICATION, OF FRONT A

11、ND REAR FRAKS. POSITION THE (DI (GI (HI POSITION THF UPPER GIRTHWISE STRAPPING AND APPLY LIGHT TENSION. (I) (JI (K) POSITION THE TOP FRAIE. ITEM 9. (L) . THREAD THE LONGITUDINAL STRAPPING THROUGH THE LOOPS IN THE FRONT AND REAR FRAMES AND OVER THE REPEAT PROCEOURE (F) FOR THE NEXT Tu0 ROUS. AS SHMJN

12、. COMPLETE TENSIONING OF THE UPPER GIRTMJISE STRAP AND WURLE NOTCH SEAL. TOP FRAHE. TENSION AND DOUBLE NOTCH SEAL. POSITION THE LATERAL STRAP AROUND THE UNIT LOAD. TENSION AND DOUBLE NOTCH SEAL. MRKING: (MI IN ADDITION TO ANY SPECIAL dRKING REQUIRED RY CONTRACT OR ORDER. THE UNIT LOAD SHALL BE FIARK

13、ED IN ACCORDANCE WITH MIL-STD-1323. D O PALLET READ STRAPPING BETWEEN THE IST AND 2ND WIRE. IN THE DETAIL A SECOND SPACE. DEPALLETIZING PROCEDURES (A) CUT AND REMOVE THE LATERAL AND LONGITUDINAL STRAPPING. (8) RENOVE THE TOP FRAME. . (Cl REMOVE THREE ROUS OF TANKS. (D) CUT AND RENOVE THE UPPER GIRTH

14、WISE STRAP. REMOVE Tu0 ROWS OF TANKS. CUT AND REMOVE THE LOWER GIRTHUISE STRAP. (E) (FI (GI REHOVE THE REMAINING TANKS THREAD STRAPPING BETWEEN THE 2ND AND 3RD WIRE. IN THE SECOND SPACE. PAGE 2 NOTE: 1. AND THE FRONT AND REAR FRAMES. IINLFSS DTHERUISE SPECIFIED, ALL NATERIAL SHALL RE IN ACCORDANCE W

15、ITH MIL-STD-1323. DO NOT USE TYPE 1 STRAPPING WITH POWER INCHINES. 2. 5 8 SEAL SEE NOTE 1 3 /If 1 7 STRAPPING, LATERAL SEE NOTES 1 E 2 314 X .O35 X 13 FT 6 2 6 STRAPPING. GIRTHWISE SEE NOTES 1 6 2 3/9 X .O35 X 15 FT 2 5 STRAPPING. LONGITUDINAL SFE NOTES 1 6 2 314 X .O35 X 15 FT 6 1 4 TOP FRAK. PALLE

16、T 10001 - 1372831 ADAPTER, M( 16 MD O STEEL - LD 296489 . 1 3 REAR FRAME. PALLET 10001 - 1372830 ADAPTER. HK 16 MOD O STEE.L - LD 296489 1 2 FRONT FRAME, PALLET lo001 - 1372829 ADAPTER, M( 19 HOD o SEEL - LD 96489 1 1 PALLET, ).R( 12 mW, O loo01 - 2086979 35 X 95-1/2 X 5-1/8 I M( 12 HOD 1 IlooO1 - 2

17、645217 I 35 X 45-1/2 X 4-3/9 REQ. ITEM I DESCRIPTION I MATL I DIMENSIONS LIST OF MATERIALS Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-STD-1323 -5 3 9797933 0073373 5 .- CROSS SECTION OF FRONT FRAME . c-44 DETAIL B PALETENG DETAILS Mll-STD-1323-5 (NAVY) CROSS SECTION OF REAR FRAME 1- 4 -114 _I DETAIL C DETAIL D PREPARING ACTIVITY: REVIEW ACTIVITY: NAVY-os NAVY-os (PROJECT NO. 8190-N757) ?AGE 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-